Users manual
Portable air conditioner CB-17
A. Control panel
ON/OFF
ON/OFF
INCREASE &
DECREASE
TEMPERATURE
INCREASE & DECREASE
TEMPERATURE
WATER FULL INDICATOR
SET TIMER
SET TIMER
SELECT FAN SPEED
SELECT FAN SPEED
SELECT MODE
SELECT MODE
B. Remote control
C. Water tank and water hose connection
D. Exhaust hose
E. Window kit
5
Please read this manual carefully before installing and using your air conditioner.
Store the manual in a safe place for future reference and product warranty.
www.tesscandinavia.se
Users manual HACE air conditioner CB17
Table of contents
2 ............................................................. Technical drawings
6 ............................................................. English
9 ............................................................. Swedish
12 ............................................................. Danish
15 ............................................................. Norwegian
6
Security warnings:
• The unit must be installed in accordance with
national wiring regulations.
• If the power cord is
damaged, it must be
replaced by qualied
personnel.
• Children should not play
with the unit.
• The unit is for indoor use
only.
• Do not switch the unit off
by unplugging its power
cord.
• Do not put any objects
into the unit’s air inlet or
outlet.
• Keep the unit away from
water sources.
• Place the unit on a at
and solid surface.
• Keep the unit away from
heat sources and inammable goods.
• Do not use the unit
in cooling mode if the
ambient temperature is
above +35°C.
• The maximum length
of the exhaust hose is
1500 mm. Do not extend
or use a longer hose as
this might seriously damage the air conditioner.
• Do not bend or ex the
exhaust hose more than
45° to ensure sufcient
air ow.
• The remote control uses
AAA batteries. Use
alkaline batteries only.
Do not use rechargeable
batteries.
Installation
• If the unit has been
transported horizontally,
keep it in an upright position for 2 hours before
using it.
• Place the unit on a at
and solid surface.
• Do not install the unit in
bathrooms or other wet
environments.
• Make sure that air ow
isn’t blocked - always
keep at least 50 cm
distance to surrounding
surfaces.
Installing the exhaust
hose
• Attach the adapter to
one end of the hose and
connect the other end
to the back of the air
conditioner.
• Extend the exhaust
hose and lead it outside
through a door or window.
Using the window kit
• To use the window kit,
open the window and
place the window kit
either horizontally or
vertically, depending on
the window.
• Adjust the length of the
window kit. Shut the
window and attach the
adapter on the exhaust
hose to the window kit.
Protection functions
Automatic defrost
The unit will automatically
defrost when needed.
Compressor protection
The unit has a compressor
protection function causing
a 3-minute start delay after
the unit is restarted.
Water full alarm
When the water tank is full,
the unit will stop working
and a water-full indication
light is shown. Empty the
water tank and restart the
unit.
Operating instructions
1. Starting the unit
Press the POWER button
to start and stop the unit.
2. Select mode
The unit has 3 different
modes; cooling, auto, and
dry mode. Press MODE on
the control panel or remote
control to select mode.
Cooling mode
Set desired temperature with the TEMP + and
TEMP - buttons on the
control panel or the remote
control.
Set temperature is shown
in the display for few
seconds. After, the display
returns to show the room
temperature. Select fan
speed with the SPEED
button.
English
7
Dry
In dry mode the unit will
dehumidify the room. Fan
speed and temperature
cannot be set. Do not use
the air exhaust hose when
using the unit in dry mode.
Auto
In auto mode, the unit will
automatically set mode
depending on the room
temperature
Room temperature below
23°C: Only the fan runs
Room temperature
between 23-26°C:
Dry mode
Room temperature above
26°C: Cooling mode
3. Set timer
Press the TIMER button
one time to set time for
automatic shut off. Press
it again to set time for
automatic start.
Set time with the TEMP
+ and TEMP - buttons on
the control panel or remote
control
4. Set fan speed
Press the SPEED button
on the control panel or
remote control to choose
fan speed.
Water drainage
Empty the water tank
Remove the water stopper.
Empty the water tank
and re-attach the water
stopper.
Connecting a water hose
for direct drainage
Unscrew the drain cover
and remove the water
stopper. Attach a 13 mm
water hose to the pipe on
the unit. Lead the other
end of the water hose to
a drain. Make sure that
the water can be drained
downwards.
The air lters
The air lters keep dust
and dirt from entering the
air conditioner.
It is very important that the
lters are cleaned regularly; otherwise the unit may
be seriously damaged.
Therefore, clean the lters
at least once every two
weeks.
Filter cleaning
• Remove the back and
side lters.
• Clean the lters with
warm water and a mild
detergent.
• Make sure that the lters
are fully dried before
reinserting them.
Maintenance and
storage
• Clean the body of the
unit with a soft cloth. Do
not use strong solvents
as this might damage
the surface of the unit.
• Store the unit in a dry
environment, away from
direct sunlight. Drain the
water before storage.
Warranties and
service
2 years product warranty.
The warranty is only valid
with proof of purchase.
For all service and warran-
ty claims, you should rst
contact your retailer.
English
8
Problem Cause Solution
The unit doesn’t start Is the power cord connected? Connect the power cord
Is the water tank full? Empty the water tank
Is the room temperature above 35°C or below
10°C?
Increase or decrease the room
temperature
Is the room temperature lower than set temperature?
Change set temperature
Bad cooling effect Is the unit placed in direct sunlight? Move the unit or close the curtains
Are the doors or windows open? Close doors and windows
Are the lters dirty? Clean the lters
Is the air inlet or outlet jammed? Make sure that air ow isn’t blocked
High noise level Is the unit placed on an uneven ground? Place the unit on a at and solid
ground
The compressor doesn’t
work
Overheat protection is activated Wait until the temperature decreases,
the unit will automatically restart
The remote control doesn’t
work
Too long distance or the remote control isn’t
aimed at the unit?
Bring the remote control closer and
aim it towards the unit
Does the batteries need replacing? Replace the batteries
Error code E0 Tube temperature sensor problem Contact retailer
Error code E2 The water tank is full Empty the water tank.
Trouble shooting
If you are having trouble with your unit, please refer to below trouble shooting.
If nothing of the below works, please contact your retailer for servicing of your unit.
English
KLIMASKLEP
ul. Orzechowa 3
72-010 Przęsocin (koło Szczecina)
tel.: (91) 432-43-42
tel.: (91) 432-43-49
e-mail: sklep@klimasklep.pl
www: www.KlimaSklep.pl
Loading...