Gulfstream Plastics 9600 Owner's Manual
PLEASE SAVE THIS MANUAL
FOR FUTURE REFERENCE
OWNER MANUAL
Chair 9600
FOOT-SPA
Chair 9700
CHI SPA
Table of Contents
Owner Manual
Safety and Precautions
Identifying Parts
Foot-spa Clearance
INSTALLATIONS
Attaching Seat
Jet Assembly
Plumbing Connections
Operations and Use
Cleaning & Maintenance
Warranty & Service
1
2-3
4
5
6-7
8
9-11
12
13
SAFETY & PRECAUTION
1
Thank you for purchasing the Chi-Spa from Gulstream Plastics . Please carefully read instructions before installing
the spa. Carefully follow the instructions, your spa will give you years of beauty and service.
This product is to be connected to a branch circuit outlet protected by a Class A GROUND FAULT CIRCUIT
INTERRUPTER (GFCI), and the GFCI shall be tested regularly for continued protection and correct
operation. If a Class A GFCI protected outlet is not available, DO NOT USE THIS PRODUCT! Please
contact a licensed electrician for installation of a Class A GFCI according to local electric codes, or equivalent.
Warning
!
Foot-spa must be installed by a licensed plumber and electrician in accordance with local codes.
Plumbing and Electrical Installation instructions must be adhered to in order for the warranty to be in effect
and to insure the utmost in safety. Chair and spa have a maximum seating capacity of 350 pounds.
THIS PRODUCT IS FOR IN DOOR USE ONLY
DISCONNECT POWER SUPPLY CORD BEFORE SERVICING AND CLEANING
TM
BASIC PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE FOLLOWING:
1. Read and follow all instructions
2. DANGER. To reduce the risk of injury, do not permit children to use this unit unless they are supervised at all
times
3. Use this unit only for its intended use as described in this manual. Do not use attachments that are not
Recommended by the manufacturer.
4. Never drop or insert any object into any opening.
5. Do not block jets during whirlpool operation.
6. The unit must be connected to an electrical supply circuit that is protected by a ground fault circuit interrupter.
7. The clean jet motor is magnetically driven and is insulated twice. Therefore it does not require to be bonded.
Save these instructions
1. Excessive water temperature is dangerous and should be checked BEFORE use.
!
Warning
2. Maximum temperature of the water should never exceed 100 degrees F.
3. Always enter and exit the Foot Spa slowly and carefully.
4. NEVER bring and / or operate any electrical devices into or near the Foot Spa.
IDENTIFY YOUR FOOT-SPA
2
Front
1
2
3
4
5
6
7
Back
16
8
9
10
15
11
1. Headrest Pillow
2. Back Cushion & Massage
3. Remote Control with Stand
4. Seat Cushion
5. Wooden Tub Frame
6. Wooden Arm Rest
7. Flip-out Manicure Tray
8. Tub
9. Hand Spray
10. Adjustable Footrest
11. Control Panel
12. Jet Control
13. Water Control
14. Drain Control
15. Drain
16. Jet
17. Foot Massage Tray
12
Control Panel
13
17
14
IDENTIFY YOUR FOOT-SPA
2
3
SEAT OPERATION
Reclining
Armrest can be raised up/down
1
3
Sliding
SPA DIMENSION
’’
3
4
15’
’
5
’’5
7’
2 ’
3
2 ’
’
Loading...