Page 1
0090504484
29F9B-P
29T9B-P
Colour Television
Operation Instructions
MAIN FUNCTION
◆218 Programmes stored
◆Dynamic noise reduction
◆Multi-picture modes, multi-sound modes selection
◆Auto-correcting black balance
◆Surround stereo
Page 2
CONTENTS
WARNING AND CAUTIONS...............................................................................................................1
BASIC FEATURE..................................................................................................................................2
TECHNICAL SPECIFICATION............................................................................................................2
FUNCTION BUTTONS AND EXTERNAL SOCKETS.......................................................................3
REMOTE CONTROLLER BOARD......................................................................................................5
OPERATION MENU..............................................................................................................................6
MULTI FUNCTION TIMER.................................................................................................................10
PROGRAM NUMBER EXCHANGE...................................................................................................11
GENERAL OPERATION.......................................................................................................................12
EXTERNAL CONNECTIONS...............................................................................................................14
TROUBLESHOOTING GUIDE.............................................................................................................15
Page 3
WARNING AND CAUTIONS
BASIC FEATURE
1. When you clean the TV set, please pull
out the power plug from AC outlet.
Or may result in electric shock, fire or
damage to the TV set. Don't clean the
cabinet and the screen with benzene,
petrol and other chemicals.
2. In order to prolong the using life of the
TV set, please place it in a well ventilated
location.
3. Don't place the
TV set in direct
sunlight or near
heat source.
4. Do not place the TV set near rain
or moisture as it may cause an electric
shock, or the TV set to catch fire. The TV
set must only be used
in dry indoor location.
5. The back cover must only be removed
by a registered electrical service person.
Removing the back cover may result in
electric shock, fire or damage to
the TV set.
6. If the TV set is not going to be used for
long time, or there is a severe thunder &
lightening storm, it is recommended that
the TV set be disconnected from the AC
power outlet and the aerial plug
removed.
●218 programs stored
●Auto-correcting black balance
●Surround stereo
●Blue extension, green improvement
●Multi-picture modes and multi-audio modes
●Audio/Video input, S-Video input
●DVD component input
TECHNICAL SPECIFICATION
POWER SUPPLY: See rating plate
TV SYSTEM: B/G D/K
COLOUR SYSTEM: PAL SECAM NTSC3.58/4.43 (AV)
CRT: 29"
AERIAL INPUT IMPEDANCE: 75Ωunbalanced
VIDEO INPUT: 1.0VP-P(75Ω)
AUDIO INPUT: 436mVrms(40KΩ)
VIDEO OUTPUT: 1.0VP-P(75Ω)
AUDIO OUTPUT: 436mVrms(>600Ω)
AUDIO MAX OUTPUT POWER: 5W+5W
POWER CONSUMPTION: See rating plate
NET WEIGHT(kg): 29F9B 46
29T9B 44
NET SIZE(mm): 810 x 530 x 600
Explanation on the display tube
When the picture tube requires cleaning, please disconnect the power and use
a dry soft cotton cloth. Do not use any cleaner or abrasive cloth.
1 2
Supplied accessories:
Infrared remote control handset 1
Battery(AA) 2
Operating instructions 1
Design and specifications are subject to change without notice.
Page 4
FUNCTION BUTTONS AND EXTERNAL SOCKETS
Antenna Connection
Connect an antenna to the antenna socket on
Antenna
Figure A Figure B
75-300Ω
Antenna adapter
Antenna cable
with a plug
Figure C
Coaxial cable(75Ω) twin-lead cable(300Ω)
Antenna feeder
Figure D
the TV set,we recommend using a Cable TV
system for better picture and audio quality.
1.If you use a coaxial cable(75 ),insert the
Ω
antenna plug (see figure C) into 75 socket
(see figure A).
2.If you use a twin-lead cable(300 ),please
Ω
shape the cable as figure D,and connect the
leads to antenna adapter and then insert the
antenna adapter into the 75 socket.(see
Ω
figure B)
Power source wire connection
Insert the power plug into AC outlet.
