Hafele America 102 Users Manual

LockerLock Mounting Instructions and Operation, Simple Mode

NOTICE: Any changes or modifications made to the LockerLock will void the user’s authority to operate this
equipment in compliance with FCC regulations.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the
receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on
a circuit different from that to which the receiver is connected. Consult the factory or an experienced radio/TV
technician for help.

Set-up:

Set-up of the Dialock LockerLock unit begins with unpacking and inspecting the
unit. Remove and discard the box and packing material. Inspect the unit and all
other components for obvious signs of damage. Contact the dialock department
for questions or problems. The following list includes the article numbers along
side the components packed in the set:

• 1 – LockerLock Set Tiris, 231.80.000

• 1 – LockerLock Label, Silver, Blank, 231.81.100

• 1 – LockerLock Instructions Label, Silver, 231.81.200

• 2 - LockerLock Cover Plug, 231.80.200

Hafele America Co. 1 Document No.: DIA.DPR.013
Dialock Dept. Document Date: 12/17/2001
[phone] Print Date: 2/8/2002

Installation:

Begin by locating and removing the battery cover from the bottom of the
LockerLock assembly. This component should be partially detached straight out
of the box. Choose the correct mounting diagram for preparing the door for
installation (see figures 1, 2, and 3 for typical application drawings).

Hafele America Co. 2 Document No.: DIA.DPR.013
Dialock Dept. Document Date: 12/17/2001
[phone] Print Date: 2/8/2002

Figure 1 Inset door application utilizing a mortised recess and strike plate for

securing the deadbolt.

Hafele America Co. 3 Document No.: DIA.DPR.013
Dialock Dept. Document Date: 12/17/2001
[phone] Print Date: 2/8/2002