Re: Certification for Hafele DMT 32 Transmitter
Model: DMT 32
FCC ID: PW3107
USER'S MANUAL INFORMATION
(PRELIMINARY)
The User's Manual is in preparation. The following material will be contained in the
manual:
FCC ID: PW3107 CANADA: to be provided by IC
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry
Canada. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
WARNING: Changes or modifications not expressively approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Technical information
All safes are supplied in the basic method of operation.
In this method of operation, locking authorisations can be allocated to
personnel keys directly at the safe with a special programming key stick
(green). The locking authorisations are withdrawn again directly at the
safe with a clearing key stick (red).
Guest keys are authorised via the software Hotel.
The configuration takes place when the system is initiated.
Technical data:
weight
TM3
TM4
thickness of steel material
thickness of front plate and
door
safety level
number of locking bolts
Mounting instructions
13 kg
19 kg, with removable shelf (sheet steel)
2 mm, single walled
6 mm
A according to VDMA, norm 24992
2
engl. 9