English
English
English
English
English
English
English
English
English
English
English
English
English
English
English
English
PREPARE UNIT
2
FOR
INSTALLATION-2
1. Remove the screws which fasten
the cabinet at both sides and at
the back.
2. Slide the unit from the cabinet
by gripping the base pan handle
and pulling forward while bracing
the cabinet.
3. Insert the Frame Guide into the
bottom of the cabinet.
Caution: Never expose plastic
front or grille to extreme
temperatures.
3
Install top rail with three 13/32"screws.
Slide left-hand curtain assembly
into left end of top and bottom
rails. Repeat for right-hand curtain
assembly. Fasten curtain retainer
strips to sides of outer case with
eight 13/32" screws.
ASSEMBLE
CURTAINS/TOP
RAIL
Shipping
Screws
PREPARE
4
WINDOW FOR
INSTALLTION
Inspect window track, sash, and sill
for its ability to support the weight of
air conditioner.
Measure width between window
moldings to ensure Instant Mount
will fit window frame. Instant Mount
models are designed for windows
wide (the detail see page 15)
Instant Mount kit supplied with unit
is designed for mounting in most
double-hung windows without
storm windows. For installation in
window frame with storm window,
modify sill by adding wood strips (not
included) to inner and outer sills. This
raises unit and eliminates
interference of storm window frame.
16
Storm window installation
If storm window frame does not allow
adequate clearance below sill (1/2"
required), remove storm window
frame or create clearance by adding a
wood strip (at least 1 1/2" wide) along
entire width of sill. Fasten wood strip
to sill with at least three countersunk
wood screws (not supplied with kit).
This provides a smooth surface for
mounting air conditioner.
1/2"
1 1/2"
Minimum
Wood
SILL
I
N
D
O
O
R
Storm Window
Frame
Stri p
Minimum
O
U
T
D
O
O
R
Mobile home window installation
Add wood strip (at least 1 1/2" wide)
along entire width of window sill.
Thickness of wood strip should match
height of front lip on window frame.
Fasten wood strip to sill with a
minimum of three countersunk wood
screws (not supplied with kit). This
provides a smooth surface for
mounting air conditioner.
Must be a minimum
of 1/2" to clear
bottom rail on unit
11/2"
Minimum
N
D
O
O
R
Wood
Strip
I
Window
Frame
O
U
T
D
O
O
R
INSTALL OUTER
5
CASE IN WINDOW
Place outer case in window. Lower
sash until it rests behind front flange
of top rail. Bottom rail must rest
behind window sill.
Top rail
Bottom rail
Curtain assembly cut
away for clarity.
About
5°
Expand both curtains to contact the
window frame. Attach each curtain
the window sash using 31/32" screws.
NOTE: To make screws easier to
drive, drill a pilot hole into sash
through clearance hole in curtains.
English
Use 3 screws(31/32") to fix the case to windows sash.
17
English
6
Install sash bracket on top of indoor window sash
with one wood screw 31/32" to prevent raising of
window from the outside. Screw anchor directly into
side of window frame. For hard wood or metal window
frames, drill a pilot hole to start screw.
Important:Be careful not to drill pilot hole too deep.
Add a piece of tape to the drill bit as a depth gauge.
Also stay clear of glass. Be careful not to damage the
function of the window.
Cut window seal gasket to width of window. Stuff window
seal strip between outdoor window glass and top of
indoor sash. This will stop air leakage which reduces
efficiency.
7
The base pan may overflow due to high humidity.
You must install the drain tube before using the
unit. Adjust the direction of the drain tube
to make it be in line with the hole in the rear of
unit; Insert the drain tube into the hole and twist
90¡ª. To drain the excess water to indicated
position, connect a drainpipe to the drain tube.
When pressing the drain tube or drainpipe into
place, apply force in the direction away from the
fins to avoid injuring yourself.
INSTALL SASH BRACKET
& SEAL GASKET
INSTALL
DRAIN TUBE
RETURN
8
CHASSIS TO
OUTER CASE
Find someone to help you
replace chassis in outer case.
Replace front panel, and grille.
(Don't forget to install the attachment
screws before replacing grille)
Caution:
For security purpose, reinstall
screws at cabinet's sides.
Important:
Because window
sash helps keep unit in window,
make certain window sash contacts
outer case before reinstalling chassis.
18
Care and Cleaning Guide
Always unplug your air conditioner before cleaning.
The air filter behind the inlet grille should be checked and cleaned at least
once every 2 weeks (or as necessary) to maintain optimal performance of
the air conditioner.
How to remove the air filter
1. The grille may be opened from the top for easy maintenance after installation.
2. Open the inlet grille by pulling off the exposed door on the top of the
unit(based on the installation).
3. Pull the tab slightly to release the filter. Pull the filter in the same direction
as the opening.
4. Clean the filter with warm, soapy water. The water should be below
o
C(104oF).
40
5. Rinse off and gently shake off excess water from the filter. Let it dry before
replacing it.
DO NOT use your air conditioner without the air filter in place.
English
To clean the front panels or the cabinet DO NOT use harsh
chemicals, abrasives, ammonia, chlorine, bleach, concentrated
detergents, solvents or metal scouring pads. Some of these chemicals
may dissolve, damage and/or discolor your air conditioner.
