Haier NBFPA007 User Manual

7" Oscillating
Desk Fan

BEFORE OPERATING THIS PRODUCT, READ UNDERSTAND AND FOLLOW
THESE INSTRUCTIONS.

User Manual -

Model # NBFPA007

1

English

IMPORTANT SAFEGUARDS

Warning! When using electrical appliances, basic safety precautions should always

be followed to reduce the risk of fire, electric shock, and injury to
persons, including the following:

• READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.

• To reduce the risk of fire or electric shock, DO NOT use this fan with any solid
state speed control device.

• Keep unit away from heated surfaces and open flames.

• Keep the cord away from heavy traffic areas. DO NOT let the cord hang over
the edge of a table or counter. To avoid fire hazard, NEVER put the cord under
rugs, near heaters, radiators or stoves.

• To avoid fire or shock hazard, plug the appliance directly into a 120 Volt AC
electrical outlet.

• To protect against electrical hazards, DO NOT immerse in water or other liquids.
Do not use near water or place near a window where rain may enter and come
in contact with the unit.

• Close supervision is necessary when any appliance is used by or near children, or
by disabled persons.

• DO NOT operate any appliance with a damaged cord or plug, if motor fan fails
to rotate, after the appliance malfunctions, or if it has been dropped or damaged
in any manner.

• DO NOT attempt to repair or adjust any electrical or mechanical functions on this
unit. Doing so will void your warranty. Return the appliance to the manufacturer
for examination, electrical or mechanical adjustment, or repair.

• DO NOT operate in the presence of explosive and/or flammable fumes.

• Use appliance only for its intended household use as described in this manual.
Any other use not recommended by the manufacturer, such as commercial or
industrial use, may cause fire, electric shock, or injury to persons.

• DO NOT use outdoors.

• Always unplug the fan before assembly or disassembly, when moving from one
location to another, before cleaning, or whenever the fan is not in use.

• To disconnect, grip the plug and pull it from the wall outlet. Never pull on the
cord.

• Always use on a dry, level surface.

• Avoid contact with moving parts. DO NOT operate without fan grills properly in
place.

SAVE THESE INSTRUCTIONS!

WARNING: This fan is equipped with a polarized alternating current line plug (one

blade is wider than the other). This plug fits into the power outlet only
one way. This is a safety feature. If you are unable to inser t the plug
fully into the outlet, try reversing the plug. If the plug still fails to fit,
contact an electrician to replace the obsolete outlet. Do not defeat the
safety purpose of the polarized plug.

2

English

ASSEMBLY INSTRUCTIONS

Your table fan comes completely assembled and
is ready for immediate use carefully unpack your
fan, refer to the operating instruction below and
enjoy.

MAINTENANCE INSTRUCTIONS

CLEANING:

Always unplug the fan before cleaning or
disassembling. Be sure to use a soft cloth
moistened with a mild soap solution.
Do not immerse fan in water or allow water to
drip into the fan housing. Avoid the use of
gasoline, benzine, thinner, etc. This will result in damage plug to the fan.
The following three steps are suggested for cleaning the blade.

1. Use a screwdriver to open the clips on the front guard frame to remove the front guard from the rear
guard.

2. Clean the blade with a soft cloth, moistened with a mild soap solution.

3. Secure the front guard to the rear guard with clips after cleaning.

STORAGE:

1. Clean thoroughly and store in the original box.

FAN OPERATION:

1. Set fan base on a dry, level surface.

2. Plug cord into any standard 120V AC 60Hz outlet making sure the speed control is at OFF.

ADJUST THE VERTICAL ANGLE

1. To adjust the vertical angle, hold fan guard and loosen the vertical setting knob. Adjust the fan to the
desired vertical angle then tighten the vertical setting knob.

OSCILLATING CONTROL

1. Pull the oscillating pin upward to keep the fan in a stationary position.

2. Push the oscillating pin downward for a 90-degree oscillating movement.

Issue: November. 04

Limited Warranty

This item is warranted to be free from defects in materials or workmanship for a period of five (5) years
from the original date of purchase under normal household use. Within the warranty period, we will
replace the product. This warranty extends only to the original retail purchaser, and excludes any damage
to the product resulting from accident or misuse. The product is not warranted when used in a commercial
or business environment. The above warranty is complete and exclusive. The warrantor expressly disclaims
liability for any special, incidental, indirect, or consequential damages in connection with the purchase or
use of this product or costs over the original purchase price. Any implied warranties arising by operation of
law shall be limited in duration to the terms of this warranty. This warranty gives you specific legal rights
and you may have other rights, which vary by jurisdiction. This warranty is valid only within the United
States of America.
IMPORTANT! Do not return this product to your retailer. If for any reason this product malfunctions, please
follow the directions below and return the product to the manufacturer to receive areplacement product of
equal or greater value. 1-877-337-3639
Cut the power cord off the product. (MAKE SURE THAT THE PRODUCT IS REMOVED FROM THE POWER
OUTLET.) Remove the rating tag/label from the back or bottom of the product. Return both items to the
closest return center with a check for $5.99 to cover shipping and handling. Please be sure to include your
return address. Allow 10-15 working days for shipment.

Haier Return Center
1356 Broadway
New York, NY 10018