
rece ption, which can be determin ed by turning the
equi pment off and on, the user is enco uraged to try
to cor rect the interference by one o r more of the
foll owing measures:
Reor ient or relocate the receivi ng antenna.
Incr ease the separation betwee n the equipment
and re ceiver.
Conn ect the equipment into an outl et on a circuit
diff erent from that to which the receiver is connec ted.
Cons ult the dealer or an experienc ed radio/TV
tech nician for help.
Caut ion: Changes or modifications not expressly
approved by HARMAN could void the user’s
authority to operate the equipment.
For Pr oducts That Transmit RF
Ener gy:
FCC AND IC INFORMATION FOR USERS
This device complies with Part 15 of the FCC rules
and Industry Canada license-exempt RSS 210.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference;
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Fcc And Ic Statement For Users
(usa And Canada Only)
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept any
interference received, including interference
that may cause undesired operation.
Fede ral Communication Commission
Inte rference Statement
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
FCC/IC Radiation Exposure Statement
This equipment complies with FCC/IC RSS-102
radiation exposure limits set forth for an
uncontrolled environment.This equipment should
be installed and operated with minimum distance
20cm between the radiator & your body.
For Products with Radio Receivers
That Can Use an External
Antenna (USA ONLY):
CATV (Cable TV) or Antenna Grounding
If an outside antenna or cable system is connected
to this product, be certain that it is grounded so as
to provide some protection against voltage surges
and static charges. Section 810 of the National
Electrical Code (NEC), ANSI/NFPA No. 70-1984,
provides information with respect to proper
grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors,
location of antenna discharge unit, connection to
grounding electrodes and requirements of the
grounding electrode.
Note t o CATV Sy stem Installer:
This reminder is provided to call the CATV (cable
TV) system installer’s attention to article 820-40
of the NEC,which provides guidelines for proper
grounding and, in particular, specifies that the
cable ground shall be connected to the grounding
system of the building, as close to the point of
cable entry as possible.
4

SBASE301
SBASE301
flash.
and it doesn’t flash any more
13