!
WARNING
!
H2O Audio stands behind our products.
Failure to follow our instructions could destroy
your iPod and will void the Warranty. If you
have any concerns, or experience any
difficulties with your H2O Audio product, we
are here to help you, so please contact us
directly. We can be reached at:
1.800.708.6080
support@h2oaudio.com
www.h2oaudio.com
Caution
Please read this card or you may
destroy your iPod
H2O Audio wants you to know:
» H2O Audio housings are designed for
specific Apple iPod models, which vary by
generation and storage size. You must ensure
the correct housing is used for your iPod.
» Before using this housing for the first time,
you must perform a 'Leak Test'. Please refer to
the Printed Instructions for more information.
» To accommodate the different iPods (with
video) storage sizes, you may have to swap the
existing rails with the included rails. Please refer
to the Rail Instructions for more information.
» It is extremely important you ensure the
T-Seal is properly seated and clean. If it is out of
alignment, twisted or dirty you will cause
damage to, or destroy your iPod.
» If you have any concerns or issues with a
H2O Audio product do NOT contact your local
retailer. Please contact
H2O Audio:
1.800.708.6080
858.623.0339
support@h2oaudio.com
www.h2oaudio.com
H2O Audio
11211 Sorrento Valley Rd. Suite F
San Diego, CA 92121 USA
1. Installing and Replacing Housing Rails
CAUTION:
into the housing you must replace the thick clear rails that
come installed in the housing with thin grey rails which are
included in this bag.
*If you are unsure which rails you need or if you need rails please contact H2O Audio*
1.
2.
3.
4.
NOTE: Be very careful, do not damage the T - Seal with the screwdriver.
For the iPod ( with video ) 60Gb and 80Gb to fit
Use the small Phillips Screwdriver in a counterclockwise
direction to remove all three ( 3 ) screws from the clear rail.
Once all the screws are removed, gently lift the clear rail
out of the housing. Do not leave any screws in the
housing as they may interfere with the accurate closure
of the housing.
Replace the clear rail that was removed, with a thin grey
rail provided in this bag.
Repeat steps 1 - 3 for the other clear rail.
S5 - 52 20070306
www.h2oaudio.com
H2O Audio for iPod with video
®
Printed Instructions
Before using this system, please be sure to read, understand, and follow the instruction of this manual.
2. Housing Features
TM
SealTight Connector
Display Window
Commander Scroll
Wheel Control
IMPORTANT: Make sure the seal is fully seated against the housing base each time you close the
housing. Use the lid to compress the seal into the base if required.
TM
LatchTight Locking
TM
System
3. Introduction
The H2O Audio waterproof housing lets you to listen to digital audio during
active watersports. It houses the Apple iPod digital media player.
HOUSING: The housing features the LachTight Locking System which keeps
the unit waterproof during operation. The H2O Audio housing allows for
functional control of the player while in the water with the Commander
Scroll Wheel.
TM
TM
NOTE: The iPod is NOT waterproof without the H2O Audio housing and
headphones and is NOT covered under the product warranty. Any attempt
to use the housing with an audio player other than the Apple iPod will void
the Warranty.
HEADPHONES: The housing is only waterproof when combined with H2O
Audio waterproof headphones (sold separately). Use of other headphones
with a 3.5mm stereo connector will result in a water resistant case, and should
not be submerged.
4. Leak Test
Before utilizing the system for the first time, it is highly recommended to
perform a 'Leak Test'. Follow the instructions below.
DO NOT INSTALL THE iPod INSIDE THE HOUSING FOR THE LEAK TEST
1. Open the housing, and visually inspect the housing T-Seal.
2. Verify the T-Seal is fully seated and free of debris, then close and lock
the housing using the latch.
3. Immerse the housing, without the iPod, in water and soak for 30
minutes.
4. Manipulate the controls during submersion.
5. Remove from the water, dry the exterior, and visually inspect the
housing for any sign of leaks before opening.
6. Open the housing upside down to prevent water from dropping into
the housing during opening.
7. After a successful 'Leak Test', install the iPod in the housing.
5. Unlock / Locking the Housing
Unlocking your housing
1
Slide latch button towards
1.
the unlock icon.
2
While holding the latch button
2.
towards the unlock icon,
push up on the side of the latch.
3
Lift the top latch over the lid
3.
hooks. Compress the lid to the
base if the latch does not clear
the lid hooks.
Locking your housing
Lift the top latch over the lid
1.
hooks. Compress the lid to
the base if the latch can does
not clear the lid hooks.
2
Snap the latch downwards
2.
to lock in place.
3
Verify the lid and latch are closed
3.
and the button is positioned on
the icon prior to entering the
water.
6. The T-Seal
This product uses a high grade silicone “T-Seal”.
DO NOT USE SILICONE GREASE as this will damage the seal.
