Please read this operation manual
before using the air conditione
Please keep it attentively.
No. 0010523429
r.
Contents
1
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that they do not play
with the appliance.
Parts Name
2
Machine body
Front panel
Air inlet (indoor side)
Machine body
Air outlet (indoor side)
Air inlet (outdoor side)
Operation panel
Display
panel
Air filter (inside)
6
5
4
3
2
7
8
9
1
10
3
Operation Guide
4
Thermostat switch
This switch controls the preset indoor temperature
6
5
4
7
so as to reduce power consumption and operate the
system both comfortably and economicall
to mak
3
8
ethe air conditioner start or stop automatically,
y.
2
1
9
10
Remark:
The compressor stops running when the
set temperature is reached but the fan
continues to operate to keep an even
indoor temperature.
Airflow Direction Vane
Vertical Airflow Direction Vane is
The
manuall
vane t
downwar
y controlled by positioning the
odischarge the air upward,
d or straight out.
Vertical airflow direction
The horizontal air direction is adjusted
by setting the
the ON position
AUTO SWING switch to
.
Note:
It is advisable not to keep vertical flap at downward position for a long time
in COO
L or FAN mode, otherwise , condensate water might occur.
Don't move the horizontal flap with hand in order to avoid the vertical flap
abnormal, using the remote controller to adjust the move of vertical flap.
CAUTION
In cooling mode, after you turn thermostat switch counter-clockwise,
do not turn it back until at least 3 minutes have elapsed.
Otherwise, the fuse may blow due to overload.
Do not exceed the selection range.
Maintenance
5
Air filter cleaning (before cleaning, turn off the power)
When dirt accumulates on air filter, air circulation will be blocked, which causes poor
cooling. It is advisable to clean air filter every two weeks for longe
Take out the air filter
1.Press the concave parts on both sides at
the lower part of air inlet grille to open the
air inlet grille.
2.Hold the hump of filter mesh with
fingers (as illustrated) and take it out.
Hump
r operation.
Note: Open-angle should be less than 70 degrees in case of components damage.
Air filter cleaning
Cleaning of the
air filter
Maintenance
6
Disposal of the condensed water
Block the back hole of the conditioner with rubber lid and install outlet pipe fitting to the bottom
hole, which can make the condensed water flow out from the bottom plate. (See Fig.1)
If necessary the above can have extra pipe added on the outlet pipe fitting
(available on the market).
Fig.1
Rubber lid
Back hole
.
outlet pipe fitting
Bottom plate hole
Cautions
Power cord: Be sure to use the exclusive power cord.
Change
place please contact the deale
installation place: If air-con need to be changed to another
r, who sold you the unit.
Maintenance
7
Avoid opening doors and windows
unless necessary.
Use curtain or blind
Direct sunlight may reduce cooling
effect, always use window curtain.
Don't be exposed to cold air for
a long time.
Keep heat source away from
air conditioner.
Set temp . a little bit higher
before going to bed.
Proper
temperature
After unit stops, don't restart it
until 3 min. have elapsed.
OK! Enjoy a
3-min nap
Troubleshooting
8
Doesn't work
Is thermostat switch
wrongly adjusted?
Readjust the thermostat.
Use curtain or blind.
No cool air or
poor cooling
Is there any direct
sunlight in the room?
Are doors or windows
left open?
Are there any obstacles
blocking air inlet and
outlet?
Is air filter clogged?
Is there too much heat
source in the room?
Shut doors and windows.
Remove the obstacles.
Clean it.
Remove the heat source
Installation Instructions
9
Don't hang clothes in the vicinity
of air inlet. This will decrease
cooling effect and cause abnormal
operation.
Go away!
Temperature should be set
properly when there are infant,
child, the aged or disabled
in the room.
Baby has
gone sleep,
better to adjust
suitable temp.
Before operating mode selection
switch, check that if the air inlet
or outlet have been blocked.
For longer and trouble-free operation of the unit, pay special attention to
the following:
Install air-con at a place strong enough to support the unit.
Leave enough space around air inlet and outlet for better circulation.
Avoid places where flammable gas leaks.
Problems may occur if unit is installed in the following places:
Place where oil exists in the air including engine oil or seaside with
salt breeze blows and hot spring area with sulphurous gas in the air.
Installation Guide
10
Selection of the installation position
1.
The air-conditioner is better installed in shadow or in a place with short
period of sunshine. In case the air-conditioner is installed at the point
exposed directly to the sunshine, it should be protected from the direct
sunlight as possible in order to avoid the long time of direct sunlight
otherwise its performance will be lowered. (As illustrated in Fig. 1).
2. For the convenience of operation, it is recommended that air-conditioner
installed at least at the height of 760-1300 mm above the floor and no obstacles
be
before it for a free airflo
The shutters at both sides and the top of air-conditioner should be
3.
protruded outdoors free from being blocked by wall, windo
The back of air-conditioner should be kept over 500mm from the
4.
obstacles (for example, wall, etc.) (As illustrated in Fig. 2).
To have an efficient drainage, the back part of the air-conditioner should
5.
be inclined downward by 5-10mm (As illustrated in Fig. 3).