Haier HSU-10HM03/R2(DB), HSU-12HM03/R2(DB), HSU-10HT03/R2(DB), HSU-12HT03/R2(DB) Operation Manual
No.
HSU-10HM03/R2(DB)
HSU-12HM03/R2(DB)
HSU-10HT03/R2(DB)
HSU-12HT03/R2(DB)
SPLIT TYPE ROOM AIR CONDITIONER
OPERATION MANUAL
Please read this operation manual before using the air conditioner.
For the purpose of the safety,the air conditioner
must be properly grounded in accordance
with specifications.
Always remember to unplug the air
conditioner before openning inlet grill. Never
unplug your air conditioner by pulling on
the power cord. Always grip plug firmly and
pull straight out from the outlet.
All electrical repairs must be carried out
by qualified electricians. Inadequate repairs
may result in a major source of danger for
the user of the air conditioner.
Do not damage any parts of the air
conditioner that carry refrigerant by piercing
or performating the air conditioner's tubes
with sharp or pointed items , crushing or
twisting any tubes , or scraping the coatings
off the surfaces. If the refrigerant spurts
out and gets into eyes , it may result in
serious eye injuries.
Disposal of the old air conditioner
Before disposing an old air conditioner that
goes out of use, please make sure it's
inoperative and safe. Unplug the air
conditioner in order to avoid the risk of
child
entrapment.
It must be noticed that air conditioner
system contains refrigerants, which require
specialized waste disposal. The valuable
materials contained in an air conditioner
can
be recycled. Contact your local waste
disposal center for proper disposal of an
old air conditioner and contact your local
authority or your dealer if you have any
question. Please ensure that the pipework
of your air conditioner does not get
damaged
prior to being picked up by the relevant
waste disposal center, and contribute to
environmental awareness by insisting on
an appropriate, anti-pollution method of
disposal.
Disposal of the packaging of your
new air conditioner
All the packaging materials employed in
the
package of your new air conditioner may
be
disposed without any danger to the
environment.
The cardboard box may be broken or cut
into
smaller pieces and given to a waste paper
disposal service. The wrapping bag made of
polyethylene and the polyethylene foam pads
contain no fluorochloric hydrocarbon.
All these valuable materials may be taken
to a waste collecting center and used again
after adequate recycling.
Consult your local authorities for the name
and address of the waste materials
collecting centers and waste paper disposal
services nearest to your house.
Safety Instructions and Warnings
Before starting the air conditioner, read the
information given in the User's Guide
carefully. The User's Guide contains very
important observations relating to the
assembly , operation and maintenance of
the air conditioner.
The manufacturer does not accept
responsibility for any damages that may
arise due to non-observation of the following
instruction.
Damaged air conditioners are not to be
put into operation. In case of doubt, consult
your supplier.
Use of the air conditioner is to be carried
out in strict compliance with the relative
instructions set forth in the User's Guide.
Installation shall be done by professional
people, don't install unit by yourself.
Cautions
1
The machine is adaptive in following
situation
Cooling
Heating
Indoor
Indoor
Outdoor
Outdoor
Maximum: D.B/W.B 32∞C / 23∞C
Minimum: D.B/W.B 18∞C / 14∞C
Maximum: D.B/W.B 43∞C / 26∞C
Minimum: D.B 18∞C
Maximum: D.B 27∞C
Minimum: D.B 15∞C
Maximum: D.B/W.B 24∞C / 18∞C
Minimum: D.B/W.B -15∞C
Do not obstruct or cover the ventilation
grille of the air conditioner. Do not put
fingers or any other things into the
inlet/outlet and swing louver.
Do not allow children to play with the air
conditioner. In no case should children be
allowed to sit on the outdoor unit.
Specifications
The refrigerating circuit is leak-proof.
1. Applicable ambient temperature range:
2. If the power supply cord is damaged, it
must be replaced by the manufacturer
or its service agent or a similar qualified
person.
3. If the fuse of indoor unit on PC board is
broken,please change it with the type of
T. 3.15A/ 250V.
4. The wiring method should be in line with
the local wiring standard.
5. After installation, the power plug should
be easily reached.
