Haier HWM70-A User Manual
User's Manual
HWM70-A
Fuzzy Computeried Automatic
Washing Machine
Please read this manual carefully before using.
Retain it for future reference
Please check if the power receptacle has good earthing
condition before using to guarantee your safety.
The manufacturer will not bear the responsibility for
those risks occurred from not obeying this manual.
Contents
Before using
Names of the parts The 2 cover
Safety precautions
Installation and adjustment
Install the water inlet hose 5
Using process
Preparation before washing
Put in the laundries
Add the detergent and softener
Use the operation buttons
Close the top lid
Finish washing
Disposal after washing
Trouble shooting *
Answers to questions
Picking list
Specifications the back cover
nd
10
14
14
15
16
17
1
3
7
8
9
Names of the parts
Before using
Before using
Before using
Before using
Top lid B
Detergent box
Control panel
Level meter
Lint filter(Installed by user)
Filter cover
Control panel
film
Front control
board
Pulsator
Cabinet
Adjustable foot
Top lid A
Drier outlet
cover
Power line
Inner tub
hanging hole
for the drain
hose
back cover
Adjustable foot
seam
Cool water valve
Warm water valve
Back faceplate
Cabinet handle
Drain hose
Front fixed
foot
Rear fixed foot
Accessories
The end connecting to
the washing machine
Jointer connecting
the water inlet hose
to the water faucet
The end connecting to
the water inlet hose jointer
Bottom plate
(1 piece)
Water inlet hose
(2 pieces)
Water inlet
hose jointer
(2 pieces)
Tapping screw
(8 pieces)
Lint filter
(1 piece)
Meaning and description of the symbols
Contents marked with
Warning
mark
Forbidding
mark
that symbol are related
to the safety of the
product and the personal
safety of the users. Failure
to comply with the
instruction could cause
damage of the machine
or injure the personal
safety of the user.
Contents marked with
that symbol are actions
forbidden to perform.
Failure to comply with
the instruction could
result in damage of the
machine or injure the
personal safety of the user.
Safety precautions
Before using
Before using
Before using
Before using
Please insert the power cord into special
receptacle with rated voltage.Be sure to
use single-phase three pins receptacle.
The earthing terminal must be earthed
reliably.If possible,please adopt electric
leakage protector.
Earth
Do not bend, stretch, twist, bind the power cord by force,
or reform it. Do not press or clamp it with heavy items. If the
power cord and power plug are bad, or the receptacle is loose,
be sure to have it replaced by the technicians of our special shop
or our agent, or the after-sale service department for the sake
of avoiding any risk. Keep the prong of the power plug clean.
If dust is found on the power plug, please wipe it off with dry cloth.
In case the washing machine is installed on
ground with carpet, be careful not to block the
ventilation hole with carpet.
The ventilation
holes at the
bottom
In normal usage of the washing machine,
the power plug shall be ready to be pulled
or plugged with hand. Be sure to pull the
plug off and close the water faucet in
following cases: power failure, delivering
the machine, setting the machine idle or
cleaning the machine. Do not plug
or pull the power plug with wet hand.
Do not use water with temperature
higher than 50 inside the tub.
Do not set the machine at damp place
like the bathroom. Never wash it with water.
Do not put wet laundries on the control
panel coating.
Do not let the machine share one receptacle with other
electric appliances. If the power plug is damaged, or the
plugging into the receptacle is loose, do not use it any
more.
Do not wash water-proof laundries like
the raincoat, bike covers, down textiles etc.
to avoid abnormal vibrations in spinning and
damaging the laundries.
Safety precautions
Before using
Before using
Before using
Before using
Do not put hand into the rotating tub. It is
dangerous even if the rotation speed is slow.
Take special care of the children. Keep
children away from the washing machine
to avoid them climbing on it.
Do not put any hot or heavy items
(such as the kettle with hot water) on the
washing machine.
Do not decompose, repair or alter
the machine by yourself.
Do not wash laundries with volatile
materials (such as thinner, petrol etc.).
The handicapped or children shall not
use the machine without care.
To prevent the lint in the tub from blocking
the cascade outlet and influencing the
cascade effect, please keep the lint filter
in good condition, and install it to proper
position during washing. If the lint filter is
lost or damaged, please contact the local
after-sale service department of our
company.
Keep the machine away from direct
sunlight and heat source like the heater.
To protect your laundries and washing
machine, please take out all of the coins,
buttons, sand, hairpin and other foreign
materials before washing.
Please check if the water faucet is open, and if
the connection of the water inlet pipe is proper.
It is suggested to use foamless washing powder.
Before using
Before using
Before using
Before using
Safety precautions
Please install and adjust the machine according to the requirement of the manual, which is very
important for you to operate the machine safely and properly.
Install the bottom plate
After opening the package, please lean the
washing machine gently down on soft items
(like towel cloth, blanket, etc.). Install the
bottom plate to the bottom of the machine
with eight screws by a cross screwdriver,
then lift the machine up gently. See to the
figure:
Adjust the installation position
The largest allowable slope of the shank base
of the machine is 2 . The slanting or rough
ground will result in unstable running or
stoppage of the machine. Please adjust it with
following methods:
Bottom plate
Screw
Back
Front
Soft item
Confirm it's horizontal:
If the bulb of the level meter at the balance display
position is inside the standard circle, it indicates that
the machine is horizontal. Otherwise you need to
adjust the adjustable leg of the machine.
Adjust the adjustable leg:
1.To twist the adjustable leg, please first lift up the
leg side slightly, loosen the adjustable nut, and
then twist the leg.
2.After adjustment, fasten the nut.
Air bubble
Suitable Not suitable
Standard circle
Loosen
High
Fasten
Low
Adjustable nut
Adjustable leg
3
Before using
Before using
Install the lint filter
After opening the package, please take out the lint
filter from the document bag, install it to the filter cover
of inner tub. See to the figure.
Before using
Before using
Inner tub
How to change the direction of the drain hose
1.Dismount the back cover of the washing machine.
2.Lay down the washing machine gently with the front side
facing the ground. Use cross screwdriver to loosen the
eight screws. Take off the bottom plate.
back
front
3.Put down the outer drain hose. Twist the drain hose nut
counterclockwise to take it off as indicated in Figure 1.
Take off the drain hose rack. Put the drain hose into
the cabinet as indicated in Figure 2.
Loosen
Outer
drain hose
Drain hose nut
Figure 1
Drain hose rack
bottom plate
soft item
drain hose nut
Figure 2
4.Dismount the protecting cover of the drain outlet at the other
side as indicated in Figure 3.
5.Extend the drain hose out of the other side. Fix the drain
hose onto the cabinet with the drain hose rack. Set the
drain hose nut on, and fasten the nut to the direction
indicated in the figure, as per Figure 4.
drain outlet
protecting
cover
Figure 3 Figure 4
6.Install the protecting cover of the drain outlet to the other side,
as indicated in Figure 5.
7.Install the bottom plate (method the
same as stated above). Lift up the
washing machine gently.
Lint filter
fasten
Figure 5
Page 3
Usage of the drain hose
The drain hose shall drain smoothly
1.The height of the drain hose shall be
less than 10cm, or the drainage will not
be smooth, and cost such long time that
the machine may stop at mid way.
2.Do not ramp or press the drain hose.
If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
4.If extra drain hose is needed, please
make separate purchase. The inner
diameter of the extra hose shall not
less than 30mm, and the length shall
not exceed 1.5m.
If the extra hose is too long, cut it
either at A or at B point.
Loading...