Haier HDN-2080MG, HDN-2080M Owner's Manual

Please read this booklet carefully before fixing and using and

save it for future reference.

1

Operation theory of microwave oven

1.Microwave is a kind of high frequency electromagnetic wave, which is commonly distributed in the nature.
But the existing form of microwave is dispersed so that it cannot be collected together for heating purpose.
The key component of magnetron of microwave oven will transform the energy of electricity to microwave
and huge energy of microwave field is established under the closed cavity. So the molecule of food is
caused to vibrate at very high speed and the friction heat produced will cook the food in a fast way.

2. There are 3 properties of microwave:
a) Absorbability, the microwave can cause the excess vibration of molecule of various food so as to obtain
the heating purpose. But the infiltration ability is largely depend on the size, thickness and properties of the
food.
b) Penetrability, microwave can penetrate through ceramics, glass, temperature-resistant plastics. It is
required to use the containers whose material have good microwave penetrability to achieve best heating
result. See the below utensils guide.
c) Reflectivity, microwave would be reflected by the metal wall of interior cavity so as to establish an even
magnetic field, thus can prevent the overheating of partial area.

Installation of microwave oven

1) To ensure sufficient ventilation, the distance of the back of microwave to the wall should be at least 10
cm, the side to the wall should be at least 5cm, the free distance above the top surface at least 20 cm.

2) Do not place any objects on the top of microwave oven.

3) The position of the oven shall be such that it is far from the TV, Radio or antenna as picture disturbance
or noise may occur.

4) The appliance must be positioned so that the plug is accessible.

5) The microwave oven is intended to be used freestanding and shall not be placed in a cabinet.

6) To keep the microwave oven at a distance from the wall, install the distance limiter as shown below.

Push Distance Limiter
in this direction

1)Push Distance Limiter in the given direction;

2)Make sure Clasp A is secured to Hole A;

Secure Clasp A to Hole A

Hole A

Clasp A

Hole A

Distance Limiter

3)Insert Clasp B and Clasp C into their respective square holes.

Clasp C

Clasp B

1

2

2

Utensils guideline

Before use check that utensils are suitable for use in microwave oven. Take the reference of below table. In
the table marked as “○“ is applicable, “ X ” is not applicable.
Material of container Microwave Grill Combination
Heat-resistant glass

○ ○ ○

Ceramic

○

X X
Ordinary glass X X X
Heat-resistant
plastic

○

X X

Ordinary plastic X X X
Thin Plastic film

○

X X
Metal Grill X

○ ○

Metal container X

○ ○
Note： In comb Function, only the shallow metal container can be used, and the metal container can never
be placed directly on metal grill. In such case, Glass plate is needed to sandwich between. And metal grill
shall not be placed so as to touch the wall of cavity as sparkle is liable to occur, never use tie-over jar.

For the first use

As there is manufacturing residue or oil remained on the oven cavity or heat element, it usually would smell
The door, even a slight smoke, it is normal case and would not occur af ter several times use, keep th e door
or window open to ensure good ventilation.
So it is strongly recommended to operate as follows
For the oven incorporate grill function, set the oven to grill mode and operate dry several times.Operating
dry can only be conducted in the grill mode, it can not be conducted at combination mode.

Product introduction

3

1) Door interlock ensure that microwave oven can only be activated when the door is properly closed.

2) Viewing Window cooking status can be viewed through metal mesh.

3) Rotating axis driving the glass turntable rotating

4) Rotating ring supporting the glass turntable

5)Turntable it turns to make food heated evenly when cooking, recommend

using it when cooking.

6) Control panel see below in details (the control panel is subject to

change without prior notice)

7) Grill rack used to place the roasting food

8) Wave guide cover (inside) Warning: never remove it during cleaning. See
fig.1

IMPORTANT SAFEGUARDS

The following basic precautions should always be followed when using electrical appliance:

1. Read all instructions before using.

2. Make sure the voltage in your living area corresponding to the one shown on the rating
label of the appliance. And the wall socket is properly grounded.

3. To reduce the risk of fire in the oven cavity:
a. Do not overcook the food.
b. Remove wire twist-ties from paper or plastic bags before placing bags in the oven.
c. Do not heat oil or fat for deep drying as the temperature of oil cannot be controlled.
d. After use wipe the waveguide cover with a damp cloth, followed by dry cloth to remove any
food splashes and grease. Built-up grease may overheat and begin to cause smoke or catch fire.
e. If materials inside the oven should smoke or ignite, keep oven door closed, turn oven off
and disconnect the power supply.

f. Close supervision is necessary when using disposable containers made from plastic, paper
or other combustible material.

4. To reduce the risk of explosion and sudden boiling:
a. Do not place sealed containers in the oven. Baby bottles fitted with a screw cap or teat are
considered to be sealed containers.
b. When boiling liquid in the oven, use the wide-mouthed container and stand about 20
seconds at the end of cooking to avoid delayed eruptive boiling of liquids.

c. Potatoes, sausage and chestnut should be peeled or pierced before cooking. Eggs in their
shell, whole hard-boiled eggs should not be heated in microwave ovens since they may
explode,even after microwave heating has ended.
d. The cooked liquid should not be removed out immediately. Several moments should be
waited before removing In order to avoid possible hazards caused by delayed eruptive boiling
of liquids.
e. The contents of feeding bottles and baby food jars are to be stirred or shaken and the
temperature is to be checked before consumption, in order to avoid burns.

5. Never operate the oven further if the door or door seals is damaged or the oven is
malfunctioned or supply cord is damaged. Return the appliance to the nearest authorised
service center for repair and maintenance. Never try to adjust or repair the oven yourself.

Fig.1