Gundlach 338 Instructions And Parts List

The No. 338 Universal Cutting Tool cuts:

• Underlayment in Toe Kick Areas

• Door Jambs

The No. 338 Universal Cutting Tool is designed for use with any
corded ³⁄₈" or ¹⁄₂" electric drill and stores easily in your tool box.
Blades are sold separately.

Note: The Universal Cutting Tool should always be operated

between 1,750

RPM

and 2,500

RPM

. Operate the drill in the

forward position.

GUNDLACH

Instructions and Parts List for

No. 338 Universal Cutting Tool

Shown with handle set up
for underlayment cutting.

Cutting Installed Underlayment

The tool cuts ⁷⁄₈" deep to within ¹⁄₈" from the backboard of toe space area
for underlayment removal. To cut installed underlayment, position the No. 338
Universal Cutting Tool and the drill as shown above. Cut into the
underlayment pulling the drill from right to left.

DANGER Proper handle setup and drill placement for cutting installed

underlayment must be strictly followed.

To adjust the handle on the No. 338 Universal
Cutting Tool, simply loosen the wing nut and
position the handle for the desired job.

Operating Instructions

No. 338 Universal Cutting Tool
shown with handle set up for
cutting installed underlayment.