Haier HWM65-728, HWM65-728A User Manual

User's manual

This manual is for

HWM65-728

Please read this manual
carefully before using.
Retain it for future reference.

Fully automatic washing machine

W

0030808138

Packing list Specification

Specifications

Installation and adjustment

Usage of the drain hose

Preparation before washing

Put in the laundries

Usage of the detergent

Close the top lid

Installation the water inlet hose

Disposal after washing

Finish washing

Use the operation buttons

Trouble-shooting

Answer to question

Contents

Names of the parts

Safety precautions

Meaning and description of the symbols

1

Please check if the power receptacle has good earthing
condition before using to guarantee your safety.

Warning sign

Forbidding sign

Contents marked with that symbol are related
to the safety of the product and the personal

safety of the users. Please operate in strict

conformity to the contents, otherwise it may

cause damage of the machine or injure the

personal safety of the user.

Contents marked with that symbol are actions

forbidden to perform. Performing of those
actions may result in damage of the machine
or injure the personal safety of the user.

Control panel seat

Top lid component

Notes: All illustrations in this Manual are given for reference only. Your products

and accessories may show differences from these illustrations due to our
continuous improvement.

Names of the parts

Meaning and description of the symbols

Ú

Back cover

Power line

Drain hose

Cabinet handle

Water inlet valve

Jacket of
drain hose

Water absorption
cushion

Drain entrance
cover

Hanging
hole

Filter cover(2 pieces)

Control panel film

Cabinet

Adjustable foot

Adjustable foot film

Screw cover(right)

Back control board

Screw cover(left)

Outer tub cover

Lint filter

(2 pieces)

Balance ring

Inner tub

Liquid whitener inlet

Fixed foot (3 pieces)

Detergent box

Pulsator

2

Safety precautions

Please insert the power cord into
special receptacle with rated vol­tage.Be sure to use single-phase
three pins receptacle.The earthing
terminal of the receptacle must be
earthed reliably.If possible,please
adopt electric leakage protector.

When the machine is normally
using, please put the power plug
at the location easily to be insert­ed and extracted by hand. Be sure
to pull the plug off when there's
power failure, or the machine is
being moved, cleaned or when it
is idle.

If the power cord is bad, to avoid risk it is required to replace it by the
technicians of our special shop or the after-sale service department.
Keep the pin of the power plug clean.

Do not put the machine at damp
place like the bathroom . Never
wash it with water. Do not place
wet laundries on the control panel.

Do not use water hotter than 50 C .

In case the washing machine is in­stalled on ground with carpet, do not
block the ventilation hole with carpet.

Do not wash water-proof laundries like
the raincoat, bike covers etc. to avoid
abnormal vibrations in spinning.

Do not let the machine share one receptacle
with other electric appliances. If the power
plug is damaged, or the plugging into the
receptacle is loose, do not use the plug any
more.

The ventilation holes

at the bottom

3

Do not decompose, repair or alter the
machine by yourself.

Do not put any hot or heavy items (such
as the kettle with hot water ) on the
washing machine.

Do not wash laundries with volatile
materials (such as thinner, petrol etc.)

The handicapped or children without

care shall not use the machine.

Keep the machine away from direct
sunlight and heat source like the heater.

Safety precautions

Do not stretch hands into the working
machine. It is dangerous even if the
rotation is slow. Take special care of
the children.

Petrol

Thinner

Please check if the water faucet is open, and if the connection of the water inlet pipe is proper.
It is suggested to use foamless washing powder.

Please don t use the washer in the environment below 0 C; if the washer has been stored
below 0 C, please be sure to ensure the washer is placed under the room temperature for 24 hours

and then use otherwise the washing effects may be lowered or the washer may be damaged.

To change the direction of drain pipe, please contact the customer care agent of our company.

4

Installation and adjustment

Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.

Carpet

Back

Front

Bottom plate

Screw

Install the bottom plate

After opening the package, please lean the washing machine gently down
on soft items (like towel cloth,blanket, etc.). Install the bottom plate to the
bottom of the machine with seven screws by a cross screwdriver, then lift the
machine up gently. See to the figure:

Adjust the Installation position

The washing machine away from wall should be overrun 20mm. The largest
allowable slope of the shank base of the machine is 2 .The slanting or rough
ground will result in unstable running or stoppage of the machine.
Please adjust it with following methods:

Confirm it's horizontal:
Hang the lead line to check if it is horizontal.

Adjust the adjustable leg:

1 .To twist the adjustable leg, please first lift up the side of the
leg slightly, loosen the adjustable nut, and twist the leg.

2 .After adjustment, fasten the nut.

Fasten

Loosen

High

Low

the adjustable nut

the adjustable feet