To install and to replace batteries of the remote
control unit
1.Place the remote control unit with the face
down, then open the battery cover of the unit.
2.Place the two"AA"size batteries, matching
the + and - signs on each battery to the +
and -signs of the battery compartment.
3.Close the cover of the battery compartment.
NOTE:
(1)Don't drop or wet or dismantle the unit.
(2)If you don't intend to use the unit for a
long period or the electricity of the
batteries is used up, remove the batteries
to prevent batteries acid from leaking into
the battery compartment.
(3)Always replace both batteries at the same
time.
(4)Do not use rechargeable batteries (Ni-cd)
or mix battery types.
(5)Never place batteries in a fire. Dispose
of the batteries with your domestic
rubbish collection.
Ω
FUNCTION BUTTONS AND EXTERNAL SOCKETS
1.Front Panel
TV/ AV
MEN U
V-
V+ P- P+
(3)
(7)
(6)
(5)
(4)
(1)Remote sensor: let the remote controller aim here the set can receive remote
control signal.
(2)Power switch: press the button to turn on the TV set . Press the button again to turn
off the TV set.
(3)Power indicator: the indicator lights in standby status ,the indicator lights in sleep
status . The indicator glints when you use remote controller.
(4)Menu button
(5)Program up/down button
(6)Volume up/down button
(7)TV/AV
2.Rear Panel and Side Panel
AV IN1
AUDIO-R
AUDIO-L
VIDEO
AUDIO-R
AUDIO-L
VIDEO
(10)
(8)S-video input
Y
(9)Video input/output
(10)DVD component input
(11)Antenna input
(12)Audio input/output
(9)
OUT
IN
VIDEO
(1)
(2)
Cb
L AUDIO R
Cr
(11)
S-VIDEO
(8)
(12)
3 4
Page 5
REMOTE CONTROLLER BOARD
OPERATION MENU
MARK
S A
S N
LOC
C
A
K
TE
U
M
C
FUNCTION DESCRIPTION
N
PROGRAM SCAN
STANDBY
M N
C
H
P
E U
F
.
P
H
U T
3
6
9
I
-
I
I
S
+C
V
-
N
C IO T N
ZOOM
C
A
E
X
T V
V A
/
.ST
O
L
+
S A
W
N
E
SWAP
L
L
I
T
M
Z
O
C
TV/AV
D
-VOL+
-CH+
PICTURE
SOUND
P
U
TIME
FUNCTION
0-9
-/--
MENU
E
I-
P
S
.
S
TU
O K
L
SWAP PROGRAM BETWEEN THE PRESENT AND THE LAST
U
A
MUTE
T
E
O
M
Z
O
O
M
I L
L
S AYD
L
P
TV/VIDEO SELECTION
VOLUME CONTROL
CHANNEL NUMBER UP/DOWN
PICTURE MENU
SOUND MENU
TIME MENU
FUNCTION MENU
ONE DIGIT SELECTION
ONE OR TWO OR THREE DIGITS PRE-SELECTION
MENU DISPLAY
X
S.
EXIT MENU DISPLAY
I
T
INVALID BUTTON
I
I
PICTURE MODE SELECTION
TD
T
D
SOUND MODE SELECTION
TUNE MENU SELECTION
N
E
C
CHILD LOCK
-
P
P
I
CT
S
O
1 2
4
5
7 8
/
-
-
.
ST
D
VO
U
RE
U
N
D
T
0
L
-
I E
M
NOTE：
The function of selecting menu button on the remote controller is
the same as that of program up/down button on the TV set.
The fuction of identifying menu button on the remote controller
is the same as that of volume up/down button on the TV set.
Setting Channel
1.Entering and exiting menu
Press MENU button on the remote controller once (or directly
press PICTURE button on the remote controller),PICTURE
menu displays on the screen; press MENU button
twice (or directly press SOUND button on the remote
controller), SOUND menu displays on the screen.
