Haier CZ51023FRZ User Manual
HF-100
Freezer
UUSSEERR IINNSSTTRRUUCCTTIIOONNSS
Please read these instructions carefully before using this product and keep the
instructions safe for future reference.
Instruction booklet and Guarantee information
Adjustable front feet (if not already fitted)
Spanner for feet adjustment
Ice scraper
O Do read these instructions thoroughly before
using this appliance.
O Do install the appliance only in the vertical
position.
O Do stand for 12 hours to allow the cooling
gases to stabilise if transported in a horizontal
position.
O Do install to allow for adequate ventilation
around the appliance (see page 3).
O Do not install near heaters or other heat
sources.
O Do unplug before cleaning and maintenance.
O Do defrost regularly for maximum efficiency.
O Don’t install the appliance in humid or extreme
conditions.
O Don’t attempt to repair the appliance yourself
(see Helpline information – back page).
O This appliance is intended for domestic use only.
Only use it in accordance with the
manufacturer’s instructions.
O Don’t use any other electrical device inside the
appliance to defrost.
O Don’t store goods containing inflammable or
other explosive gases.
O Don’t leave door closed if appliance is left
switched off for long periods.
Page 2
Before Use
Do and Don’t
Page contents
Check the contents
Check the following contents are included with the product and and inspect the casing for any damage. If
there is any need, contact your retailer from whom you purchased the product.
After unpacking, wipe the casing with a dry cloth and clean the inside with a damp cloth ready for food
storage.
Packaging
The packaging is recyclable so dispose of it according to local regulations. Keep the packaging materials
out of reach of young children.
Warning
The freezer is heavy and care is needed when unpacking and
moving it. Get extra help and only hold it by the casing – not the
door or trim.
Before use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Do and Don’t . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Installation and controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Door reversal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Using the freezer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Maintenance and cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
Fuse and mains plug replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
Specification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .back cover
Safety measures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .back cover
After sales service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .back cover
Ice tray
Key for thermostat adjustment
3 plastic freezer baskets
1 superfreeze tray
The appliance is designed to operate at normal
room temperatures. Position it away from any heat
source such as a boiler, ovens and heaters which
will reduce the cooling efficiency of the freezer. It is
also not advisable to install the appliance in
unheated locations such as garages or
outbuildings, as these will impair the operation of
the freezer in winter.
The freezer requires space around the casing for
efficient cooling and operation. The minimum
clearances are shown in Figure 2.
The freezer must be installed on a firm flat and
level surface for it to work quietly and efficiently.
Keep the condenser tubes clear away from rear
wall or obstructions (Figure 1).
If the feet are not already fitted, screw them into
the two front corners of the bottom of the casing.
Fine adjustments can be made to level the
appliance by turning the feet to raise or lower with
the spanner supplied (Figure 3).
Switching on
Plug the freezer into a nearby power socket and
switch on.
Temperature control
Switch the freezer on for the first time and use the
key supplied, to turn the thermostat control to the
‘SF’ position on the dial (Figure 4). Leave the
freezer running with the door closed for
approximately 4 hours before storing food. (When
the thermostat is set to the Superfreeze position
(‘SF’ position). the freezer motor stays constantly
on.) Only use the ‘SF’ position for fast freezing
food, otherwise set the thermostat dial to a midway position.
It is advisable to place a freezer thermometer (not
supplied) inside the freezer to check that the
temperature is maintained at –18°C to –20°C.
Note: The setting on the thermostat control is
dependent upon room temperature. If the
temperature inside the freezer is above –18°C to
–20°C, adjust the thermostat control towards MAX.
Page 3
Installation and controls
Important
Make sure that the voltage marked on the rating label on the product corresponds with the voltage in your
home.
This quality product has been tested and certified to meet all applicable UK electrical and safety standards.
Diagrams show alternative methods of providing correct air
flow around the appliance.
FIGURE 1
CONDENSER
TUBES
THERMOSTAT
CONTROL
KEY
FIGURE 2
100mm
100mm
25mm
25mm
FIGURE 4
FIGURE 3
SPANNER
FOOT
Loading...