Haier HSU-09HG13-B - annexe 1, HSU-12HG13-B Operation Manual

Please read this operation manual before using the air conditioner.

SPLIT TYPE ROOM AIR CONDITIONER

OPER

ATION MANUAL

0010518180

HSU-09HG13-B
HSU-12HG13-B

Before disposing an old air conditioner that
goes out of use, please make sure it's inop­erative and safe. Unplug the air conditioner
in order to avoid the risk of child entrapment.

It must be noticed that air conditioner system
contains refrigerants, which require speciali­zed waste disposal. The valuable materials
contained in an air conditioner can be recycled
.Contact your local waste disposal center for
proper disposal of an old air conditioner and
contact your local authority or your dealer if
you have any question. Please ensure that
the pipework of your air conditioner does not
get damagedprior to being picked up by the
relevant waste disposal center, and contribute
to environmental awareness by insisting on an
appropriate, anti-pollution method of disposal.

Cautions

Disposal of the old air conditioner

All the packaging materials employed in the
package of your new air conditioner may be
disposed without any danger to the
environment.

The cardboard box may be broken or cut into
smaller pieces and given to a waste paper
disposal service. The wrapping bag made of
polyethylene and the polyethylene foam pads

contain no fluorochloric hydrocarbon.

All these valuable materials may be taken to
a waste collecting center and used again after
adequate recycling.

Consult your local authorities for the name
and address of the waste materials collecting
centers and waste paper disposal services
nearest to your house.

Disposal of the packaging of your
new air conditioner

Before starting the air conditioner, read the
information given in the User's Guide caref­ully. The User's Guide contains very impor­tant observations relating to the assembly,
operation and maintenance of the air
conditioner.

The manufacturer does not accept respon­sibility for any damages that may arise due
to non-observation of the following
instruction.

Damaged air conditioners are not to be
put into operation. In case of doubt, consult
your supplier.

Use of the air conditioner is to be carried
out in strict compliance with the relative
instructions set forth in the User's Guide.

Installation shall be done by professional
people, don't install unit by yourself.

For the purpose of the safety,the air con­ditioner must be properly grounded in acco­rdance with specifications.

Always remember to unplug the air
conditioner before openning inlet grill. Never
unplug your air conditioner by pulling on
the power cord. Always grip plug firmly and
pull straight out from the outlet.

All electrical repairs must be carried out
by qualified electricians. Inadequate repairs
may result in a major source of danger for
the user of the air conditioner.

Safety Instructions and Warnings

Do not damage any parts of the air
conditioner that carry refrigerant by piercing
or performating the air conditioner's tubes
with sharp or pointed items, crushing or
twisting any tubes, or scraping the coatings
off the surfaces. If the refrigerant spurts
out and gets into eyes, it may result in
serious eye injuries.

1

3. If the fuse of indoor unit on PC board is
broken,please change it with the type of

T. 3.15A/ 250V.

Do not obstruct or cover the ventilation
grille of the air conditoner.Do not put fingers
or any other things into the inlet/outlet and
swing louver.

Do not allow children to play with the air
conditioner.In no case should children be
allowed to sit on the outdoor unit.

The refrigerating circuit is leak-proof.

1.Applicable ambient temperature range:

Cooling

Indoor

Maximum:D.B/W.B

32

o

C/23oC

43

o

C/26oC

27

o

C/19oC

Maximum:D.B/W.B
Minimum:D.B

Minimum:D.B/W.B

Outdoor

Specifications

The machine is adaptive in following
situation

10 .The power plug and connecting cable

must have acquired the local attestation.

2. If the power supply cord is damaged, it
must be replaced by the manufacturer

or its service agent or a similar qualified
person.

4. The wiring method should be in line with
the local wiring standard.

5. After installation, the power plug should
be easily reached.

6. The waste battery should be disposed
properly.

7. The appliance is not intended for use
by young children or infirm persons

without supervision.

8. Young children should be supervised
to ensure that th

ey do not play with

the applience.

9.Please emp

loy the proper power plug,

which fit into the p

ower supply cord.

Cautions

11.In order to protect the units,please turn

off the A/C first, and at least 30 seconds
later, cutting off the power.

Indoor

Outdoor

Maximum:D.B
Minimum:

D.B/W.B

Maximum:

D.B

Minimum:D.B

Heating

2

35

o

C/24oC

20

o

C/-oC

27

o

C/-oC

7

o

C/6oC

24

o

C/18oC

15

3

Parts and Functions

OUTLET

INLET

CONNECTING PIPING AND ELECTRICAL WIRING

DRAIN HOSE

Outdoor Unit

HSU-09HG13-B

Indoor Unit

For model: HSU-09HG13-B HSU-12HG13-B

Remote signal receiver

Operation mode indicator

Timer mode indicator

Power indicator

Vertical flap

Air filter

Inlet grille

Emergency switch(manual)

Test running switch(manual)

Use remote controller to
adjust up and down air flo

w.

(Don't adjust it manuall

y.)

Lights up when unit starts. Lights up when

Timer operation

is selected.

Lights up during compressor
running.

A beeping sound is generated when

received.

a signal from remote controller is

Used when remote controller is lost or
defective. Unit will run temporaril

y.

Used only for test running in cooling

Don't use it in normal operation.

when room temp. is below 16

o

C.

