Haier HWM150-0623S User Manual

Twin-tub Washing Machine
User's manual
Model: HWM150-0623S
Please read this manual carefully before using. Retain it for future reference.
Contents
Names of the parts
Safety precautions Installation and adjustment
The musts in washing
Usage of the detergent
Washing sequence
Disposal after washing
Trouble-Shooting *Answer to question
Packing list *Specification
Names of the parts
Drain selector
Wash selector
Wash timer
Water-filling entrance
Water-filling translation
Control panel
Bypass channel
Water level adjusting lever
Overflow filter
Lint filter
Drain hose
Cabinet handle
Pulsator
Valve cover
Wash tub
Base frame
Outer cover of the spin tub
Inner cover of the spin tub
Spin timer
Spin tub frame
Spin tub
Cabinet
Notes: All illustrations in this Manual are given for reference only. Your products and accessories may show differences from these illustrations due to our continuous improvement.
Meaning and description of the symbols
Warning sign
Contents marked with that symbol are related to the safety of the product and the personal safety of the users. Please operate in strict conformity to the contents, otherwise it may cause damage of the machine or injure the personal safety of the user.
Forbidding sign
Contents marked with that symbol are actions forbidden to perform. Performing of those actions may result in damage of the machine or injure the personal safety of the user.
Please check if the power receptacle has good earthing condition before using to guarantee your safety.
1
Safety precautions
Please insert the power cord into special receptacle with rated vol­tage.Be sure to use single-phase three pins receptacle.The earthing terminal of the receptacle must be earthed reliably.If possible,please adopt electric leakage protector.
When the machine is normally using, please put the power plug at the location easily to be insert­ed and extracted by hand. Be sure to pull the plug off when there's power failure, or the machine is being moved, cleaned or when it is idle.
If the power cord is bad, to avoid risk it is required to replace it by the technicians of our special shop or the after-sale service department. Keep the pin of the power plug clean.
Do not put the machine at damp place like the bathroom . Never wash it with water. Do not place wet laundries on the control panel.
Do not use water hotter than 50 C .
In case the washing machine is installed on ground with carpet , do not block the ventilation hole with carpet.
Ventilation hole at the bottom of the washing machine
Do not let the machine share one receptacle with other electric appliances. If the power plug is damaged, or the plugging into the receptacle is loose, do not use the plug any more.
Do not wash water-proof laundries like the raincoat, bike covers etc. to avoid abnormal vibrations in spinning.
2
Safety precautions
Do not stretch hands into the working machine. It is dangerous even if the rotation is slow. Take special care of the children.
Do not put any hot or heavy items ( such as the kettle with hot water ) on the washing machine.
Handicapped or children without care shall not use the machine.
Do not decompose, repair or alter the machine by yourself.
Do not wash laundries with volatile materials (such as thinner, petrol etc.).
l
tro
Pe
er
inn
Th
Keep the machine away from direct sunlight and heat source like the heater.
To protect your laundries and wash­ing machine, please take out all of the coins, buttons, sand, hairpin and other foreign materials before washing.
Please check if the water faucet is open, and if the connection of the water inlet pipe is proper.
It is suggested to use foamless washing powder.
3
Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine.
Install the lint filter
Put the underside of the lint filter into overflow filter then push the upside into overflow filter
After installation, please refer that the lint filter installed to the right station, otherwise the lint filter may be fall off when washing, influencing your use.
Usage of the drain hose
The drainage shall be smooth with the drain hose.
1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and cause incomplete drainage.
2.Do not tramp or press the drain hose.
3.If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the hose slantingly.
4.If extra drain hose is needed , please make separate purchase. The inner diameter of the extra hose shall not less than 40mm, and the length shall not exceed 1.5m.
overflow filter
lint filter
<10cm
> 40mm
<1.5m
If the extra hose is too long, cut it either at point A or B.
4
BA
Loading...
+ 12 hidden pages