Always use a soft cloth dampened with water or mild soap
and water solution to wipe the front of the cabinet.
Wipe dry with a soft cloth.
19
English
TroubleShooting
To store your air conditioner, after the season, remove the unit from the
window as per the installation guide. Repack the unit in its original box
and store away. If your unit is installed in a wall or you do not intend to
remove it from the window then cover the outside with a winter cover.
This can be purchased from the retailer where you purchased your
air conditioner or from your local hardware store.
Before putting away your unit make sure any water left in the pan is
removed and drained away'. Water left in the pan could lead to Rusting
or damage to the electrical connections.
If air conditioner does not operate:
Check if unit is plugged in. The plug may have come loose.
Check if the unit is in "Off" mode.
Air from air conditioner is warm:
The COOL setting may need to be raised.
Ice formation on cooling coils:
Outside temperature too cold. Set the unit on fan only
setting to defrost ice.
Lower temperature setting. Temperature setting may be too cold,
Unit BTU may be too high for the room.
20
English
Air conditioner working but room not cooling:
Room may have appliances that produce heat. Use an exhaust fan to
remove excess heat.
Redirect the airflow Remove any obstacles.
Al doors and windows need to be closed so cool air does
not escape the room.
Air filter may need cleaning.
Unit BTU may be too low for the required cooling area.
On extreme hot & humid days air conditioners may take
a little longer to cool
Vent may be in the open position. Vent has to be closed for
optimum cooling.
Air conditioner is making noise when cooling:
You may hear sounds of air movement, water, compressor clicking on and
off or window vibrations. Read Operating Guide- Normal Operating
Sounds. (See page 8)
Water in the air conditioner cabinet:
This is normal as your air conditioner not only cools but also dehumidifies
the air. If there is water dripping inside the room, check the installation of
the unit. The unit may need to be reinstalled. (See page 17)
21
English
ROOM AIR CONDITIONG AND DEHUMIDIFIER PRODUCTS
Limited Warranty
What is covered and for how long?
This warranty covers all defects in workmanship
or materials for a period of:
12 months for labor
12 months for parts (Functional Parts Only)
5 years for sealed system
The warranty commences on the date of item purchase.
Customer shall provide Amana with proof of the date of
purchase, brand, model and serial number for verification
prior to any warranty service being provided.
EXCEPTIONS: Commercial or Rental Use warranty
90 days for labor
90 days for parts
No other warranty applies
What is covered/Not covered?
1. The mechanical and electrical parts of the appliance
which serve the functional purpose of this appliance are
covered for a period of 12 months. This includes all parts
except finish and trim.
2. Manufacturing defects to the components of the sealed
system (e.g. hermetic compressor, condenser and
evaporator) are covered for a period of 5 years from the
date of purchase. Any damages to such components caused
by mechanical abuse, improper handling or shipping will
not be covered.
3. The limited warranty does not cover any credit or refund
for any loss or injury caused by the product or defects to
the product including but not limited to incidental or
consequential damages.
What will be done?
1. Any mechanical or electrical part that proves to be
defective in normal usage during the specified warranty
period will be repaired or replaced at Amanas discretion.
A&E factory service is the authorized service provider for
Amana.
If it is determined that repair is not appropriate or
replacement part is unavailable for repair, Amana will
exchange the product with a refurbished or new product
the same or similar to the original at its discretion.
2. There will be no charge to the purchaser for functional
replacement parts and labor on any covered items during
the initial 12- month period. Beyond this period, only the
components of the sealed system are covered, labor is not
provided and must be paid for by the customer.
3. To have your product serviced, please contact Amana
customer service 1-888-842-2440.
THIS WARRANTY COVERS
APPLIANCES WITHIN THE
CONTINENTAL UNITED STATES,
PUERTO RICO AND CANADA.
IT DOES NOT COVER
THE FOLLOWING:
Damages from improper installation.
Damages incurred during shipping.
Defects other than manufacturing.
Damage from misuse, abuse, accident,
alteration, lack of proper care and
maintenance or incorrect current or
voltage.
Damage from other than household use.
Damage from service by other than an
authorized dealer or service center.
Decorative trims or replaceable
light bulbs.
Transportation and shipping.
Labor (after the initial 12 months).
Credit or Refund for products over 30 days past date of
purchase
Food loss for food spoiled as a direct result of mechanical
failure of the product or of any delay in providing service,
repair, replacement.
This limited warranty doesnt apply to refurbished product
or unit purchased as/like new or second-hand.
THIS LIMITED WARRANTY IS GIVEN IN
LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR INCLUDING THE
WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR
PURPOSE
The remedy provided in this warranty is
exclusive and is granted in lieu of all
other remedies.
This warranty does not cover incidental
or consequential damages, so the above
limitations may not apply to you. Some
states do not allow limitations on how
long an implied warranty lasts, so the
above limitations may not apply to you.
This warranty gives you specific legal
rights, and you may have other rights,
which vary from state to state.
For more information on this and other Amana
products, call Customer Affairs Department at:
1-888-842-2440
CONSUMER INFORMATION LINE
Amana Toll-Free
1-888-842-2440
(Not a technical assistance line for dealers.)
22
Loading...