Haier 1050, HSU-09LH13 User Manual

SPLIT TYPE ROOM AIR CONDITIONER

OPERATION MANUAL

HSU-09LH13
HSU-12LH13

Please read this operation manual before using the air conditioner

No.001050

Cautions

Disposal of the old air conditioner

Before disposing an old air conditioner that
goes out of use, please make sure it's inop­erative and safe. Unplug the air conditioner
in order to avoid the risk of child entrapment.

It must be noticed that air conditioner system
contains refrigerants, which require speciali­zed waste disposal. The valuable materials
contained in an air conditioner can be recycled
.Contact your local waste disposal center for
proper disposal of an old air conditioner and
contact your local authority or your dealer if
you have any question. Please ensure that
the pipework of your air conditioner does not
get damagedprior to being picked up by the
relevant waste disposal center, and contribute
to environmental awareness by insisting on an
appropriate, anti-pollution method of disposal.

Disposal of the packaging of your
new air conditioner

All the packaging materials employed in the
package of your new air conditioner may be
disposed without any danger to the
environment.

The cardboard box may be broken or cut into
smaller pieces and given to a waste paper
disposal service. The wrapping bag made of
polyethylene and the polyethylene foam pads

contain no fluorochloric hydrocarbon.

All these valuable materials may be taken to
a waste collecting center and used again after
adequate recycling.

Consult your local authorities for the name
and address of the waste materials collecting
centers and waste paper disposal services
nearest to your house.

Safety Instructions and Warnings

Before starting the air conditioner, read the
information given in the User's Guide caref­ully. The User's Guide contains very impor­tant observations relating to the assembly,
operation and maintenance of the air
conditioner.

The manufacturer does not accept respon­sibility for any damages that may arise due
to non-observation of the following
instruction.

Damaged air conditioners are not to be
put into operation. In case of doubt, consult
your supplier.

Use of the air conditioner is to be carried
out in strict compliance with the relative
instructions set forth in the User's Guide.

Installation shall be done by professional
people, don't install unit by yourself.

For the purpose of the safety,the air con­ditioner must be properly grounded in acco­rdance with specifications.

Always remember to unplug the air
conditioner before openning inlet grill. Never
unplug your air conditioner by pulling on
the power cord. Always grip plug firmly and
pull straight out from the outlet.

All electrical repairs must be carried out
by qualified electricians. Inadequate repairs
may result in a major source of danger for
the user of the air conditioner.

Do not damage any parts of the air
conditioner that carry refrigerant by piercing
or performating the air conditioner's tubes
with sharp or pointed items, crushing or
twisting any tubes, or scraping the coatings
off the surfaces. If the refrigerant spurts
out and gets into eyes, it may result in
serious eye injuries.

1

Cautions

Do not obstruct or cover the ventilation
grille of the air conditoner.Do not put fingers
or any other things into the inlet/outlet and
swing louver.

Do not allow children to play with the air
conditioner.In no case should children be
allowed to sit on the outdoor unit.

Specifications

The refrigerating circuit is leak-proof.

The machine is adaptive in following
situation

1.Applicable ambient temperature range:

32oC/23oC
18oC/14oC

43oC/26oC
18oC

27oC
15oC

24oC/18oC

-7oC/-8oC

Cooling

Heating

Indoor

Outdoor

Indoor

Outdoor

Maximum:D.B/W.B
Minimum:D.B/W.B

Maximum:D.B/W.B
Maximum:D.B

Maximum:D.B
Maximum:D.B

Maximum:D.B/W.B
Minimum:D.B/W.B

7. The appliance is not intended for use
by young children or infirm persons
without supervision.

8. Young children should be supervised
to ensure that they do not play with
the applience.

9.Please employ the proper power plug,
which fit into the power supply cord.

10 .The power plug and connecting cable
must have acquired the local attestation.

2. If the power supply cord is damaged, it
must be replaced by the manufacturer
or its service agent or a similar qualified
person.

3. If the fuse of indoor unit on PC board is
broken,please change it with the type of
T. 3.15A/ 250V.

4. The wiring method should be in line with
the local wiring standard.

5. After installation, the power plug should
be easily reached.

6. The waste battery should be disposed
properly.

2

Cautions

Safety Instruction

Please read the following Safety Instructions carefully prior to use.

The instructions are classified into two levels, WARNING and CAUTION according to
the seriousness of possible risks and damages as follows. Compliance to the
instructions are strictly required for safety use.

Installation

WARNING

Please call Sales/Service Shop for the Installation.

Do not attempt to install the air conditioner by yourself because improper works
may cause electric shock, fire, water leakage.

lnstallation in a inadequate place may cause accidents. Do not install in the following place.

CAUTION

Connect the earth
cable.

earthing

Do not install in the
place where there is
any possibility of
inflammable gas
leakage around the
unit.

PROHIBITION PROHIBITION

Do not get the unit
exposed to vapor
or oil steam.

3

Check proper
installation of the
drainage securely

STRICT
ENFORCEMENT

Cautions

When abnormality such as burnt-small found,
immediately stop the operation button and
contact sales shop.

WARNING

Use an exclusive power source with a
circuit breaker

OFF

Connect power supply cord
to the outlet completely

STRICT

ENFORCEMENT

Do not use power supply cord
in a bundle.

PROHIBITION

Do not start or stop the
operation by disconnecting
the power supply cord and so on.

