C M Y CM MY CY CMY K
0010562911
TEMPERATURE
1
2
3
4
10
9
8
7
65
FAN ONLY
MIN
COOL
MAX
COOL
SPEED
LOWHI
OFFON
Wait 3 Minutes Be ore
Restarting
POWER
RG-61A
C M Y CM MY CY CMY K
C M Y CM MY CY CMY K
1
C M Y CM MY CY CMY K
C M Y CM MY CY CMY K
1
1
2
4
4
5
5
6-7
8-13
8
8-13
14-18
15
15
16-18
19-20
20-21
C M Y CM MY CY CMY K
Test power plug before each use:
1. Press reset button.
2 . Press test button, unit should trip.
3. Press reset button again for use .
Do not use if above test fail.
In the event this device trips , the cause of the malfunction is to
be corrected before further use of the device .
Important:
C M Y CM MY CY CMY K
5
5
C M Y CM MY CY CMY K
6
2 way
airflow
control paneleasy access filters
MODEL: RG-61A
TEMPERATURE
1
2
3
4
10
9
8
7
65
FAN ONLY
MIN
COOL
MAX
COOL
SPEED
LOWHI
OFFON
Wait 3 Minutes Before
Resta ting
POWER
2. MODE Set Switch
5. How The Unit Drains
C M Y CM MY CY CMY K
7
Fig. # 1
TEMPERATURE
1
2
3
4
10
9
8
7
65
FAN ONLY
MIN
COOL
MAX
COOL
SPEED
LOWHI
OFFON
POWER
C M Y CM MY CY CMY K
8
Also when you shut off the air conditioner wait for 3 minutes
before turning it on again.
POWER Turns air conditioner off.
SPEED "LOW" Low speed fan operation with cooling or not.
SPEED "HI" High speed fan operation with cooling or not.
This automatically controls the temperature of indoor air. Turn the knob
so that arrow points to the cooler marks for more moderate cooling.
Normal Fan
1. Turn the SPEED mode switch to the "HI" or the "LOW" setting.
2. Set the thermostat control to the temperature mark "FAN ONLY".
Normal cooling
1. Turn the SPEED mode switch to the "HI" or the "LOW" setting.
2. Set the thermostat control to the desire temperature (the mid-point
is a good starting position).
If the room temperature is not satisfactory after a reasonable time, adjust
the control to a warmer or cooler setting, as appropriate.
Maximum cooling
1. Turn the SPEED mode switch to the "HI" setting
2. Set the thermostat control to the MAX COOL temperature mark.
Quieter operation
1. Turn the SPEED mode switch to the "LOW" setting.
2. Set the thermostat control as needed.
CAUTION:
1
2
3
C M Y CM MY CY CMY K
9
C M Y CM MY CY CMY K
10
window seal gasket
short screws 13/32"
wood screws 31/32"
Model:RG-61A
top rail
C M Y CM MY CY CMY K
11
Insert the side curtains into the
top and bottom rails of the air
conditioner. Fasten the curtains
to the unit with 8 short screws
13/32".
Install top rail with 3 short
screws13/32".
ASSEMBLE
CURTAINS/TOP RAIL
TEMPERATURE
1
2
3
4
10
9
8
7
65
FAN ONLY
MN
OOLMAOOL
PEE
LO
OFFON
Wi 3 Mi t B f
R t ti
POER
RG 61A
12
3
5
13
3
8
36
22
12
7
16
18
9
16
14
11
16
5
3
25
1
2
C M Y CM MY CY CMY K
12
1. This unit is designed for installation in standard double hung windows
with actual opening widths of 22
to 36 . The upper and lower sash
must open sufficiently to allow a clear vertical opening of 14
from the
bottom of the sash to the window sill.
2. If storm window presents interference, fasten a 2
wide wood strip(not
included) (OUTER SILL) to the inner window sill across the full width of
the sill. The wood strip should be thick enough to raise the height of
the window sill so that the unit can be installed without interference by
the storm window frame (STORM WINDOW FRAME) or wood strip
(OUTDOORS) to help condensation to drain properly to the outside.
3. Install a second wood strip (approximately 6
long by 1-1/2 wide
and same thickness as first strip) in the center of the outer sill flush
against the back off the inner sill. This will raise basepan angle .
4. If the distance between STORM WINDOW FRAME and WOOD STRIP
MOUNTED ON TOP OF INNER SILL is more than 1
, two of wood
strip are not necessary.
INNER
SILL
OUTER
SILL
I
N
D
O
O
R
S
O
U
T
D
O
O
R
S
WOOD STRIP
MOUNTED ON
TOP OF INNER SILL
WOOD STRIP
FOR BASEPAN
ANGLE
STORM
WINDOW FRAME
1
MAX.
3/4
CLEARANCE
I
N
D
O
O
R
S
O
U
T
D
O
O
R
S
INNER
SILL
OUTER
SILL
LOCATING UNIT IN
WINDOW
Open the window and mark center line on the
center of the inner sill.
CENTER LINE
INNER SILL
INDOOR SIDE
ATTACH BASEPAN
ANGLE
CENTER LINE
SHORT SCREW13/32"
INNER SILL
OUTER SILL
SHORT SIDE
BASEPAN ANGLE
8
8
OUTSIDE
INSIDE
Install the basepan angle behind the inner window sill, with
the short side of basepan angle as shown. Use the 2 short
screws13/32" provided.
The basepan angle helps to hold unit securely in place.
Be sure to place basepan angle edge flush against back
of inner sill.
2
C M Y CM MY CY CMY K
13
INSTALL THE AIR CONDITIONER
IN THE WINDOW
Carefully lift the air conditioner and slide it into the open
window. Make sure the bottom guide of the air conditioner
drops into the notches of the basepan angle.
While steadying the air conditioner ,carefully bring the
window sash down behind the upper guide of the air
conditioner.
WINDOW FRAME
UPPER GUIDE
BOTTOM GUIDE
BASEPAN ANGLE
ABOUT 1/4
INSTALL THE SEAL GASKET
AND SASH LOCK
Extend the side curtains to fill the
window opening using 4 wood screws
31/32" to secure them.
Cut the seal gasket to the window
width. Stuff the sash seal between the
glass and the window to prevent air
and insects from getting into the room.
Fasten the basepan angle, using a
short screw13/32".
BASEPAN ANGLE
WINDOW SEAL GASKET
SHORT SCREW13/32"
WOOD SCREW31/32"
C M Y CM MY CY CMY K
14
The air filter behind the front grille should be checked and
cleaned at least once every 2 weeks or more often if necessary.
To remove:
1. Open the inlet grille downward by pulling out the top of the inlet grille.
2. Remove the air filter from the front grille assembly by pulling the air filter
up slightly.
3. Clean the filter with warm, soapy water below 40
o
C(104oF).
4. Rinse and gently shake the water from the filter and let it dry before replacing
it.
Always use a soft cloth dampened with water or mild soap
and water solution to wipe the front of the cabinet.
To clean the front panels or the cabinet DO NOT use harsh
chemicals, abrasives, ammonia, chlorine, bleach, concentrated
detergents, solvents or metal scouring pads.
DO NOT use your air conditioner without the air filter in place.
Always unplug your air conditioner before cleaning.
TEMPERATURE
PEED
LOW
OFF
POWER
1
2
3
4
10
9
8
7
65
FAN ONLY
MN
COOL
MAX
COOL
C M Y CM MY CY CMY K
15
C M Y CM MY CY CMY K
16
(see page 8)
(see page 18)
Loading...