The appliance and its accessible parts become hot
during use.
Care should be taken to avoid touching heating elements.
Children less than 8 years of age shall be kept away unless
supervised.continuously
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
WARNING: Accessible parts may become hot during use.
Young children should be kept away
During use the appliance becomes hot. Care should be taken
touching heating elements inside the ovento avoid
Make use of residual heat from the
oven.If the cooking time is greater
than 40 minutes,switch off the oven
10 minutes before the end time.
Important when using the timer,set
appropriately shorter cooking times
according to the dish being prepared.
Make sure the oven door is properly
closed.
Heat can leak through spillages on the
door seals.Clean up any spillages
immediately.
Do not install the oven in the direct
vicinity of refrigerators/freezers.
Otherwise energy consumption
increases unnecessarily.
DISPOSAL OF THE APPLIANCE
Old appliances should not
simply be disposed of with
normal household waste,
but should be delivered to
a collection and recycling
centre for electric and
electronic equipment.
A symbol shown on the product, the
instruction manual or the packaging shows
that it is suitable for recycling.
Materials used inside the appliance are
recyclable and are labeled with information
concerning this. By recycling materials or
other parts from used devices you are
making a significant contribution to the
protection of our environment.
Information on appropriate disposal
centers for used devices can be provided
by your local authority.
Page 4
1. Oven operation buttons
2. Display
3. Oven door handle
4. Oven door
3
4
Page 5
The kitchen should be dry and have effective ventilation according to the
existing technical provisions.
Main lead behind the oven must be placed in such manner to avoid touching the
back panel of the oven because of the heat it develops during operation.
Remove any packaging materials(foils,artificial foam,nails,etc.)from the reach of
children,because they represent potential danger.Children may swallow small parts,
or suffocate with foils.
This is a built-in oven,which means that its back wall and one side wallcan be
placed next to a high piece of furniture or a wall.Coating or veneer used on fitted
furniture must be applied with a heat resistant adhesive(100℃),This prevents
surface deformation or detachment of the coating.If you are unsure of your
furniture's heat resistance,you should leave approximately 2cm of free space around
the oven.The wall behind the oven should be resistant to high temperatures.During
operation,its back side can warm up to around 50 above the ambient temperature
Make an opening with the dimensions given in the diagram for the oven to be fitted.
The appliance must be earthed.
Insert the oven completely into the opening without allowing the four screws in the
places shown in the diagram to fall out.
554
570
547
20
595
595
558
℃
0
6
5
600
600
0
4
558
595
595
554
570
600
560
547
20
40
600
.
(by authorised electrician)
Before attempting the connection,
check whether the voltage indicated
on the rating plate corresponds to
the actual mains voltage.
Mains lead should be minimum1.5m
long.
Earthing wire should be installed in
such manner to be the last one pulled
-
zzzz
out in case the safety relief device of
the mains lead should fail.
Mains lead behind the oven must be
placed in such manner to avoid
touching the back panel of the oven
because of the heat it develops
during operation.
The cable of corroct size rating must
2
the grounding wire shall be
1.5m.
m
longer than the other wires.
The means for disconnection from
the supply mains having a contact
separation in all poles that provide
full disconnection under over voltage
category iii shall be provided in the
For on / off oven lamp;Select a function, the light will turn on.
Used to set the clock, alarm, cooking time,end of cooking time.
Heating process used to confirm the selection.
After set a functions, touch this type you can set different
temperatures.
of cooking time,touch this key time of addition and
subtraction can be realized
To enable rapid heating.After setting the function and
temperature, touch this button allows the oven temperature
reaches the set temperature quickly
As soon as the child safety device is engaged,the appliance can no
longer be switched on.
Explanation
When set the clock, alarm, cooking time,end
Remark:
Use the function and temperature selector at the same time can turn on/off the oven.
Above is the control panel diagram, actual function please refer to product.
Select or set a function, must press button“”.
Heating Indicator
When the ” is on, that the oven is heating.“
Also will show the heating status “ ”, total 5 sections, each present 20%
of the setting temperature.
Cooking time
End of cooking time
Child Safety Device
Timer
Current time
Residual Heat Indicator
After oven stop working, temperature display ” show the residue heat “
information. 5 sections each stand for 20% of setting temperature.
Speedcook
Speedcook function is mainly used for preheating the oven. And preheating functionis
not yet complete, you can by pressing the speedcook button“ ”any time toexecute.
do the following:
1. Setting the function and temperature (See steps on page 12 “Feature Selection
/temperature regulation”).
