Haier LD42U7000, LD50U7000 User Manual

0 (0)

LED LCD TV

OWNER' S MANUAL

MODEL: LD42U7000

LD50U7000

Please READ this manual carefully before operating your TV, and retain it for future reference

Contents

1. SAFETY AND WARNINGS .............................................................................................................2

2. INTRODUCTION ............................................................................................................................4

3. INSTALLATION ...............................................................................................................................5

4. REMOTE CONTROLLER ............................................................................................................. 11

5. TV OPERATION ........................................................................................................................... 12

6. TROUBLE SHOOTING ................................................................................................................23

-1-

IMPORTANT SAFETY INSTRUCTION

1) Read these instructions.

2) Keep these instructions.

3) Heed all warnings.

4) Follow all instructions.

5) Do not use this apparatus near water.

6) Clean only with dry cloth.

7) Do not block any ventilation openings, install in accordance with the instructions.

8) Do not install near any heat sources such as radiations, heat registers, stoves, or other apparatus

(including ampliers) that produce heat.

9) Do not defeat the safety purpose of the polarized

plug. If the provided plug does not t into your outlet,

consult an electrician for replacement of the obsolete outlet.

10) Protected the power cord from being walked on

or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11) Only use attachments/accessories specied by the

manufacturer.

12) Unplug this apparatus during lighting storms or

when unused for long periods of time.

13) Refer all servicing to qualied service personnel.

Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

14) Mains plug is used as the disconnect device, the

disconnect device shall remain readily operable.

15) The ventilation should not be impeded by covering

the ventilation openings with items, such as newspapers, table-cloth, curtains, etc.

16) No naked ame sources, such as lighted candles,

should be placed on the apparatus.

17) Attention should be drawn to the environmental

aspects of battery disposal.

18) The use of apparatus in moderate climate.

19) The apparatus shall not be exposed to dripping

or splashing and that no objects lled with liquids,

such as vases, shall be placed on the apparatus.

Manufactured under license from Dolby Laboratories. Dolby and the double D symbol are trademarks of Dolby Laboratories.

SAFETY AND WARNINGS

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN!

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The symbol indicates that dangerous voltages constituting a risk of electric shock are present within this unit. The symbol indicates that there are important operating and maintenance instructions in the literaturaccompanying this unit.

WARNING:

To reduce the risk of re or electric shock, do not

expose this apparatus to rain or moisture.

WARNING: The batteries shall not be exposed to excessive heat

such as sunshine, re or the like.

This symbol indicates that this product incorporates double insulation between hazardous mains voltage and user accessible parts. When servicing use only identical replacement parts.

This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.

CAUTION

-2-

SAFETY AND WARNINGS

High voltages are used in the operation of this television receiver. Do not remove the cabinet back from your set.

Refer servicing to qualied service personnel.

To prevent re or electrical shock hazard, do not expose the

television receiver to rain or moisture.

Do not drop or push objects into the television cabinet slots or openings. Never spill any kind of liquid on the television receiver.

Do not block the ventilation holes in the back cover. Adequate ventilation is essential to prevent failure of electrical components.

Never stand on, lean on, or suddenly push the television or its stand. You should pay special attention to children. Serious injury may result if it falls.

Do not place your television on an unstable cart, stand, shelf or table. Serious injury to an individual , and damage to the television, may result if it falls.

When the television receiver is not used for an extended

period of time, it is advisable to disconnect the AC power cord from the AC outlet.

Avoid exposing the television receiver to direct sunlight and

other sources of heat. Do not stand the television receiver directly on other products which give off heat, e.g. video

cassette players and audio ampliers. Do not place naked ame sources, such as lighted candles on the television.

Minimum distances

10cm 10cm

20cm

5cm

Do not trap the power supply cord under the television receiver.

Dim:515*320mm(不包括底座）

If the television is to be built into a compartment or similar enclosure, the minimum distances must be maintained. Heat build-up can reduce the service life of your television, and can also be dangerous.

