Haier HWM120-35FF User Manual

Packing list

Name

User's manual

Water inlet hose

Lint filter

Single-tub washing machine

Specification

Water level / Water quantity (about)(L)

Injection pressure(MPa)

Rated washing capacity（kg）

Quantity

One piece

One set

Maximum/114 Medium/93 Minimum/71

0.02～0.2

12.0

Single-tub Washing Machine

This manual is for

HWM120-35FF

Please read this manual carefully before using. Retain it for future reference.

nua

Safety precautions

Please insert the power cord into special receptacle with rated voltage.Be sure to use single-phase three pins receptacle. The earthing terminal of the receptacle must be earthed reliably.If possible,please adopt electric leakage protector.

If the power cord is bad, to avoid risk it is required to replace it by the technicians of our special shop or the after-sale service department. Keep the pin of the power plug clean.

In case the washing machine is installed on ground with carpet , do not block the ventilation hole with carpet.

Ventilation hole at the bottom of the washing machine

Do not put the machine at damp place like the bathroom . Never wash it with water. Do not place wet laundries on the control panel.

Do not stretch hands into the working machine. It is dangerous even if the rotation is slow. Take special care of the children.

Do not put any hot or heavy items ( such as the kettle with hot water )on the washing machine.

Handicapped or children without care shall not use the machine.

When the machine is normally using, please put the power plug at the location easily to be inserted and extracted by hand. Be sure to pull the plug off when there'spower failure, or the machine is being moved, cleaned or when it is idle.

Do not use water hotter than 50 C .

Do not share one receptacle with other electric appliances. Do not use it in case that the power plug is damaged or the inserting into the receptacle is loose.

Do not decompose, repair or alter the machine by yourself.

Do not wash laundries with volatile materials (such as thinner, petrol etc.).

Keep the machine away from direct sunlight and heat source like the heater.

Names of the parts

Water selector

Timer knob

Water inlet

Control panel

Panel support

Quick water inlet

E DE

Cabinet

Base

Drain hose

Accessories

hinn rTehinn rT

符号含义说明

Contents marked with that symbol are related to the safety of the product

and the personal safety of the users. Please operate in strict conformity to

the contents.

Contents marked with that symbol are actions forbidden to perform.

Performing of those action may result in damage of the machine or

influence the personal safety of the users.

Filter cap

Lint filter(Installed by user)

Lint filter surport

water inlet hose

( one pc )

Water-filling jointer (one pc)

Lint filter

( one pc )

Top lid

Pulsator

Installation and adjustment

Ple ase ins tall an d adjus t the mac hine ac cordi ng to the r equir ement o f the man ual. It is v ery imp ortan t to your s ecuri ty and co rrect o perat ing the m achin e.

Usage of the drain hose

The drainage shall be smooth with the drain hose.

1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and cause incomplete drainage.

2.Do not step on or press the drain hose.

3.If extra drain hose is needed , the inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed1.5m.

Install the lint filter

Aft er open ing the p ackag e, plea se take o ut the li nt filt er from t he doc ument b ag, ins tall it t o the ove rflow f ilter o f the cab inet. See t o the fig ure

Adjust the installation position

The l arges t permi tted sl ope of th e beari ng surf ace of th e washi ng mach ine is 2. Slant ing or un even gr oundw ill cau se unst able op erati on of the m achin e. Plea se chec k with fo llo win g metho ds:

·Han g a becke t with we ight to c onfir m if the wa shing m achin e is hori zonta l.

Install the water inlet hose ; Select the water level

Insert the water inlet hose into the water-inleton the control panel directly. ( pull it out to dismantle it) Fill the water to the water level selected according to the quantity of the laundries. Attention:

·Do not exceed the " Maximum" water level , otherwise the water may overflow out of the machine.

Use the quick water inlet

Insert the water-filling jointer into water inlet hose, then push the water-filling jointer into the water inlet on the control panel. (To dismantle the water inlet hose, just push the control handle as indicated in the figure and pull it out)

Fill water into the wash tub directly through quick water inlet. It can reduce the humidity inside the control panel significantly and prolong the operating life of the components.

Water inlet

Water inlet hose

Water-filling jointer

Overflow filter

Quick water inlet

<1.5m

Maximum

（about 114L）

Medium

（about 93L）

Minimum

（about 71L）

Water inlet hose

Push

Control handle

> 30mm

Lint filter

Water level indicator

<10cm

1 Preparation before washing

Preparation before washing

1.Connect the water inlet hose.