6. The waste battery should be disposed
properly.
7. The appliance is not intended for use by
young children or infirm persons without
supervision.
8. Young children should be supervised to
ensure that they do not play with the
applience.
9.Please employ the proper power plug,
which fit into the power supply cord.
10.The power plug and connecting cable
must have acquired the local attestation.
Cautions
11.If the fuse of outdoor unit on PC board
is broken, please change them with the
corresponding type of T.1.0A/250V,
T.3.15A/250V,T.25A/250V.
2
Cautions
STRICT
ENFORCEMENT
Safety Instruction
Installation
WARNING
Please read the following Safety Instructions carefully prior to use.
The instructions are classified into two levels, WARNING and CAUTION according to
the seriousness of possible risks and damages as follows. Compliance to the
instructions are strictly required for safety use.
Please call Sales/Service Shop for the Installation.
Do not attempt to install the air conditioner by yourself because improper works
may cause electric shock, fire, water leakage.
lnstallation in a inadequate place may cause accidents. Do not install in the following place.
Connect the earth
cable.
earthing
Do not install in the
place where there is
any possibility of
inflammable gas
leakage around the
unit.
Do not get the unit
exposed to vapor
or oil steam.
Check proper
installation of the
drainage securely
PROHIBITION PROHIBITION
3
CAUTION
Cautions
WARNING
When abnormality such as burnt-small found,
immediately stop the operation button and
contact sales shop.
OFF
Use an exclusive power source with a
circuit breaker
ENFORCEMENT
Connect power supply cord
to the outlet completely
Use the proper voltage
Do not use power supply cord
in a bundle.
Take care not to damage
the power supply cord.
Do not use power supply cord
extended or connected in halfway
STRICT
ENFORCEMENT
STRICT
STRICT
ENFORCEMENT
PROHIBITION
PROHIBITION
PROHIBITION
PROHIBITION
Do not start or stop the
operation by disconnecting
the power supply cord and so on.
Do not channel the air flow directly
at people, especially at infants or
the aged.
Do not try to repair or reconstruct
by yourself.
Do not use for the purpose of storage of
food, art work, precise equipment,
breeding, or cultivation.
CAUTION
Take fresh air occasionally especially
when gas appliance is running at the
same time.
PROHIBITION
STRICT
ENFORCEMENT
Do not operate the switch with
wet hand.
PROHIBITION
PROHIBITION
4
PROHIBITION
PROHIBITION
PROHIBITION
Do not install the unit near a fireplace
or other heating apparatus.
Check good condition of the
installation stand
Do not pour water onto the unit
for cleaning
PROHIBITION
Do not place animals or plants in
the direct path of the air flow
Do not place any objects on or
climb on the unit.
Do not place flower vase or water
containers on the top of the unit.
Do not insert objects into the air
inlet or outlet.
PROHIBITION
PROHIBITION
PROHIBITION
Inlet grille
Outlet
Signal receiving window
(Use remote controller to
adjust up and down air flow.
Donít adjust it manually)
Vertical louver
Air filter(inside)
Anion generator
(inside)
Human sensor
Timed operation indicator
Operation indicator
Light sensing receiver
Human sensing indicator
Healthy operation indicator
Remote signal receiver
Power indicator
Sleep indicator
Air Purifying Filterr
(inside)
Power plug
Indoor unit
Outdoor unit
Horizontal louver
(adjust left and right air flow)
Control panel
Connecting piping and
electrical wiring
Inlet
Outlet
Drain hose
5
Parts and Functions
AUTO COOL DRY FAN HEAT
2.RESET
4.TIMER button
5. CLOCK button
It is to set light sensing function,
which enables normal operation
for strong indoor light (day) or
sleeprunning mode for weak
indoor light (night).
It is to set human sensing function,
which automatically gets standby if
detecting no human activity for
continuously 20 min, and automatically
starts running upon re-detecting
human activity.
button
8.HOUR button
9.HEALTHY button
10. ON/OFF button
24. TIMER OFF display
13. LOCK diaplay
14. SWING UP/DOWN diaplay
15. SLEEP diaplay
16. HEALTH diaplay
18.