PROHIBITION

Do not use for the purpose of storage of
food, art work, precise equipment,
breeding, or cultivation.

STRICT

ENFORCEMENT

Use the proper voltage

STRICT

ENFORCEMENT

Take care not to damage

the power supply cord.

PROHIBITION

Do not channel the air flow directly
at people, especially at infants or
the aged.

PROHIBITION

CAUTION

Take fresh air occasionally especially
when gas appliance is running at the
same time.

Do not use power supply cord

extended or connected in halfway

PROHIBITION

Do not insert objects into the air
inlet or outlet.

PROHIBITION

Do not try to repair or reconstruct
by yourself.

Do not operate the switch with
wet hand.

PROHIBITION

Do not install the unit near a fireplace
or other heating apparatus.

PROHIBITION

Do not place animals or plants in
the direct path of the air flow

PROHIBITION

STRICT

ENFORCEMENT

Check good condition of the
installation stand

PROHIBITION

Do not place any objects on or
climb on the unit.

PROHIBITION

4

PROHIBITION

Do not pour water onto the unit
for cleaning

PROHIBITION

Do not place flower vase or water
containers on the top of the unit.

PROHIBITION

Parts and Functions

Indoor unit

Display board

Inlet

Anion generator

(inside)

Vertical flap

(Use remote controller to
adjust up and down air flow.
Don't adjust it manually)

Horizontal louver

(adjust left and right air flow)

Actual inlet grille may vary from the one shown in the manual according to
the product purchased

Air filter

(inside)

Inlet grille

Outdoor unit

1
2

OUTLET CONNECTING PIPING AND ELECTRICAL WIRING

INLET DRAIN HOSE

3
4

5

Parts and Functions

19

18 2434 16 17

9. HEALTH button

Used to set healthy operation.

10. ON/OFF button

Used for unit start and stop.

11. TIMER ON display

12. FAN SPEED display

LOW HI

13. LOCK display

FRESH

28

14. SWING UP/DOWN display

15. SLEEP display

16. HEALTH display

STERILIZE

33

17.FRESH AIR display

18. Operation mode display

Operation mode

Remote controller

Display board

19.Singal sending display

20. UV light degerming function display

21. Left/right air flow display

22. TEMP display

Remote controller: to display the TEMP. setting.

23. TIMER OFF display

1.CODE

Used to select CODE A or B with a press,A or B
will be displayed on LCD.
Please select A without special explanation.

2.RESET

When the remote controller appears abnormal,
use a sharp pointed article to press this button
to reset the remote controller normal.

3.LIGHT button

Control the lightening and extinguishing of
the indoor LCD display board.

4. TIMER button

Used to select TIMER ON, TIMER OFF,
TIMER ON-OFF.

5. CLOCK button

Used to set correct time.

6. SLEEP button

Used to select sleep mode.

7. MODE button

AUTO COOL DRY FAN

8. HOUR button

Used to set clock and timer setting.

NOTE:(1) The following functions and related displays are not available:

(2) Cooling only unit do not have functions and displays related with heating.

24. CLOCK display

25. TEMP button

Used to select your desired temperature.

26. FAN button

Used to select fan speed: LOW,MED, HI, AUTO.

27. HEALTH AIRFLOW button

Used to set the health airflow mode.

28. SWING UP/DOWN button

Used to select up or down air sending direction.

29. SWING LEFT/RIGHT button

Used to select left/right air flow.

30.

FRESH

Use to set fresh air function.

31. SET button

Used to confirm timer and clock settings.

32. STERILIZE button

Use to set UV light degerming function.

33. LOCK

Used to lock buttons and LCD display. If pressed, the
other buttons will be disabled and the lock condition
display appears. Press it once again, lock will be
canceled and lock condition display disappears.

34. Ambient temp.display

To display the Ambient temp.

MED AUTO

AUTO FANCOOL DRY

button

30

1

20

31

6

Parts and Functions

Clock Set

When unit is started for the first time and after replacing batteries in
remote controller, clock should be adjusted as follows:

1. Press CLOCK button,"AM" or "PM" flashes.

2. Press or to set correct time. Each press will increase or decrease
1 min. If the button is kept depressed, time will change quickly.

3. After time setting is confirmed, press SET, "AM" or "PM" stop flashing,
while clock starts working.

Remote controller's operation

When in use, put the signal transmission head directly to the receiver hole on the indoor unit.

The distance between the signal transmission head and the receiver hole should be within
7m without any obstacle as well.

Don't throw or knock the remoter controller.

When electronic-started type fluorescent lamp or change-over type fluorescent lamp or
wireless telephone is installed in the room, the receiver is apt to be disturbed in receiving
the signals, so the distance to the indoor unit should be shorter.

FRESH

STERILIZE

Loading of the battery

Load the batteries as illustrated right
2 R-03 (7#) batteries

Remove the battery cover:

Slightly press" "area and push down the cover
as illustrated.

Load the battery:
Be sure that the loading is in line with the "+" / "-".

request as illustrated on the bottom of the case.
Put on the cover again.

Confirmation indicator:

After pressing power ON/OFF, if no display, reload the batteries.
Note:

Full display or unclear display during operation indicates the batteries have been used up.
Please change batteries.

Used two new same-typed batteries when loading.

If the remote controller can't run normally during operation, please remove the batteries and
reload several minutes later.

Hint:

Remove the batteries in case unit won't be in usage for a long period. If there are any display
after taking-out, just need to press reset key.

7