Haier HR-180T2, HR-180T1 User Manual

HR-180T2

MODEL HR-180T1

REFRIGERATORS
OPERATING
INSTRUCTIONS

The manufacturer keeps on developing various

*

types of refrigerators, so he has the right to modify
designs, products and technical data without further
notice.

FIGURATION OF THE REFRIGERATOR

7

6

5

4

3

1. Low bottle support

3. Vegetable box

5. Drip tray

7. Thermostat

8

0

1

5

2

4

3

2. High bottle support

4. Shelf

6. Evaporator

8. Light Switch

1

2

The manufacturer reserves the right to improve the
product from time to time without further notice.

1

NOTICE

The power supply

HR-180T1 127v,60HZ
HR-180T2 220V, 50/60Hz

Single phase.
It is not
recomended
to use any
extention cords.

Connect the appliance
with a properly earthed three-wire
plug and socket with a special use.

SETTING UP

The appliance can be placed with its
rear panel directly against the wall.
For a good air circulation, the vent
grille at the back of the worktop must
not be blocked, It should be placed on
flat and firm ground lest it gives off
higher noise than usual.

Never store anything dangerous
in the appliance, such as
combustibles, exposives,
strong acid and alkali. etc.

Poorly ventilated rooms
are unsuitable. Avoid
positioning the appliance
in direct sunshine or
exposed to similar
sources of heat.

2

THERMOSTAT

1

2

5

4

3

The knob graduation 0, 1, 2, 3, 4, 5, 6, 7,
does not stand for concrete temperature.The smaller
the numbers,the higher the temperature in the
compartment and vice versa.Usually,it’s better to
put the thermostat in Pos. “1”,Pos. “4”.Pos. “0”
shows the power is cut off.

STORING FOOD

The temperatures in different positions inside
the refrigerator are different due to different
refrigeration distribution.Thus when store
food, select proper position to meet your
needs.
The coldest position áë=, Temperature
from low to high in order as  !K

ICE-MAKING

When making ice,add water to the ice tray
until 4/5 full with the grid in it and place it
on the bottom of the ice chamber. Twist the
tray or place it briefly in warm water to
remove the ice cubes.
NOTE
Do not use a knife and the like when
removing the ice tray.

3

NOTES ON STORAGE

Where necessary, food should be
packed in bags, avoiding giving
off strong odours or getting wet
or dry.

Hot food or liquid must be allowed
to cool to room temperature
before placing in it.

CLEANING

Do not store food too full in
the appliance. Allow space among
the packages of food for a
perfect refrigerating.

The appliance can only be cleaned at drawn network plug. Clean it
with lukewarm water containing a little detergent. In any case do
not use hot water,corrosive scouring agent and anything rough.

NOTE

Pull the
plug out

Do not use anything rough
for cleaning.

4

DEFROSTING

4~6mm

NOTES

When defrosting, switch off
the appliance. Remove food from
the ice chamber,it will be
defrosted automatically.When
defrosting process has been
completed, the drip-tray should
be depleted. Replace the food
and switch on the appliance.

If the appliance
remains out of
use for some time,
pull out the plug
to disconnect the
appliance from
power supply.
Clean the interior
as described

above to prevent
odours from
forming inside.

The appliance door
should be opened as
little and briefly
as possible to reduce
energy consumption

In the event of power
failure,try to keep
the appliance closed
to maintain the
refrigeration as long
as possible.

5