Guzzanti ZRW 50 X, ZRW 60 W, ZRW 60 X User Manual

INSTRUCTIONS

FOR MAINTENANCE AND USE

KITCHEN EXTRACTOR HOOD

ZRW 50/60

Dear Customer

You are now a user of a kitchen extractor hood of ZRW type. This hood has been designed and
manufactured specially with a view to satisfying your expectations and it will certainly
constitute a fitting element of a modern kitchen. The modern structural solutions and the newest
technologies used in production of this hood guarantee its high effectiveness and good
appearance.
Please read these instructions carefully before installing the hood. They will help you avoid
mistakes during installation and operation of the hood.
We wish you a lot of satisfaction from choosing our kitchen extractor hood.

NOTE: The manufacturer will accept no responsibility for any damage due to installation or
operation not conforming to these instructions..

I Characteristics

ZRW kitchen extractor hood was designed to remove or neutralize kitchen fumes. It has to be
installed permanently over a gas or electric cooker. It requires installation of a conduit

discharging used air to the outside if working in fume removal mode. The conduit (a pipe Ø120

mm) shall not be longer than 4-5 m. The hood can operate as an odour absorber after installation
of an active carbon filter. In such case a conduit discharging used air to the outside is not
necessary. The kitchen hood is an electrical appliance manufactured according to class II of fire
protection, equipped with a permanent supply cord and plug. It has its own lighting and an
exhaust fan which can be set to one of three rotational speeds.

II Technical data

Power supply voltage AC 230V 50 Hz
Fan motor 1
Lighting 40 W
Number of grease filters 1
Number of speeds 3
Width (cm) 50, 60
Depth (cm) 50
Height (cm) 13

Mass (kg) 6 (60 cm) / 4,8 (50 cm)
Air outlet (ø mm) 120
Capacity (m3/h) 320
Power consumption (W) max. 135
Noise level (dBA) max. 51

2