hager 3300 Series, I-LS02282 Instructions Manual

3300 Series Grade 3 Leverset

PURPOSE: To illustrate how to change the face plate on the 3300 latch bolt.

TOOLS: Flat Blade Screwdriver

NOTE: The latch bolt comes with the round corner face plate attached and square corner loose in the box.

STEP 1

Carefully pry off the round corner face plate by inserting the flat blade of the
screwdriver between the mounting bracket and face plate in the location shown
below.

While holding the latch, twist the screwdriver to pry the face plate off the mounting
bracket.

Repeat Step on opposite side to free the face plate.

Latch Bolt Face Plate Change Instructions
I-LS02282

Rev -, Rev Date: 3/28/18 Page 1 of 2

Hager Companies 139 Victor Street, St. Louis, MO 63104 [phone] www.hagerco.com

3300 Series Grade 3 Leverset

STEP 2

Install new face plate making sure the posts on the back of the face plate fit
through the holes of the mounting bracket as shown below.

NOTES:

 After prying off the face plate, the new face plate will not snap tight to the

mounting bracket. The new face plate will attach to the mounting bracket in
Step 3.

STEP 3

Mount the latch, placing the mounting bracket, face plate, and screws as shown
below. When the fasteners are screwed into the frame, everything will be held
tightly in place.

NOTE: Make sure the mounting bracket is oriented as shown below before
installing the face plate and screws.

CORRECT INCORRECT

Latch Bolt Face Plate Change Instructions
I-LS02282

Rev -, Rev Date: 3/28/18 Page 2 of 2

Hager Companies 139 Victor Street, St. Louis, MO 63104 [phone] www.hagerco.com