DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral
triangle is intended to alert the user to the presence of
uninsulated dangerous voltage within the product s
enclosure that may be of sufficient magnitude to constitute a
risk of electric shock.
The exclamation point within an equilateral triangle is intended
to alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature
accompanying the appliance.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT USE THIS
POLARIZED PLUG WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT
BLADE EXPOSURE.
CAUTION: These servicing instructions are for use by qualified service
personnel only. To reduce the risk of electric shock, do not perform any
servicing other than that contained in the operating instructions unless
you are qualified to do so.
CAUTION: USE OF ANY CONTROLS, ADJUSTMENTS, OR PROCEDURES
OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS
RADIATION EXPOSURE. (This item is only for TV with DVD models.)
IMPORTANT SAFETY INSTRUCTIONS
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the
manufacturer's instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves,
or other apparatus (including amplifiers) that produce heat.
9) Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
10) Only use attachments/accessories specified by the manufacturer.
11) Use only with the cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid injury from tip-over.
12) Unplug this apparatus during lightning storms or when unused for long
periods of time.
13) Refer all servicing to qualified service personnel. Servicing is required when
the apparatus has been damaged in any way, such as power-supply cord or plug
is damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or
has been dropped.
14)The apparatus shall not be exposed to dripping or splashing and that no
objects filled with liquids, such as vases, shall be placed on the apparatus.
15)The mains plug or appliance inlet is used as the disconnect device, remain it
readily operable during the apparatus normal use.
Front Panel Controls..................................................................................
3. MENUMenu display. Press to access the on-screen menu display.
4. VOL- Volume down / Left button to adjust the item in the OSD.VOL+ Volume up / Right button to adjust the item in the OSD
/Press to enter.
5. CH- TV channel down / to select the item in the menu.
CH+ TV channel up / to select the item in the menu.
6. Power indicator
7. Remote Sensor Receivers IR signals from the remote control.
Do not put anything near the sensor ,which may
block the remote control signal.
DVD
OPEN/CLOSE
PLAY/PAUSE
STOP
PREV
NEXT
DVD slot load
Insert DVD with the label side facing towards
the back. (Silver "shiny" side facing towards you)
The above figure is for reference
only, connections may differ
depending upon the models and
terminals of some models may be
on the back bottom of the set
1. HDMI: Connect a HDMI device to receive digital audio and uncompressed
digital video.
2.VGA Connect to the VGA 15PIN analog output connector of a PC
graphics card to use set as a PC display.
3.Component Input Connect a component video device to these jacks.
4.S-VIDEO Connect S-Video out from an S-Video device to the jacks.
5.VIDEO Out
6.AUDIOConnect audio input from an external device to these jacks.
7.
Video in Connect video output from an external device to this jack.
Connect video input from an external device to this jack.
Out
8.Audio in Connect audio output from an external device to these jacks.
9.PC audio in Connect the audio output from the pc to the PC audio input port.
10..Headphone jack : Headphone audio output terminal.
11. ANT IN(Antenna Input) Connect cable or antenna signals to the TV,
either directly or through your cable box.
Remote Control Key Functions
When using the remote control, aim it
towards the remote sensor on the TV
1
DISPLAY
OPEN/CLOSE
2
ARC
3
4
5
6
P.MODE S.MODE SLEEP
D.AUDIO
SUBTITLE
CCD MTS/SAP
1.Press to turn on and off the TV
2.Press to display the TV status information on the top
21
of the TV screen
22
3.Press to change the aspect ratio
23
4.Press repeatedly to cycle through the available picture
24
modes
25
DVD AUDIO
5.
6.DVD SUBTITLE
7.Show the input source
8.Switches the TV sound on or off
26
9.Press to adjust the volume
10.Press to open the on-screen menu
11.Thumbstick(Up/Down/Left/Right)
27
Allows you to navigate the on-screen menus
and adjust the system settings to your preference
28
12.Clears all on-screen displays and returns to TV viewing
from any menu
29
13.DVD ZOOM
14.DVD REPEAT
15.DVD FAST FORWARD
30
16.DVD FAST REVERSE
17.DVD TITLE
31
18.DVD SET UP
19.DVD PROGRAM
20.DVD A-B
21.DVD Open/close
32
22.Press to display the sleep timer option
33
23.Press to cycle through different sound settings
34
35
36
37
38
39
40
Select MONO, STEREO, SAP
24.
25.Select a closed caption option
26.Press to change a channel
27.SCAN
28.Press to jump back and forth between two channels
29.Press to scan through channels. To scan quickly
OK
PLAY/PAUSE
PREV NEXT
SEARCH
ANGLE D.CALL
SCAN
RECALL
H.LOCK
STOPZOOMREPEAT
10+
7
8
9
10
11
12
13
14
15
16
17
18
19
20
INPUT
MUTE
VOL CH
MENU
EXITD.MENU
REV
TITLE
SETUP
PROGRAM
A-B
between the last two channels, press and hold down
either +/- .
V-CHIP
30.
31.Confirm button
32. DVD menu
33. DVD PLAY/PAUSE
34. DVD STOP
35. DVD Previous Chapter
(For TV with DVD)
36. DVD Next Chapter
37.DVD SEARCH
38.DVD 10+
39.DVD CALL
40.DVD ANGLE
When using the remote control, aim it towards the remote sensor on the TV.
1.
1
SCAN
2
3
INPUTDISPLAY
4
MENU
5
6
EXIT
7
P.MODE ARC
8
9
CCD MTS/SAP
10
PIP SWAP MOVE
11
12
13
(For TV without DVD)
1 2 3
4 5 6
7 8 9
0
CH+
VOL-
OK
CH-
VOL+
SLEEP
H.LOCK
HDMI
MUTE
RECALL
S.MODE
FREEZE
FAVORITE
14
15
16
17
18
19
20
21
22
23
24
25
Press to turn on and off the TV
2.SCAN
3.Not available
4.
Show the input source
5.
Press to open the on-screen menu
6.Volume/Channel Selection
7.
Clears all on-screen displays and returns to TV viewing
from any menu
8.
Press repeatedly to cycle through the available picture
modes
9.
Press to change the aspect ratio
10.
Select a closed caption option
11.
Select MONO, STEREO, SAP
12.Not available
13.Not available
14.HDMI mode
15.
Press to change a channel
16.
Press to display the TV status information on the top
of the TV screen
17.
Switches the TV sound on or off
18.Confirm button
19.
Press to jump back and forth between two channels
20.
Press to cycle through different sound settings
21.
Press to display the sleep timer option
22.Not available
23.
V-CHIP
24.Not available
25.Not available
Loading...
+ 20 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.