2. Touch the rapid cooking button “ ” the temperature display will show “ ”.
the rapid cooking function is activated.
Page 7
3. This time Top element+Grill+Bottom element+Fan simultaneously work,
rapid increase in internal temperature oven.
4. After rapid heating to reach the set temperature,Icondisappears.“ ”
the“ ” is full grid logo.
5. Oven in step 1 settings continued heating.
Caution
Setting temperature lower than 100℃,no Speedcook .
Child Safety Device
To avoid mal-operation while the oven is working, the child lock function has been
added to this oven series.
Operate the oven when time display or normal heating function as below:
1. Touch “”button and hold for 5 seconds.
Time display area shows key icon “ , the appliance is locked.”
2. All the buttons are disabled after the child lock active, and the key icon“ ”,
keeps blinking, to show that machine is locked.
3. Touch and hold“ ”button for 5 seconds to unlock.
Use ON/OFF switch “ turn off the oven, the cooking time(“)andtheend
●
ofcookingtime( “”)
willbecancelled.
Change the temperature setting during working, time count down stop, press
●
“ ”,it will continue.
●
Press several keys at the same time, functions will not operate.
Change the function during working, time count down will stop.
●
When use touch control, to get the best result, remove your finger swift and
soft after touch, unless the manual have other directions.
Tips: Make sure your finger and buttons both dry and cool.
Opened the oven
1. Touch the button “ ” turn on the oven.
2. Touch button to select function.“ ”or “ ”
3. Touch button to set temperature.“ ”or “ ”
4. Touch ON/OFF button to switch off the oven“ ”
Function selection / Temperature regulation
1. Touch ON/OFF button “ to switch on the oven.”
2. Heat program display empty .“ ”
3. Touch button to select function.“ ”or “ ”
4. A suggested temperature will appear on display and blinking when function selected.
5. Touch button to set the temperature.“ ”or “ ”
6. Touch “”to confirm the selected temperature.
7. Oven start working.
””
Caution
● Never put food or tray on bottom of the oven.
● Keep children away.
● Set time before use.
● The temperature scope is 50 - 250 ℃ (defrost is 20 – 60℃) .℃℃
● “ ”“ ”Long press and can speed up temperature setting.
This is a 24 hour clock, make sure to set the right time before first use.
The clock can be set when the ON/OFF button in OFF position.
4. Touch button “ ” or button “ ” to confirm, or will auto confirm after 30 seconds.
Timer
To set the timer you should:
1. Touch button“ ”until the timer “ ” flashes on the display, and time display “0: 00”.
2. Touch to set alarm.“ ”or “ ”
3. touch button“ ” to confirm.
4. The “ ” stop flashing, time count down begin.
5. Alarm sounds when time count down finished, alarm icon “ ” flashing
6. Touch button “ ”,“ ”,“ ”or “ ”,the alarm signal will go off. or it
will be turned off automatically after 90 seconds.
7. If you want to cancel the timer, you can set the time to “ 0:00 ”.
Caution
● Always keep the control panel clean, or the grease may damage the touch panel.
● Touch panel need to be regular cleaned by soft cloth.
● The alarm function prior to cooking time and clock display (if all 3 functions are set up,
thedisplaywillshowthealarmcountdown).
● The alarm time range is 1 second to 23 hours 55 minutes. Alarm isjusttoremind.
Semi-automatic operation
This mode to set the oven cooking time, when time run out, oven stop working and alarm
sound to remind customer.
Set the cooking time when ON/OFF button is on, and the oven is working:
3. Touch “ ” to confirm, the cooking time”“ lights on, time set saved.
4. Set cook time run out, oven stop heating, alarm sounds, the cooking timeicon “”
and temperature iconbothflashing.
5. Touch button “ ”,“ ”,“ ”or “ ”,the alarm signal will go off. or it
will be turned off automatically after period of time.
“ ”
Automatic operation
Touch button “ to set end time only after set cook time.”
Set end time when the ON/OFF button “ is on, oven is working, and cook time already set:”
1. Touch button“for 3 times,the end of cooking time icon“flashing.”
2. Touch“ ”or “ ” to set the end of cooking time .
3. Touch“ ” to confirm, the end of cooking time“ light on, setting is saved.”
4. Oven stop heating when reach setting end time, alarm sounds, the cooking time “”
and temperature icon both flashing.
5. Touch button “ ”,“ ”,“ ”or “ ”,the alarm signal will go off. or alarm
signal will be turned off automatically after period of time.
