Page 1
Configuration
Configuring Harness System
Un-zip harness pocket on
back of bag and pull out
harness.
Latch waist straps and
shoulder straps to base of
bag.
Order of Adjustment
Butterfly Opening
1
2
3
1
Leave top buckle connected
2
Pull zipper to bottom middle
3
Open butterfly panel to access your gear
Full Opening
1
2
4
3
Thank you.
Welcome to the Gura Gear family.
We are here to help
+1 (801) 823-2809 or support@guragear.com
Gura Gear
154 East 21st Street Ogden, Utah 84401 United States
www.guragear.com
Latch load lifters to top of
bag. Then the harness is
ready.
3
5
2
1
To properly fit bag, adjust
straps in the order shown.
1
Waist Belt
2
Hip Loaders
3
Shoulder Straps
4
Load Lifters
5
Sternum Strap
1
Disconnect top buckle
2
Pull zippers to bottom corners
3
Open full panel to access your gear
Page 2
Velcro Strap Keepers
Rain Protection
1
Ground Protection
2
Locate strap keeper. Unstrap and roll/unroll to
resize. Resecure velcro.
Waist Strap Removal
& Adjustment
1
2
1
Remove protective cover from zipper
pocket.
2
Cover bag and tighten pull cord.
Remove protective cover from zipper pocket.
Lay the cover on ground to provide dry, clean
surface to rest bag on.
Tripod Side Mount Tripod Center Mount
1
Unbuckle both hip loaders.
2
Detach from velco backing,
pull strap out to remove or
shift up or down for ideal fit.
Place leg(s) of tripod into right-side pouch. Use
accessory strap around the top of the tripod to
secure it to the bag.
Wrap one end of accessory strap around the leg
of the tripod. Attach other end of the strap to
the bag as shown. Repeat for other side.
Thread provided Kooh Cord through bottom
handle loop and then around legs of tripod to
secure tripod to bag.
Loading...