Gunter & Hauer ATALA 1060 GL, ATALA 1075 GLW, ATALA 1060 GLW, ATALA 1090 GL, ATALA 1090 GLW Instruction Manual

Günter & Hauer

Instruction manual

Cooker hood

ATALA

1060 GL/GLW 1075 GL/GLW 1090 GL/GLW

Content

Safety instructions…………………………..4

Installation…………………………………..7

Start using your cooker hood………………..9

Troubleshooting…………………………….11

Maintenance and cleaning………………….12

Environmental protection…………………..16

Safety Instructions s

4

T

his manual explains the proper installation and use of your cooker hood, please
read it carefully before usin g ev en if you are f amiliar w ith the produc t. The m anual
should be kept in a safe place for future reference

Never to do:

● Do not try to use the cooker hood without the grease filters or if the filters

are excessively greasy!

●Do not install above a cooker with a high level grill.

●Do not leave frying pans unattended during use because overheated fats

or oils might catch fire.

●Never leave naked flames under the cooker hood.

●Do not flambé under the cooker hood.

●CAUTION: Accessible parts may

become hot when used with cooking
appliances.

●The minimum distance between the

supporting surface for the cooking vessels
on the hob and the lowest part of the cooker hood. (When the cooker hood
is located above a gas appliance, this distance shall be at least 65 cm)

●The air must not be discharged into a flue that is used for exhausting fumes

from appliances burning gas or other fuels.

Always to do:

5

● Important! Always switch off the electricity supply at the mains during

installation and maintenance such as light bulb replacement.

● The cooker hood must be installed in accordance with the installation

instructions and all measurements followed.

● All installation work must be carried out by a competent person or

qualified electrician.

●Please dispose of t he packing material ca refully. Chil dren are vulnerable

to it.

● Pay attention to the sharp edges inside the cooker hood especially during

installation and cleaning.

●Make sure the ducting has no bends sharper than 90 degrees as this will

reduce the efficiency of the cooker hood.

●Warning: Failure to install the screws or fixing device in accordance with

these instructions may result in electrical hazards

●If the cooker hood is damaged, do not attempt to use.

Warning: Before obtaining access to terminals, all supply circuits must be

disconnected.

Always to do:

●Always put lids on pots and pans when cooking on a gas cooker.

●When in extraction mode, air in the room is being removed by the cooker

hood. Please make sure that proper ventilation measures are being
observed. The cooker hood removes odours from room but not steam.

●Cooker hood is for domestic use only.

●If the suppl y cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.

●This appliance can be used by children aged from 8 years and above and

persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by
children without supervision.

Warning: Danger of fire: do not store items on the
cooking surfaces.
A steam cleaner is not to be used.

A

lways to do:

● Caution: The appliance and its accessible parts can become hot during

operation. Be careful to avoid touching the heating elements. Children
younger than 8 years old should stay away unless they are under
permanent supervision.

● There shall be adequate ventilation of the room when the cooker hood is

used at the same time as appliances burning gas or other fuels.

●There is a fire risk if cleaning is not carried out in accordance with the

instructions

●Regulations concerning the discharge of air have to be fulfilled.

●Clean your appliance periodically by following the method given in the

chapter MAINTENANCE.

●For safety reason, please use only the same size of fixing or mounting

screw which are recommended in this instruction manual.

●Regarding the details about the method and frequency of cleaning, please

refer to maintenance and cleaning section in the instruction manual.

●Cleaning and user maintenance shall not be made by children without

supervision.

●When the cooker hood and appliances supplied with energy other than

electricity are simultaneously in operation, the negative pressure in the
room must not exceed 4 Pa (4 x 10-5 bar).

NEVER try to extinguish a fire with water, but switch off the appliance and

then cover flame e.g. with a lid or a fire blanket.

6

Installation (Vent o utsi de) j

1. The cooker hood should be placed at a distance of 65-75cm (26-

30inch) from the cooking surface for the best effect.

2. Drill a hole in t he cabinet, with hole wide 500*27 5(mm) for 52CM,

730*275(mm) for model 75CM and 880*275(mm) for model
90CM.Refer to Pic 1. Make sure the hole edge to the cupboard edge
at least 35mm distance.