7. Installing the iPod into the Housing
Installing the iPod
The white T-Seal between the base and the lid of the housing is what keeps
your iPod safe and dry. It is very important that the seal always be fully
seated, and free of sand, dirt, hair, lint or other debris. Visually inspect the
1
T-Seal and Contact Surface prior to each use. If you see scratches, or other
imperfections, do not use the housing. Wipe clean as necessary using a soft
lint free cloth. If you have questions, contact H2O Audio Customer Support.
Contact Surface
T-Seal
Squeeze both sides of
the housing together
Align the audio port with the
1.
stereo jack in the housing.
Removing the iPod
Slide the player
1.
Gently snap the player into the
2.
audio jack. Verify that the player is
completely plugged into the audio
jack.
off of the stereo
jack. Player will
slide up the
ramps at the
bottom of the
housing.
Rotate the housing
2.
to drop the player into
To ensure the T-Seal is fully seated in the base of the housing, firmly squeeze
your hand.
both sides (the base and lid) of the housing together after each insertion of
the player. Always check to make sure the latch is closed and locked prior to
use.
NOTE: Do not disturb the T-Seal during removal of the player. If the T-Seal is moved, Please use the
housing lid to completely seat the T-Seal.
S5 - 70 20060210
8. Connecting the Headphones
The SealTight Connector is what keeps your audio connection safe and
dry underwater. It is designed specifically to create a seal around the
H2O Audio Series Waterproof Headphones (sold separately). Using any
other headphones will not have a complete waterproof connection, and
reduces the waterproof rating to water-resistant.
To create a waterproof connection, align the 3.5mm stereo plug on the
1.
headphones with the stereo jack of the housing.
Insert the headphones into the stereo jack of the housing, ensuring
2.
that the plug mates securely into the SealTight Connector.
CAUTION: The SV Series Headphones do not fit with the SealTight Connector boot
featured on the H2O Audio Series housings. If your headphones have a connector
that looks like the one shown below, you can not use them with this housing.
TM
TM
TM
SV Series Headphones Connector
9. Commander Scroll Wheel Control
The Commander Scroll Wheel Control is a waterproof assembly, which
TM
TM
allows you to maintain complete control over the iPod’s Click wheel
functions. Refer to iPod Instruction Manual for complete details of how
to use the player.
Menu
Previous / Rewind
Button
Next / Fast Forward Button
Select Button
Scroll Wheel
Rotates Clockwise &
Counter-Clockwise
Play / Pause Button
10. General Storage Procedures
For long-term storage, store in a plastic bag out of direct sunlight.
CAUTION: The life of a T-Seal is typically one (1) year. Contact H2O Audio
for spare T-Seals or a maintenance kit. Always remember to reinstall the
T-Seal before next use. Do not expose the housing to extreme heat, such
as the inside of a hot car, or in hot direct sunlight, such as on a beach, or
boat deck. Doing so may cause damage and subsequent flooding.
CAUTION: The housing is succeptible to internal condensation with
extreme temperature fluctuations. Use above 105°F(40C) can result in
internal condensation. When used in temperatures below freezing, frost
will appear on the interior of the housing.
CAUTION: Do not store housing in the following environments:
* Solvents or other chemical fumes
* High humidity
* High Ozone
* Extreme temperature fluctuations
Storing the housing in these conditions may lead to a damaged housing,
causing it to leak.
Rinse the EXTERIOR of the system in fresh water after EACH use:
1. Make sure the housing is securely closed with headphones attached.
2. Soak in clean fresh water for 30 minutes.
3. Rinse the entire system with freshwater
4. Completely dry the entire exterior of the system using a clean soft
cloth.
5. Dry face down so water can properly drain from the Commander
Scroll Wheel.
Strong detergents, soaps, and chemicals MUST NEVER be used to clean
the system.
TM
11. Available Accessories
H2O Audio Waterproof Headphones (required for use underwater)
Pro Armband for extreme sports
Swimbelt designed by swimmers
12. Contact Us
Customer Support is available Monday to Friday 9AM to 5PM PST.
www.h2oaudio.com
P. 800.708.6080 or 858.623.0339
F. 858.225.0815
E. support@h2oaudio.com
Copyright Notice:
This owner’s manual is copyrighted, all rights reserved. It may not, in whole or in part, be copied,
photocopied, reproduced, translated, or formed into any electronic format without prior consent in
writing. H2O Audio is a registered trademark of Diver Entertainment Systems, Inc. Apple and iPod
are registered trademarks of Apple Computer Inc.
Patents 6396769, 6614722, 6954405 Others Pending.
13. General Use Notice
READ THIS MANUAL CAREFULLY. IF YOU HAVE ANY QUESTIONS PLEASE CONTACT H2O
AUDIO CUSTOMER SUPPORT PRIOR TO USE.
