Guerrilla Gravity The Smash Owner's Manual

Owner’s Manual

Contents

• Assembly

– Frame fittings

– Fastener torque
– Fork compatibility
– Drivetrain compatibility

– ISCG Mount

• Setup

– Fork
– Shock install & orientation, air springs vs coil springs

– Suspension sag, air volume spacers, and damper settings

• Crush Mode/ Plush Mode

• Onboard Frame Storage

• Maintenance and Small Parts

• Safety

Assembly - Frame Fittings

– Headset: EC49/40 lower, ZS49/28 for tapered steer tube

– BB: Standard 73mm BSA threaded

– Seat post: Ø30.9mm, Clamp: Ø34.9mm, stealth routing compatible

– Rear hub: 12x148, offset 3mm to the drive side

– Rear brake mount: International Standard

– Shock: 230x57.5, 8x25 front, 8x40 rear hardware

– Tires: Up to 29x2.5”

– Chainring: Up to 34 teeth, 55mm chainline

Assembly – Fastener Torque

1. Main Pivot Axle

1. Adjust pre-load on angular contact bearings (8mm hex)

2. Then tighten pinch bolt to 10 Nm (7 lb-ft, 90 in-lb) (5mm hex)

2. Rocker Pivot Axle

1. Adjust pre-load on angular contact bearings (5mm hex)

2. Then tighten pinch bolt to 10 Nm (7 lb-ft, 90 in-lb) (5mm hex)

3. Seatstay/Rocker Bolts: 10 Nm (7 ft-lb, 90in-lb) (5mm hex)

4. Chainstay/Axle Block Bolts: 10 Nm (7 ft-lb, 90in-lb) (5mm hex)

2

2

3

4

1

Assembly – Fastener Torque

1. Rear Axle

1. Pinch bolt holds axle nut insert and derailleur hanger, to remove rear wheel, only loosen axle head

2. Derailleur Hanger

1. The pinch bolt clamps the nut insert and attaches the derailleur hanger

2. Tighten pinch bolt to 10 Nm (7 lb-ft, 90 in-lb) (5mm hex)

3. Do not loosen pinch bolt to remove rear wheel

1

2

2

Assembly - Chainline

Definition: Distance between frame centerline plane and center plane of chainring

Chainline