3. Unscrew the 4 screws on the outer glass frame panel by screwdriver,

pull out the light wire, take down the outer glass frame panel, see Pic

2.

7

4. Put the hood into the

WARNING:

 For safety reason, please use only

screw which are recommended in

device in accordance with these

cabinet, tighten up the screws by screwdriver, and make sure the hood
was fixed. Pic 3.

5. Connect the light wire and assemble the outer glass frame panel b y

screw.

6. Install the outlet and expansion pipe: install the outlet on the cooker

hood, then cover the expansion pipe on the outlet and lead it to
outdoor.

the same size of fixing or mounting

 Fa ilure to install the scre ws or fixing

this instruction manual.

instructions may result in electrical
hazards.

8

Start using your cooker hood s

LED touch control

LED touch control has five buttons, see pic.

(Decrease), (Increase), (Lamp), (Timer),

(Power)

1. Power-on: After connecting the cooker hood to the main supply, the

backlight of button will turn on,

hood will enter into stand-by mode.

2. (Power) button:

output will be closed and the cooker

2.1. Press (Power) button, the backlight of button will be on and
the hood will work at the low speed, and the light will be on. The

backlight of the buttons (Decrease), (Increase),

(Lamp), and (Power) will be on. Press (Power) button again,
the backlight of button will be off and the cooker hood will be turn off
and return into stand-by mode and operate by the circle.

2.2. The button of (Lamp) button could be operated without

pressing the (Power) button. Press (Power) button, the

9

cooker hood will be turn off without any functions.

3. (Lamp) button:

Press (Lamp) button, the backlight of button and the lights will be
on. Press again, the lights will be off. The lights run circularly.

4. (Increase) button:

4.1 Press (Increase) button, the backlight of button will be on,

the cooker hood starts to work at the low speed. the LED display
will display “1”,

4.2 Press (Increase) button again when it is working on the low

speed, the cooker hood works at the mid speed and the LED
display will display “2”,

4.3 Press (Increase) button again when it is working on the mid

speed, the cooker hood works at the high speed and the LED
display will display “3”.

5. (Decrease) button

Press (Decrease) button, the cooker hood will decrease one
speed, and the display will show the current working speed. When press

(Decrease) button again when it is working on the low speed, the

10

cooker hood will turn off and the backlight of the (Decrease)

Fan switch turned
off

Fan switch failed

Contact service center.

Light does
One way valve and

tightly sealed

Leakage from the

chimney and cover

button will be off.

6. (Timer) button:

6.1．The (Timer) button works when the motor and light is on
only. The timer setting is 5mins and could be repeat setting. When the
time is up, the cooker hood will be turn off and the light will be off.

6.2 When the timer is set, if adjusting the speeds, the timer will re-

calculate the working time.

Troubleshooting s

Fault

Light on,
but motor
does not
work

not work,
motor does
not work

Oil leakage

Lights not
working

Possible Cause

Select a fan switch position.

Motor failed Contact service center.
House fuses blown Reset/Replace fuses.

Power cord loose or
disconnected

the outlet are not

connection of

Broken/Faulty
globes

Refit cord to power outlet.
Switch power outlet on.

Take down the one way valve
and seal with sealant.

Take chimney down and seal.

Replace globes as per this
instruction.

11

Solution

Insufficient

The distance

is too far

The Cooker

inclines

suction

between the cooker
hood and the gas top

Refit the cooker hood to the
correct distance.

hood

The fixing screw not
tight enough

Tighten the hanging screw and
make it horizontal.

NOTE:

Any electrical repairs to this appliance must conform to your

local, state and fed eral laws. Please con tact the service cen tre if
in any doubt before undertaking any of the above. Always disconnect the
unit from the power source when opening the unit.

Maintenance and cleaning s

Caution:

●Before maintenance or cleaning is carried out,

the cooker hood should be disconnected from
the main power supply. Ensure that the cooker
hood is switched off at the wall socket and the
plug removed.

●External surfaces are susceptible to s cratches

and abrasions, so please follow the cleaning
instructions to ensure the best possible result is achieved without damage.

GENERAL

Cleaning and maintenance should be carried out w ith the appliance cold
especially when cleaning. Avoid leaving alkaline or acid substances
(lemon juice, vinegar etc.) on the surfaces.