”
For example
The current time is 2:00, set the cooking time to 1 hours, and set the end of cooking timeto
“3:00”, if not adjust end of cooking time by , “ ” but touch“ ” to save, then the oven
will stop heating by “ 3:00 ”.
If you touch button“ ” to adjust the end of cooking time to“3:30” , and touch button“ ”
to save ,then the oven start working at “ 2:30”and stop at “ 3:30”
end of cooking time
End of cooking time
End of cooking time = current time + cooking
End of the work time priority display than the current time
We suggest that you supervise the first few cooks to make sure time and
temperature are right.
Then you can make adjustment to avoid over or insufficient cook.
end of cooking time
time
For example
Current time is “2:00”, setcooktimeto 1 hour, soovenstopheatingwhen“ 3:00”.
Alarm sounds, the cooking time icon “ ” and temperature icon both flashing.
Touch button “ ”,“ ”,“ ”or “ ”,the alarm signal will
go off. or it will be turned off automatically after period of time.
6. If you want to cancel the cooking time, you can set the cooking time to “ 0:00 ”.
Page 9
Circular heater Fan
with Bottom Element
This operates the fan oven with the
convection element and the bottom
element allowing for cooking with
increased temperature from the
bottom
position 3
knob to .
of 220 is
adjusted and
of the dish when using shelf
or 4 . set the oven operation
the default temperature
displayed and can be
button.
Fan and bottom heater on
Do not wait until the oven is coated in grease to
run a pyrolytic programme.
The smoke produced by pyrolysis is broken down
by passing through a catalyser.
Please note: Before any pyrolytic programme,
remove all shelves, trays and other accessories
from the oven and clean up any major spills to
avoid the risk of fire or excessive smoke.
Do not hang towels or cloths on the oven
handle during pyrolysis.
The programme immediately locks the door and
starts the cooling fan at a slow setting; the
cooling fan speed increases to its maximum
when the oven heat builds up.
Economy Grill (variable) (1100w)
Use the economy grill to grill or brown
small amounts of food. Locate the grill
pan in the 4th or 5thshelf position .
pre-heat the grill for 5 minutes before
use .
Fan,grill element
top heater
At this oven function , the oven activates
the bottom heater and fan function.
The mode is useful for baking low pastry
and preparation of preserved fruit
and
vegetables.
Pyrolytic Oven - No Shelves
P
- Default 430°C
NOTE: This function has an added safety
feature to prevent it from being selected
accidentally. To run the pyrolytic function,
select “Pyrolytic”on the “Function Selector
Display”, then touch the “Boost/Pyrolytic” key
for 5 seconds to confirm the selection.
This oven can clean itself by a process known
as pyrolysis, heating the cavity to a temperature
of approximately 430˚C. This will burn off the
residue from spattering and spillages caused by
cooking. Pyrolytic programmes should be used
when the oven smokes during preheating or
cooking or if the oven smells even when cold.
It is not necessary to run a pyrolytic programme
after every use of the oven.
Before any maintenance is started
involving electrical parts, the
appliance must be disconnected
from the power supply.
If the oven has been in use, let the
oven cavity and the heating elements
cool down before attempting any
maintenance.
Changing the bulb
Unscrew the protective cover. We
l
recommend that you wash and dry the
glass cover at this point.
l
Carefully remove the old bulb and
insert the new bulb suitable for high
temperatures (300ºC) having the
following specifications: 220-240V,
50Hz, 25W, G9 fitting.
l
Refit the protective cover.
-Closetheovendoor.
-Setthetemperatureknobto50℃,
and the function knob to the bottom
heater position.
-Heat the oven chamber for
approximately 30 minutes.
-Open the oven door,wipe the
chamber inside with a cloth or sponge
and wash using warm water with
washing-up liquid.
● Aftercleaningtheovenchamberwipeitdry.
IMPORTANT
Never use screwdrivers or other
utensils to remove the light cover.
This could damage the enamel of the
oven or the lampholder. Remove only
by hand.
IMPORTANT
Never replace the bulb with bare
hands as contamination from your
fingers can cause premature failure.
Always use a clean cloth or gloves.
Fish in aluminium foilFish in aluminium foil 500500 44 230230 230230 1010--1313
ToastToast
4 slices of white bread4 slices of white bread 200200 55 240240 240240 1,51,5--33
2 s2 slices of whole meallices of whole meal 200200 55 240240 240240 22--33