ZD0675 issue 3ZD0675
Invicta 3
GB
JK1***B
JK2***B
Notice d’instructions
User instructions
Bedienungsanleitung
Instrucciones de uso
Instruções
Bruksanvisning
Gebruiksaanwijzing
All product(s) must be installed by a suitably competent electrician
giving consideration to their intended use and in accordance with the
current edition of BS 7671 (IET Wiring Regulations).
Pozidrive PZ2
2.5
2.5mm
The Electricity at Work regulations and the Health and Safety at Work
Act shall be complied with.
Only equipment and arrangements specied in Hager’s technical
documentation / catalogue shall be used
Install in the vertical plane only.
Notice:
To prevent potential overheating from loose connections the installer
shall check connections are tightened to the torque levels stated in
these instructions prior to energising this board. This check should
include factory made connections which may have loosened in transit.
Pozidrive
PZ2
ZD0675 issue 31
Pozidrive
2.5mm
PZ2
Points with central
‘easy t’ xing point
Removal of gland plate
Pozidrive
PZ2
Cut tabs and remove insert
when using gland larger
than 32mm
Drill centre mark provided when tting SWA or conduit
Use product carton / packaging to reduce the swarf when
removing end plate section
Cable protection
built into end plate
for trunking entry
2 ZD0675 issue 3
Loading...