GunVault MV 500 User Manual

MicroVault

Model MV 500

User Manual

Patented Rev 2 (10/11)

Firearm Safety

WARNING: The MicroVault safe or any other firearm storage device cannot take

the place of other safety procedures including advising children of the
dangers of firearms.

WARNING: The manufacturers and distributors of the MicroVault safe do not

recommend, suggest, advise, promote or otherwise condone the ownership
or use of firearms. We at GunVault Inc. believe the decision to own or use a
firearm is a serious decision that should only be made by an adult who has
carefully considered the risks and benefits of such a decision.

WARNING: The keypad and push buttons on the control panel are electronic.

They have a certain feel to them and may seem different to different people. It
is important for you to become accustomed through practice, as to how the
MicroVault safe responds to your own personal touch.

WARNING: Never mix alcohol or drugs with firearms or the MicroVault safe.

Alcohol and other substances likely to impair normal mental or physical
functions should not be used before shooting or handling firearms or the
MicroVault safe.

WARNING: Never grab your firearm by the trigger when removing or placing into

the MicroVault safe. Make sure your firearm’s safety mechanism is on.

WARNING: Always point your firearm in a safe direction. Common sense should

dictate which direction is the safest.

WARNING: Always follow the firearm safety rules set out by the firearm’s
manufacturer.

WARNING: Be familiar with how firearms work. GunVault recommends that you

obtain as much information as possible on firearm safety.

WARNING: Always handle firearms as if they are loaded and ready to fire.

Always assume that a firearm is loaded.

WARNING: In order to enjoy the maximum security benefits of the MicroVault

safe product, it must be mounted in place using the equipment provided with
the product, according to the instructions provided herein. Use of this product
as a storage receptacle without mounting according to the instructions
provided herein, may compromise security of the MicroVault.

- 1 -

Getting Started

Set your keys to the side. Don’t lock them inside the safe!

 Pull open the battery cover.
 Pull out the battery holder, by gently pulling on the ribbon.
 Insert new 9v battery. Following the Positive (+) and Negative (-) guides on

the holder.

 Reinsert the battery holder and snap the battery cover back into place.
 When power has been connected, the green light blinks one time and then

the red light blinks one time, with a long beep during the process.

 Use the factory-default code to open the unit, which is: Press each button one

time, from left to right -- 1 , 2 , 3 , 4.

 Getting ready to program
 Find the LED light in the keypad.
 It can glow either green or red. Depending upon the function being utilized.
 There is an audible beep when keys are pressed.

- 2 -