Hafele EN 237.56.004 User Manual

EFL1 Furniture Lock

Item No.: 237.56.000, 237.56.002, 237.56.004

Mounting Instructions

2

Areas of application:

The Dialock furniture locking (EFL1) locks are used for the electro-mechanical locking of
cabinets, drawers, doors, etc.

Supplied with:

1. AMP connector (supplied, but not connected to the EFL1 lock case)

2. EFL1 lock with power cable

3. Fixing Plate

4. Locking Bolt

NOTE:

Drill jig, Article No. 237.56.990, must be ordered separately.

Technical Information:

The EFL1 lock is controlled via a Multi Output Terminal with output extender.
Up to 128 EFL1 locks can be controlled by means of one single terminal.
Simple applications can also be employed with the wall terminal control.

Technical Data:

Power Supply 12VDC
Continuous Current 50mA
Consumption
Tensile Load > 200 N, acc to DIN 68 852 or 90 kg force

3

Installation:

Tools needed:

• Phillips or #2 screwdriver

• Marker or pencil

• Screws:

- Wooden cabinet and door: 4 #6 wood screws (ø 3.5mm x Xmm, depending on
the thickness of the cabinet)

- If otherwise: corresponding screws, e.g. self-tapping screws with metal cabinets

• Drill Jig

• Power Supply, Article No. 917.93.004 or .005

Pre-conditions:

• Door width with inset doors: minimum 240 mm

• Door width with overlay doors: minimum 240 mm

Recommendation:

• With cabinet doors: use self-closing hinges

• With drawers: use self-closing drawer slides

1. EFL1 lock

2. Drilling Jig

3. Fixing Plate

4. Locking Bolt

1. Position drilling jig and EFL1 lock

If the locking bolt is inserted in the EFL1 lock:

• Connect the power supply and remove the locking bolt from the EFL1 lock by pulling it out.

2. Put the drill jig on the EFL1 lock.

4

1. Pins of the Drill Jig

2. Place the EFL1 lock at the cabinet inside of the corresponding piece of furniture using
the drill jig.

• With overlay doors: adjust the drill jig so that it is flush with and parallel to the front
edge of the cabinet.

• With inset doors: position the EFL1 lock to the inside by the dimension of the door
thickness. Put the drill jig in such a manner that it is positioned parallel to the cabinet
edge.

• Doors with stoppers: in addition position the EFL1 lock to the outside by the
thickness dimension of the stoppers.

3. Use the marker or pencil to mark the screw holes.

4. Use 2 #6 wood screws (ø 3.5mm) to secure the EFL1 lock to the furniture cabinet.
For adjustment, leave the drill jig in position on the cabinet panel.

5. Push the door against the placed drill jig. The screw holes for the installation of the
fixing plate of the locking bolt are marked by the drill jig.