Press the menu button again (3 times, or directly press
TIME button on the remote controller), TIME menu displays
TUNE
COLOUR AUTO
SOUND B/G
BAND VHFL
SKIP OFF
PROGRAM 19
SEARCH
FINE TUNE
AUTO SEARCH
on the screen. Press the menu button again (4 times, or directly press FUNCTION button on the
remote controller), FUNCTION menu displays on the screen. Press the menu button again (5
times or directly press TUNE button on the remote controller), TUNE menu displays on the
screen. Press the menu button again (6 times), EXCHANGE menu displays on the screen .To
turn off the on-screen menu display, either press the EXIT button or allow the TV set to
automatically turn off the menu by not pressing any button for a few seconds.
2.Auto search
A. Press MENU button five times continually (or directly press TUNE button on the remote
controller), e
nsure that the TUNE menu is displayed. Press the CH+/- buttons to select
AUTO SEARCH. Then press the VOL+ button, the TV set will begin to search programs
from present programme No..
B. After the search has finished, the TV set will return to the first program that is stored.
3.Search
Press MENU button five times continually (or directly press TUNE button), ensure that the
TUNE menu is displayed. Press the CH+/- buttons to select SEARCH. Then press the VOL+
button to search up or VOL- button to search down to the next TV station.(It is much faster to
search up.) If the wrong station is found, press the search button again. You may need to
repeat this until the correct station is located. To store the new program, press the EXIT
button.
4.Fine tune
If the picture or sound is poor, try to use the "FINE TUNE" feature. Select the
FINE TUNE by using the CH +/- buttons. Use the VOL +/- buttons to fine tune the
sound and picture for optimum results. Then press the EXIT button to store the
results. Do not use this feature unless reception is poor.
5.Selecting the sound system
Press the CH+/- buttons to select SOUND item. Then press the VOL+/- buttons to select a sound
system you need.
6.Selecting color system
Usually this should be set in the auto position. However if the colours displayed on
the screen are incorrect you can manually select the correct colour system. When
you have finished remember to turn it back to auto again so that other programs
will still work correctly. Use the CH+/- buttons to select COLOUR then the VOL+/ buttons to select a color system you need. Press the EXIT button to save the setting.
5 6
Page 6
TROUBLESHOOTING GUIDE
To assist in location possible faults use help guide below:
BREAKDOWN PHENOMENON
PICTURE
Picture with Snow
Double or Triple Image
Disturb
Normal
No Picture
SOUND
Noise
Normal
Noise
No Sound
No Sound
the aerial direction and connection
This is called ghosting which can be minimized
with an outside aerial, and good quality cable
and terminations. Altering the aerial direction
can also minimize this effect.
Electrical interference which can be caused by
cars, motorbikes etc, fluorescent lamps and
dirty insulators on overhead power cables.
volume、sound mute
Ensure that the power supply is connected to
the TV set and turned on. Also ensure that the
TV set is not in "Listen Mode" or that the
brightness and contrast are not turned down.
CHECKING
adjust color control
No Color
Normal Volume
adjust channel again
Scramble
Color Spot
Note:
1.If the fault can not be repaired by using above guide consult with your local authorized service center.
2.The TV set must only be repaired by a qualified registered service person. Never attempt
to remove the back cover as the TV set has dangerous voltages in side that may cause a fatality or fire.
3.The cabinet may produce the occasional "snapping sound" This is normal and caused by
the materials in the cabinet expanding with room temperature changes.
Normal or Weak Volume
Normal Volume
Colour purity fault which can be caused by moving
the TV set, placing magnets near the TV screen or
turning on/off house hold appliances such as
vacuum cleaners near the TV set. Turn the TV off
with the mains power switch for 15 minutes.
When the power is turn on again the TV set will
automatically degauss the picture. In server cases
leave the TV set turned off over night.
15
Loading...