Plasma Table Attachment
The plasma cutting attachment has been designed to easily mount to just about any welding table or welding bench.
The design allows for you to choose how you want to mount the attachment, by either side mounting to a 3D
welding table or surface mounting to a 1D welding table / work bench, the choice is yours.
It is supplied standard with 3 mounting arms that are laser cut from 6mm steel plus 8 pieces of 40 x 3mm sacricial
vertical supports, these vertical supports are easily replaced with 40 x 3mm at bar. The cutting area is approximately
460 x 745mm but the width can be easily adjusted by purchasing 40 x 3mm at bar & cutting to your desired length.
Parts list
Please check that you have all the below parts before you assemble this product
Part Image
A. Outside Support arms
Qty:2
B. Centre Support arm
Qty:1
C. Side mount bracket
Qty:3
D. Surface mount bracket
Qty:3
E. Material Supports
Qty:8
F. Nut-Bolts-Washers
Qty: 3
Qty: 6 Qty: 3
Hafco Plasma Table Attachment
Side mount to 3D welding table
NOTE: Make sure the mounting tab has the at edge at the top, to ensure material supports
will lay at with table surface
Flat surface to the top
STEP 1:
Weld down the side ensuring to two
parts are interlocking and square.
NOTE: Using welding magnets will help
with this process
Top View Side Mount Layout
STEP 2: STEP 3:
Weld Inside braket for extra strength.
Mount to bench using nuts bolts and
washers supplied.
Mounting BracketMounting Bracket Mounting Bracket
Add material supports.
Outside
Support Arm
Centre Support Arm
Outside
Support Arm
Hafco Plasma Table Attachment
Top mount to welding table or bench
NOTE: Make sure the mounting tab has the cutout at the top, to ensure material supports
will lay at with table surface
Cutout surface to the top
STEP 1:
Weld down the side ensuring to two
parts are interlocking and square.
NOTE: Using welding magnets will help
with this process
STEP 4:
Add material supports
STEP 2: STEP 3:
Weld across the top ensuring to two
parts are interlocking and square.
NOTE: Using welding magnets will help
with this process
Weld Inside braket for extra strength.
Mount to bench using nuts / bolts and
washers supplied.
Top View Top Mount Layout
Top
Mounting Bracket
Top
Mounting Bracket
Top
Mounting Bracket
Outside
Support Arm
Centre Support Arm
Outside
Support Arm
Loading...