HSU-12HG13-B

Actual inlet grille may vary from the one shown in the manual according to the product purchased

4

AUTO

LO

MED

HI

Parts and Functions

Operation

Buttons and display of the remote controller.

like the following figure:

If the unit which you purchased has healthy function, Remote controller should

BRIEF INTRODUCTION TO HEALTH OPERATION

The anion generator in the air conditioner can generate a lot of anion to
effectively balance the quantity of position and anion in the air and also to kill
bacteria and speed up the dust sediment in the room and finally clean the air
in the room.

Hints

After replacing with new batteries, remote controller will conduct self-check, displaying
all information on LCD. Then, it will become normal.

6. SIGNAL SENDING

7. TIMER OFF display

8. TIMER ON display

9. CLOCK display

10. TEMP display

11. POWER ON/OFF
Used for unit start and stop.

12. MODE
Used to select AUTO run, COOL,
DRY, HEAT and FAN operation

13. FAN
Used to select fan speed LO, MED, HI, AUTO

14. HOUR
Used to set clock and timer setting.

15. SWING
Used to set auto fan direction.

16. SLEEP
Used to select sleep mode.

17. LOCK
Used to lock buttons and LCD
display.

18. TEMP.
Used to select your desired temp.

19. SET
Used to confirm timer and clock settings.

20. TIMER
Used to select TIMER ON, TIMER OFF,

TIMER ON-OFF

21. CLOCK
Used to set correct time

22. RESET

Used to reset the controller back to
normal condition.

23. HEALTH

1. Mode display

AUTO

COOL

DRY

HEAT

FAN

2. SWING display

3. FAN SPEED display

4. SLEEP display

5. LOCK display

Used to set healthy operation

NOTE: Cooling only unit do not have displays and functions related with heating

HEALTH

ON/OFF TEMP

MODE SET

FAN TIMER

SWING CLOCK

SLEEP

LOCK RESET

4

1

2
3

11

12

13
14

15

16

17

5
6

7

8

9

10

19

21

22

18

20

A
U
T
O

ON

OFF

AM
PM

o

C

ÇëÑ¡ÓÃͬһƷÅÆÁ½½Ú
7#
µç³Ø,³¤Ê±¼ä²»ÓÃʱ,Ϊ

·АЦ¹В©Т¹Зл½«µз³ШИ¡
³ц¡£
ФЪК¹УГЦРИзУцТм³£,Зл
½«µз³ШИ¡³ц,6·ЦЦУºуФЩ
Ч°ИлРВµз³Ш¡£

º£¶ы¼¯НЕЗаµºº£¶ы
¿ХµчЖчУРПЮЧЬ¹«Л¾

ÇëÑ¡ÓÃͬһƷÅÆÁ½½Ú
7#
µç³Ø,³¤Ê±¼ä²»ÓÃʱ,Ϊ

·АЦ¹В©Т¹Зл½«µз³ШИ¡
³ц¡£
ФЪК¹УГЦРИзУцТм³£,Зл
½«µз³ШИ¡³ц,6·ЦЦУºуФЩ
Ч°ИлРВµз³Ш¡£

º£¶ы¼¯НЕЗаµºº£¶ы
¿ХµчЖчУРПЮЧЬ¹«Л¾

ÇëÑ¡ÓÃͬһƷÅÆÁ½½Ú
7#

µç³Ø,³¤Ê±¼ä²»ÓÃʱ,Ϊ

·АЦ¹В©Т¹Зл½«µз³ШИ¡
³ц¡£
ФЪК¹УГЦРИзУцТм³£,Зл
½«µз³ШИ¡³ц,6·ЦЦУºуФЩ

×°Èëеç³Ø¡£

º£¶ы¼¯НЕЗаµºº£¶ы
¿ХµчЖчУРПЮЧЬ¹«Л¾

5

Operation

Remote controller's operation

When in use, put the signal transmission head directly to the
receiver hole on the indoor unit.

The distance between the signal transmission head and the
receiver hole should be within 7m without any obstacle as well.

Don't throw the controller, prevent it from being damaged.
When electronic-started type fluorescent lamp or change-over

type fluorescent lamp or wireless telephone is installed in the
room, the receiver is apt to be disturbed in receivering the signals
so the distance to the indoor unit should be shorter.

Loading of the battery

Load the batteries as illustrated. 2 R-03 batteries, resetting key (cylinder)

Remove the battery cover:

Slightly press " " and push down the cover.

Load the battery:

Be sure that the loading is in line with the" + "/"-"
pole request as illustrated.

Put on the cover again
Confirmation indicator:

In disorderation, reload the batteries or load the new batteries after 6mins.

Note:

Use two new same-typed batteries when loading.
If the remote controller can't run normally or doesn't work at all,
use a sharp pointed item to press the reset key.

Hint:

Remove the batteries in case unit won't be in usage for a long period.
If there are any display after taking-out just need to press reset key.

Power failure resume(please set and apply as necessary)

If sudden power failure occurs, the unit will resume original operation when power is
supplied again.

Note:

When sudden power failure happens during unit operation in power failure resume mode, if
the air conditioner is not desired for use in a long period, please shut off the power supply
in case that the unit automatically resume operation when power is re-supplied, or press
ON/OFF to turn off the unit when power resumes.