IMPROPER USE OF THIS SYSTEM MAY CAUSE THE USER TO MAKE MISTAKES OR
DECISIONS THAT MAY LEAD TO SERIOUS INJURY OR DEATH.
IMPORTANT WARNING AND DISCLOSURE:
THOSE USERS THAT ELECT TO UTILIZE THIS SYSTEM AT, OR NEAR, THE WATER'S
SURFACE, MUST MAINTAIN SAFETY AWARENESS OF MOVING WATER CRAFTS.
ALWAYS MAKE SURE TO HAVE THE AUDIO PLAYER VOLUME TURNED TO ZERO AND
THE SPEAKERS AWAY FROM THE EARS WHEN TURNING ON THE H2O AUDIO UNIT. IF
THE VOLUME LEVEL IS NOT ZERO WHEN THE H2O AUDIO IS TURNED ON, IT MAY
CAUSE EAR INJURY DUE TO A SUDDEN BURST OF VOLUME. THE VOLUME SHOULD BE
SLOWLY INCREASED WITH AN AUDIO FILE PLAYING TO SET THE SPEAKER VOLUME TO
COMFORTABLE OUTPUT LEVELS PRIOR TO POSITIONING THE SPEAKERS NEXT TO THE
EARS.
IT CAN BE POTENTIALLY DANGEROUS TO PLAY YOUR HEADSETS WHILE ENGAGING IN
ACTIVITIES THAT REQUIRE YOUR FULL ATTENTION. YOU SHOULD EXERCISE EXTREME
CAUTION OR DISCONTINUE USE IN POTENTIALLY HAZARDOUS SITUATIONS. DO NOT
USE THE HEADPHONES WHILE DRIVING, CYCLING, OR OPERATING ANY MOTORIZED
VEHICLE. IT MAY CREATE A TRAFFIC HAZARD AND IS ILLEGAL IN SOME AREAS.
AVOID USING HEADPHONES AT HIGH VOLUME. HEARING EXPERTS ADVISE AGAINST
CONTINUOUSLY LOUD AND EXTENDED PLAY. IF YOU EXPERIENCE RINGING IN YOUR
EARS, REDUCE VOLUME OR DISCONTINUE USE.
THE MANUFACTURER DOES NOT WARRANT AND WILL NOT BE HELD RESPONSIBLE IN
ANY WAY FOR DAMAGES TO THE iPod, OR LOSS OF DATA, INCLUDING LOSS OF DATA
STORED IN THE iPod, RESULTING FROM AN EXCESSIVE IMPACT, THUNDER, OR AN
EORED ON YOUR DEVICE.
14. Warranty Coverage
H2O Audio guarantees, to the original purchaser only, that the equipment purchased
(EXCLUDING THE iPod ) is free of defects in material and/or under normal recreational use
for a period of one year (1) from date of consumer purchase from an Authorized Dealer;
provided that proper care and maintenance have been performed as prescribed by the
owner's guide included with the equipment. Should this product prove to be defective for
any reason (other than those listed as limitations below) the product will be serviced or
replaced at H2O Audio's sole discretion at no charge (excluding shipping and handling).
This warranty shall be void if the registration is not completed and sent to H2O Audio
Customer Services within 30 days of purchase. This warranty shall be void if the
equipment has been tampered with by anyone not authorized to perform service. The
warranty is non-transferable and extends to the original purchaser only and is valid only if
the equipment was purchased from an authorized dealer. Warranty does not extend to
cover damage from accident, abuse, tampering, lack of maintenance, theft, or loss. Service
or modifications by anyone other than an Authorized H2O Audio agent will void the
warranty. H2O Audio will not be responsible for recovery or replacement of the product in
the event of loss or theft. H2O Audio, its Authorized International Distributors, and
Authorized Dealers make no other warranties, either express or implied or orally, or in
writing, with respect to any other warranty coverage except those expressly stated within
the preceding sentences. H2O Audio will not be held responsible for any agreements orally
or in writing with the exception of those expressly included in this warranty statement. The
warranty registration card and the terms contained herein supersede all statements
contained in any and all owner's guides, instruction cards, or other equipment literature or
catalogs. In no event will H2O Audio, its Authorized International Distributors, and
Authorized Dealers be held responsible or liable for any personal injuries resulting from the
use of the covered equipment, or for any other damages, whether direct, indirect,
incidental, or consequential; even if H2O Audio has been advised of such damages.
Warranty does not extend to any damages that may occur to the iPod or loss of any data.
15. Returns
Prior to any return, a Return Authorization (RA) number mu
the stereo jack. Player will slide up the ramps at the bottom of the housing.
the owner's portion of the warranty card must accompany all correspondence regarding
the equipment covered by this warranty agreement or in direct reference to this warranty.
Slide the player off of
S5 - 70 20060210
Loading...