Gyros S 107N Instruction Manual

Please read these instructions carefully before using the helicopter

3 CHANNEL GYROSCOPIC STABILIZATION TECHNOLOGY FOR SMOOTH HANDLING

INFRARED REMOTE CONTROL HELICOPTER

Safety Instructions

Ready to y

Low power protection

1. Please keep the helicopter and the box away from small children.

2. Please keep a safe distance from high speed rotating propellers to avoid injury.

3. First time users should be gentle with the throttle to avoid crashing the helicopter or
any potential injuries.

4. When finished flying, please turn off first the remote controller then the helicopter.

5. Please keep the charging battery away from fire and humidity.

6. Do not fly the helicopter near pets, young children, elderly and disabled people.

7. Non rechargeable batteries are not to be charged; Different types of batteries or new
and used batteries are not to be mixed; Batteries are to be inserted with correct polarity;
Exhausted batteries are to be removed from the product. The supply terminals are not to
be short circuited

8. When not in use, please turn off the power of controller and helicopter. When the
helicopter is not in use for a long period of time, remove the batteries from remote
controller.

1. Use a place away from any people, pets and obstacles.

2. Turn helicopter power switch “ON”. The helicopter lights will flash. It will search
the signal from controller.

3. Turn the remote controller “ON”. The indicator light will flash. Push the left control
throttle up and down. The indicator light will be constant.

4. Push the left control throttle up slowly and start to fly.

When the helicopter’s battery is low, the system will cut-off the power to avoid excessive
discharge. This will reduce any damage to the battery.

Instructions for care and maintenance

1. Please clean the helicopter and controller with a clean soft cloth.

2. Store the helicopter in a dry, clean place. Keep the box for storage.

3. Inspect the helicopter before use. Do not use if any parts are damaged or broken.

Battery Installation & Charging

Dierent types of batteries or new and used batteries are not to be mixed;
Batteries are to be inserted with correct polarity;
Exhausted batteries are to be removed from the product;
The supply terminals are not to be short circuited.

Charge time: 50-60 minutes—Fly time 5-6 minutes!

Battery Installation in the remote controller

Charging the helicopter battery
A. To charge the helicopter with

remote Control

1. Be sure to switch off the helicopter power.

2. Charging by A: Plug the provided USB charging cable into the helicopter, then insert
the USB plug into the remote controller charge port. The USB indicator should turn on
when the battery starts charging. The USB indicator will turn off when the battery is
fully charged (About 50-60 minutes).
Charge by B: Plug the provided USB charging cable into the helicopter, then insert the
USB plug into your computer. The USB indicator should turn on when the battery starts
charging. The USB indicator will turn off when the battery is fully charged (About 50-60
minutes).

The helicopter contains a built-in Li-Po battery, please pay attention to the following matters:

- Keep the battery away from fire and heating sources. It could damage the battery or cause
it to explode.

- Keep the helicopter and the battery away from water.

- Only charge the helicopter with the provided adapter.

- Do not remove or dismantle the built-in battery.

- Do not leave unattended when charging.

B.To charge the helicopter with USB
(Connected to computer)

1. Use a crosshead screw driver to remove the controller battery cover. Insert 4 batteries
(size AA, 1.5V) observing the correct polarity indicated in the compartment. Replace the
battery cover and secure the screw.