OPERATOR’S MANUAL
Amps Probe Kit
from 10 milliamps to 600
from 10 milliamps to 20
from 1 amp to 600 Amps AC
w/Banana Jacks or BNC
www.ferretinstruments.com
The Amps Probe Kit contains a Low Amps
To Measure Low Amps with a DMM
the circuit you want to test. 1 Millivolt
To Measure High Amps with a DMM
www.ferretinstruments.com
To View Waveforms on a Lab Scope
to the in ter face module.
waveform of the circuit under test.
Amp Probe and zero the trace on the
waveform.
The interface module has two power
will stay on until the battery is dead.
The second time you press the power
the unit will automatically power down in
The third time you press the power button
the unit will turn off.
within the above war ran ties will be to repair or replace, at our option, any defective parts and return the product to the sender within the U.S.A., ship-
ping prepaid, if it is sent to our Repair Department shipping prepaid and accompanied by proof of purchase. The above warranty is extended for the
ashtubes in timing lights which are within ve years of the date of manufacture.
A Ferret Instruments product less than ve years old according to the date of man u fac ture, and which is returned with transportation charges prepaid
to: Ferret In stru ments, Inc., Repair Department, 1310 Higgins Drive, Cheboygan, MI 49721, will be repaired or replaced, at factory option, for a service
tin ued, the nearest equiv a lent prod uct may be substituted.
This Warranty and Extended Service Policy do not apply to products which have been altered outside the factory; or repaired by anyone other than
the factory or its authorized service centers; or which have been damaged from accidents, neg li gence, or abuse; or have been used differently than
described in the printed instructions. Please note that wear and tear on leads and replacement of consumable (paper, oxygen sensors, Nox Sensors,
Warranty and the Extended Service Policy. THERE ARE NO OTHER WAR RAN TIES EX PRESSED OR IMPLIED IN CLUD ING THOSE OF MER-
CHANT ABIL I TY OR FIT NESS FOR A PARTICULAR PUR POSE AND FERRET INSTRUMENTS, INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR
vary from state to state.
Always wear safety glasses, or other eye protection when testing vehicles. Be extra careful near batteries and
Treat clothing, vehicle parts, and equipment similarly. Any acid traces inside equipment must be re moved by
tact between the vehicle body metal and the "hot" terminal can cause sparks to ignite gas or even weld tools
Avoid electrical shocks caused by getting too close to live ignition wires or touching the coil TACH ter mi nal. A
Loading...