Haier D200 User Manual
Your Phone
Keys andFunctions
1
Earpiece
Display
Fourways NavigationKey
Right SoftKey
Power/End Key
OK/HotkeytoWAP
Keypad
Microphone
Charging Port
Front View
Send Key
Left SoftKey
VolumeSide Key
2
Screen Icons
Installing the Battery
1) Aim the protruding part at the bottom of the battery
at the groove of the phone.
2) Push the top part of the battery to the phone and
3
press down the lock until it is locked.
Switch off the phone, push up the lock at the top of the
battery to uplift the top of the battery and separate it
with the main board.
1) Make sure to switch off your phone before taking
out the battery.
2) Make the metal face of the RUIM card down and
put it conferring the level of the card.
3) Reinstall the battery.
1) Remove the battery after switching off your phone.
2) Remove the RUIM card.
3) Reinstall the battery.
Removing the Battery
Installing the RUIM Card
Removing the RUIM Card
4
Charging the Battery
Using the Function Menu
Menu
Making a call
1)Plug the charger transformer into a standard outlet.
2)Insert the charger output plug into charging
connector of the bottom of the phone.
3)The rolling of the electric quantity bar indicates that
the phone begins to charge.
4) When the battery level full and stop rolled, the
phone will display 'Battery full'.
5)After charging is complete, switch off the electric
supply and pull out the charger's jack.
1.In idle mode, press to display the interface.
2.Press to scroll to a menu item.
3.Press to display the menu.
4.Display the submenu in either of the ways:
Press to scroll to a submenu item and press
to display the submenu.
Press the number key corresponding to the number
of a submenu to display it.
5.Press to return to the previous menu or quit the
function menu.
Press to return to the idle screen.
1.Dialing
Select a desired entry from the names list or directly
type in the phone number in idle mode, press key
to dial.
2. Making an international call
5
Press and hold key until ‘+’ appears on screen.
3.Ending a call
You can end a call at any time by holding down the
key till the call has been terminated.
1.Press key or any key (need setting) to answer the
call.
Or press key [Silence] once to close incoming
ringer, press [Accept] again to receive the incoming
call.
2.Press key twice to reject the incoming call.
The phone lock code is used to protect your phone
from unauthorized use.
It can be set automatically to lock your phone each
time it is switched on or when in idle mode. In this
condition, you can only dial emergency call.
You must press key to enter correct phone lock
code, and then access the phone menu (The default
code is 000000).
You can set protection code (PIN code) in order to
prevent random using of your phone by others. Each
time you restart your phone, the phone will prompt you
Enter the country code, area code (without prefix
zero) and phone number.
Press key to dial.
Receiving a call
Phone Lock
PIN and PUK
6
Loading...