
DIGITAL SCALE 200MM VERTICAL
OPERATING INSTRUCTIONS
1.MAINTENANCE INSTRUCTIONS
a. Before using the Height Gauge, clean the surface of the protective sticker with dry and
clean cloth(or soaked with cleaning oil).
b. Operating Conditions: Operation Temperature: 5°C-40°C, Relative Humidity:
Up to 80%; non-condensing.
c. Prevent any hydrous liquid from the protective slicker.
d. Never apply voltage(e.g engraving with an electric pen)
on any part of the Scale Units for fear of damaging the circuit.
2.TECHNICAL SPECIFICATIONS
1. Resolution: 0.01 mm/0.0005”
2. Repeatability: 0.01 mm/0.0005”
3. Maximum response speed: 1.5m/s
4. Power: One 1.5V battery.
3.BUTTON FUNCTIONS
Beam
1. mm/in: metric/inch system interchange button.
2. ZERO: zero setting
Battery
Cave
3. OFF/ON ON/OFF button
ON/OFF
ZERO
WARNING!
• Button & coin batteries (new or used) are hazardous and are to be kept away
from children
•
If a lithium button/coin battery is swallowed or placed inside the body can cause
fatal injuries in 2 hours or less
•
If a non-lithium button /coin battery is swallowed or placed inside the body can
cause serious injuries
Medical attention should be sought immediately if suspected the battery has
•
been swallowed or placed inside the body
•
Phone 13 11 26
expert advice
Australian Poisons Information Centre for 24/7 fast,
4.BATTERY REPLACEMENT
The digits twinkling shows the battery voltage is too low,
it needs to replace with a new one
M733_Instructions.indd 1M733_Instructions.indd 1 5/08/2022 11:12:50 AM5/08/2022 11:12:50 AM
mm/inch
Protective
Sticker