2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe.

3.Hang the drain hose up.

2 Put in the laundries

The capacity of washing of the machinerefer to the largest weight of the standardlaundries under dry condition that can be washed in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity.

The thickness ,size , type of the cloth will influence the actual washing capacity. It is suitable to put in reasonable amount oflaundries and the laundries can be turned round in washing for one time washing.

Do not select " Maximum " water levelfor laundries less than 4.0kg, so as toavoid splashing of water.

Usage of the detergent

洗涤物的参考重量

How to use the whitener

Fill wa ter to dec ided lev el. Dilu te the whi tener wi th conta iner. Pour it slow ly into th e washin g tub.

Avoid u sing whitener on la undries w ith colo r or patte rn as they are pro ne to lose c olor.

The whi tener sh all not to uch the lau ndries d irectl y.

高

中

低低

Refer to the user's manual for the usage and quantity of the whitener.

For pow der whit ener, plea se disso lve it bef ore usin g.

How to use the washing powder

Direc t dissolve d in the machine :

1.Fil l small quan tity of water.

2.Add t he powder . Ru n for 30 secon ds to dissol ve it complete ly.

3.Put i t in the laund ries. Select s uitable water l evel.

The ins tant disso lving of the was hing powde r:

1.Pre pare warm wa ter of 30 C and a conta iner.

2.Add t he powder wh ile stirring t o fully disso lve it.

The pow der is more pr one to pollute t he laund ries than th e detergent. T herefore pleas e use it with pr oper quantit y.

Dosag e of differe nt washing p owder is differ ent. Please re fer to the instr uction of the wa shing powd er for the detai l dosag e.

3 Put in the detergent

How to use the whitener

Fill water to decided level. Dilute the whitener with container. Pour it slowly into the washing tub. Avoid using whitener on laundries with color or pattern as they are prone to lose color.

The whitener shall not touch the laundries directly. Refer to the user's manual for the usage and quantity of the whitener. For powder whitener, please dissolve it before using.

How to use the washing powder

Direct dissolved in the machine:

1.Fill small quantity of water.

2.Add the powder . Run for 30 seconds to dissolve it completely.

3.Put it in the laundries. Select suitable water level. The instant dissolving of the washing powder:

1.Prepare warm water of 30 C and a container.

2.Add the powder while stirring to fully dissolve it.

4 select the wash selector

Please select water current according to the laundries.

5 select the wash time

Please select wash time according to the laundries.

Laundries

Wash time（minutes）

Silk(thin laundries)

Knitwear/chemical fiber

Bed sheet

Cotton,blending,linen

Very dirty and thick laundries

The powder is more prone to pollute the laundries than the detergent. Therefore please use it with proper quantity.

It is suggested not to use high sudsing detergent.

Dosage of different washing powder is different. Please refer to the instruction of the washing powder for the detail dosage.

WASH SELECTOR

About2 4~

About3~6

About7~13

About8~10

About10~13

WASH TIMER

STANDARD

GENTLE

(To set to below 2 minute, first set to 6 minute then turn it back.).

OFF

6 Close the top lid

7 Finish washing

After washing, the buzzer will ring. Put down the drain hose

to discharge the water.

8 Disposal after washing

After using, please clean the lint and foreign materials of the lint filter and lint frame in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning.

Cleaning the lint filter

* The lint filter must be used during washing. * It must be cleaned in time after each using.

1. Take off the lint filter Put hand at the indicated position. Push down to take it off. (See to Figure 1)

2. Clean the lint Put it in water and clean while it is still wet.(See to Figure 2)

3. Install the lint filter After cleaning, insert the bottom of the lint filter (marked with "down side") into the filter frame, then push the upper part of the filter in (marked with "up side"). (See to Figure 3)

Figure 2

Attention: be sure not to confuse the direction.

Wipe the complete unit with soft cloth twisted dry.

Wipe with neutral detergent if too dirty. Do not wash it directly by water.

After washing, dismount the water inlet hose. Pull off the power plug and hang up the power cord. Do not store water in the tub for long period. Discharge the water immediately after each using. Wipe off the water drops on the surface and inside the tub with clean soft cloth. Open the cover of the wash tub for some time (about one hour), then close it. Hang up the drain hose.

Figure 1

Figure 3