-3-

Main features

INTRODUCTION

Used as Television, display terminal, PC display;

High luminance, wide viewing angle;

Can store 200 TV programs;

HDMI interface;

Multi-Media player (USB);

Accessories

LED LCD TV.................................1 Power Cord......................................1

Bottom Stand..................................1 User Manual....................................1

Screw..............................................1

Remote Control..............................1 Quick Set Up Guide........................1

Battery(AAA).................................2

Warranty Card.................................1

(Only for India, Indonesia, Philippines)

E-waste Guideline Booklet.............1

(Only for India)

Main parameter

Model Name LD42U7000 LD50U7000 Resolution 1920 x 1080 1920 x 1080 Aspect Ratio 16:9 16:9

TV System

Video Signal System PAL/SECAM/NTSC PAL/SECAM/NTSC Receiving Channel 1-200 1-200 Input Power Voltage AC 100-240V 50/60Hz AC 100-240V 50/60Hz Power consumption 100W 120W Audio Output

Power(THD≤7%)

Subwoofer 12W 12W

Signal Input

Horizontal denition (TV line)

Ambient Temperature 0 to 45 degree Celsius 0 to 45 degree Celsius

Wall mount

PAL/SECAM BG DK I , NTSC-M PAL/SECAM BG DK I , NTSC-M

2 x 8W 2 x 8W

Analog RGB(VGA) x 1

High-Denition Multimedia Interface

(HDMI) x 2 Composite Video Input x 2 Composite Video Output x 1 Audio Input x 1 YCb (Pb )Cr (Pr) x 1

Composite Video input >=350 Y Cb(Pb ) Cr(Pr) >=400

VESA mount pattern: 400 x 400mm Screw: M6 Length: 16.5mm

This product does not include wall-mount braket module.

USB x 3 RF x 1 SD x 1 Coaxial x 1 Ethernet x 1

Composite Video input >=350 Y Cb(Pb ) Cr(Pr) >=400

VESA mount pattern: 400 x 200mm Screw: M6 Length: 14.5mm

-4-

INSTALLATION

Front panel

1 2

3030

1. Remote control sensor.

2. Indicator LED: LED OFF POWER ON.

RED STANDBY.

3. Key board

KEYBOARD

SOURCE

VOL+

VOL-

POWER

1. SOURCE : Display the input source menu.

2. MENU : Display main MENU.

3. VOL+/ VOL- : Adjust sound level. In Menu mode, press "VOL+" or "VOL-" to adjust the item that you selected.

4. CH / CH : In TV mode, press CH or CH to change the channel up and down. In MENU mode, press CH or CH to select items.

5. (POWER) : Press this button to turn the unit ON from STANDBY mode. Press it again to turn the set back to STANDBY.

REAR AV Connections(SIDE)

All the terminals are (from up to down): AV1 IN, USB, HDMI 1, SD/MMC, USB 3.0, AV OUT.

-5-

DOWN AV Connections

All the terminals are (from left to right): LAN, COAXIAL, HDMI 2, RGB(PC), YPbPr/AV2 IN, ANT IN

Note: VIDEO, YPbPr and RGB(PC) all share one audio channel.

ANTENNA

Plug

INSTALLATION

Note: Aerial connections: IEC (female).

Input impendance: 75Ω unbalanced.

ANT 75Ω

Adaptor (NOT SUPPLIED)

Loosen the screws

TWIN-LEAD FEEDER(300Ω)

Insert the feeder in Wires

An outdoor antenna

An outdoor antenna CATV net

Tighten the screws

-6-

STEPS: Be sure both the TV and computer are Power off.

1. Connect VGA and audio cable.

2. Connect power cord.

3. Power on the TV switch to PC mode.

4. Power on the PC.

This sequence is very important.

INSTALLATION

Note: Appearance in the book is a schematic diagram, please buy the real.

-7-

+ 17 hidden pages