20.SIGNAL SENDING diaplay
21.POWER/SOFT diaplay
22.Left/right air flow display
19.
23.TEMP display
25. CLOCK display
26.TEMP button
27.FAN button
28.SWING UP/DOWN button
29.SWING LEFT/RIGHT button
30.SET button
31.POWER/SOFT button
33.LOCK
6. SLEEP button
7.MODE button
34. LIGHT display
Only for the model with background
lighting function.
12. FAN SPEED diaplay
AUTO
HI
MED
LOW
32. button
Used to select nature air
17.
When the remote controller appears
abnormal, use a sharp pointed article
to press this button to reset the
remote controller normal.
Used to select TIMER ON,
TIMER OFF,TIMER ON-OFF
35. HEALTH AIRFLOW button
Used to set the health airflow mode.
11. TIMER ON display
3.
diaplay
diaplay
diaplay
Remote controller: to display the TEMP. setting
Used to select your desired temperature.
Used to select fan speed: LO,MED, HI, AUTO.
Used to select up or down air sending direction.
Used to select left/right air flow.
Used to confirm timer and clock settings.
Used to lock buttons and LCD display. If
pressed, the other buttons will be disabled and
the lock condition display appears.
Press it once again, lock will be canceled and
lock condition display disappears.
Used to set correct time.
Used to select sleep mode.
Used for unit start and stop.
Used to set healthy operation.
Used to set clock and timer setting
18
17
16
15
14
13
12
11
11
10
9
8
7
6
5
4
3
2
36
34
1
32
33
31
30
29
35
28
27
26
25
24
23
22
21
20
19
Parts and Functions
6
1.
button(light sensing)
Hint:
Remove the batteries in case unit won't be in usage for a long period. If there are any display afte
r
taking-out, just need to press reset key.
Clock Set
When unit is started for the first time and after replacing batteries in remote
controller, clock should be adjusted as follows:
1. Press CLOCK button,"AM" or "PM" flashes.
2. Press or to set correct time. Each press will increase or decrease 1
min. If the button is kept depressed, time will change quickly.
3. After time setting is confirmed, press SET, "AM" or "PM" stop flashing,
while clock starts working.
Remote controller's operation
When in use, put the signal transmission head directly to the receiver hole on the indoor unit.
The distance between the signal transmission head and the receiver hole should be within 7 m without
any obstacle as well.
Don't throw or knock the remoter controller.
When electronic-started type fluorescent lamp or change-over type fluorescent lamp or wireless
telephone is installed in the room, the receiver is apt to be disturbed in receiving the signals, so the
distance to the indoor unit should be shorter.
Loading of the battery
Load the batteries as illustrated right.
2 R-03 (7#) batteries
Remove the battery cover:
Slightly press" " area and push down the cover
as illustrated.
Load the battery:
Be sure that the loading is in line with the "+" / "-" pole
request as illustrated on the bottom of the case.
Put on the cover again.
Confirmation indicator:
After pressing power ON/OFF, if no display, reload the batteries.
Note:
Full display or unclear display during operation indicates the batteries have been used up.
Please
change batteries.
Used two new same-typed batteries when loading.
If the remote controller can't run normally during operation, please remove the batteries and
reload
several minutes later.
36. CODE
Used to select CODE A or B with a press,A or B will be displayed on LCD.
please select A without special explanation
NOTE:
The following functions and related displays are nto available:
CODE and LIGHT.
Parts and Functions
7
1. Unit start
Press ON/OFF the remote controller, unit starts.
2. Select operation mode
Press HEALTH button. For each press, is displayed
now the air copnditioner is operating the healthy function.
3. Unit stop
Press HEALTH button, the health function stops.
When the fan in the indoor unit does not work, the health lamp lights up, but
the anion generator does not release anion.
BRIEF INTRODUCTION TO HEALTH OPERATION
The anion generator in the air conditioner can generate a lot of anion to
effectively balance the quantity of position and anion in the air and also to kill
bacteria and speed up the dust sediment in the room and finally clean the air
in the room.
HEALTH Operation
Remote Controller
8
Note
Operation
Loading...