Page 1
HWT60AW1
HWT70AW1
AUTOMATIC WASHING MACHINE USER MANUAL
400W
HWT70AW1
385W
HWT60AW1
370W
345W
Rated load 7.0kg6.0kg
39kg
33kg
44.5kg
W 550 D 570 H 940
37.5kg
W 520 D 540 H 915
44 Min
Mid
7
58 Min
Mid
Mid
10 Min
52 Min
Mid
3 Min
Quick
35 Min
--（Fuzzy）
Mid
Mid
3 Min
SyntheticSynthetic
53 Min
0030807525M
Drum DryDrum Dry
Page 2
Location
Placed in the upper foam piece inside
the washing machine packaging
On The Drain hose
One
Drain hose hoop
Page 3
Page 4
if
FA
Warning
65
If the supply cord is damaged, it
must be replaced by a special cord
or assembly available from the
manufacturer or its service
agent.
Forbidden
The openings must not be obstructed
by a carpet
Page 5
This appliance is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that
they do not play with the appliance.
Remove
Page 6
The energy test program was performed using the “Normal”cycle setting of:
Normal,9mins Spin,Water Level Max,Warm
/PUF
Please use low suds/high efficiency detergent.
$:$-&(6*%&
This washer has a 2-step water fill to achieve the required water level and
temperature for the best cleaning result.
First Fill-Once options and cycle are selected
is followed by a 5-minute (approximately)soak-agitation session to help the detergent
mix completely with the laundry.
NOTE:If Cold wash temp is selected,hot water is not used.
Second Fill-The second fill starts when the washer begins to agitate and continues
until the selected water level is reached.Cold water only is used regardless of wash
and the START/PAUSE BUTTON is pressed,both hot and cold water will flow into the
inner tub.The warm water temperature helps to dissolve detergent quickly.The first fill
temp selection.
Key
digital tub
，
All of the Buttons are locked，and will no
you will hear three beep sound
，
key
Then hold the water level Button and temp Button at
key
the water level button and temp Button at the same time for more than 3 seconds，
Set the desired washing program,after seting,press the Start/Pause Button,and
washing machine begin to run
function.
the same time for more than 3 seconds
display“CL”,and the key lock will activate
and wall should be at least 20mm
Page 7
back
clamp
%FMBZ
Ą8BUFSMFWFMą
Ą5FNQą
Synthetic and “Sock Wash”
Set the spin time in accordance to the requirements of each load.
1SFTTUIFĄ4QJO5JNFąCVUUPOUPDIBOHFUIFTQJOUJNF
W
(i.e .if “ arm” is selected, the wash cycle will be warm,the rinse cycle will
be cold)
The suitable temperature between 35-65°C
Page 8
Quick
Quick” cycle for a small load of lightly soiled laundry. When
Press the “Cycle” button to select automatic program
When the power is switched on “Normal” cycle is automatically set. To
select a different automatic cycle,rotary program knob till the
corresponding indicator is on.Refer to the section on the “cycle” button
above.
E.g choose “
the “Synthetic”or“Soak Wash”or“Memory”cycles are selected the Fuzzy
Logic program is run .The washing cycle is automatically set while the
water level and wash time can be selected according to the texture and
H
size of the load.
used and that old hose-sets should not be reused.
The new hose-sets supplied with the appliance are to be
Page 9
QuickDrum
Mid,High,Max.
(Low-Max).
F
F
S
D
D
Mid Mid
A spin time setting will automatically be selected with the wash cycle.Use this button
to change the default setting.
D “Spin Time” button
E
Page 10
H
ABCDEF G
H
Mid
Low
Quick
Quick
Ideal for synthetic fabricsIdeal for synthetic fabrics
This programs is suitable for soiled items which require a soak
Drum Dry
Soak Wash
washing powder is used
If a manufacture specifies only the use of a low-sudsing or
high-efficiency type detergent, then detergent for drum type machines
shall be used irrespective of the type of machine under test.
Otherwise the detergent type to be used shall be chosen according to
the type of clothes washing machine under test, as follows.
Loading...