STAINLESS STEEL

The stainless steel must be cleaned regularly (e.g. weekly) to ensure long
life expectanc y. Dry with a clean soft cloth. A specialized stainless steel
cleaning fluid may be used.

12

NOTE:
Ensure that wiping is done along with the grain of the stainless steel to
prevent any unsightly crisscross scratching patterns from appearing.

CONTROL PANEL SURFACE

The inlay contro l panel c an be cl eaned usin g war m soapy water. Ensure
the cloth is clean and well wrung before cleaning. Use a dry soft cloth to
remove any excess moisture left after cleaning.

Important

Using neutral detergents and avoid using harsh cleaning chemicals,
strong household detergents or products containing abrasives, as this will
affect the applian ce appearance and potentially remove any printing of
artwork on the control panel and will void manufactures warrantee.

GREASE MESH FILTERS

The mesh filters can be c leaned by hand. S oak them for about 3 minute
in water with a grease-loosening detergent then brush it gently with a soft
brush. Please do not apply too much pressure, avoid to damage it. (Leave
to dry naturally out of direct sun light)
Filters should be washed separately to crockery and kitchen utensils. it is
advisable not to use rinse aid.

INSTALLING GREASE MESH FILTERS

• To install filters for the following four steps:

- Angle the filter into slots at the back of the hood.

- Push the button on handle of the filter.

13

- Release the handle once the filter fits into a resting position.

- Repeat to install all filters.

CARBON FILTER-not supplied
Activated carbon filter can be used to trap odors. Normally the activated
carbon filter should be changed at three or six months according to your
cooking habit. The installation procedure of activated carbon filter is as
below.

1. Remove the grease filter(s).

2. Hook the carbon filter over the pins that are located at the end of the

motor.

3. Turn the carbon filter anticlockwise, until you feel it click into place.

※Repeat this process for the second carbon filter. You need to place a
carbon filter at either end of the motor.

14

※Refit the motor access panel and fully tighten the screws that you

Important:

 The bulb must be replaced by the

service agent or

appliance. When handling bulb, make

reduce the life of the globe.

removed previously.

※Refit the lower and upper chimney sections to the main body of the

hood.

NOTE:

• Make sure the filter is securely locked. Otherwise, it would loosen

and cause dangerous.

• When activated carbon filter attached, the suction power will be

lowered.

BULB REPLACEMENT

manufacturer, its
similarly qualified persons.

 Always switch off the electricity supply

before carrying out any operations on the

sure it is completely cool down before
any direct contact to hands.

 When handling globes hold with a cloth

or gloves to ensure perspiration does not
come in contact with the globe as this c an

LED LIGHTS:

1. Switch off the appliance and unplug it.

2. Slide the front part of the cooker hood.

3. The al filter should be detached first. Press the lock and pull it
downward.

4. Replace with same type of light:230V~50Hz, MAX.2.5W LED

• ILCOS D code for this lamp is: DBS-2.5/65-H-120/33.
– Max wattage: 2.5W
– Voltage range: AC 230V

15

– Dimensions:

This product is marked with the symbol on the selective

this product must not be disposed of with household
waste but must be supported by a system of selective

on the environment, electrical and electronic products
are potentially dangerous for the environment and
human health due to the presence of hazardous

please contact your

local or regional authorities.

Environmental Protection s

sorting of waste electronic equipment. This means that

collection in accordance with Direc tive 2012/19/EU. It
will then be recycled or dismantled to minimize impacts

substances. For more information,

NOTE:

The following shows how to reduce total environmental impact (e.g.
energy use) of the cooking process).

(1) Install the cooker hood in a proper place where there is efficient

ventilation.

(2) Clean the cooker hood regularly so as not to block the airway.
(3) Remember to switch off the cooker hood light after cooking.
(4) Remember to switch off the cooker hood after cooking.

16

INFORMATION FOR DISMANTLING

Do not dismantle the appliance in a way which is not shown in the user
manual. The appliance could not be dismantled by user. At the end of
life, the appliance should not be disposed of with household waste.
Check with you Local Authority or retainer for recycling advice.

17

Mühlenstrasse 8a, Berlin,14167, Germany

www.gunter-hauer.eu

e-

mail: [e-mail]