Guardian H1600 Owner's Manual
E-1
Ultrasonic Digital
Humidier
Model No. H1600
3-Year Limited Warranty
www.germguardian.com
1.866.603.5900
English E - 1
French F - 1
Spanish S - 1
Date Purchased
month ________
year _________
USE & CARE INSTRUCTIONS
Germ Guardian
®
REV0509
germguardian
H1600_0509_Manual.indd 1 5/18/2009 11:57:43 AM
E-2 E-3
Model Number: H1600
Humidifying Mode: Combination (warm or cool mist)
Power Supply: AC120V, 60Hz
Power Consumption: 140W (40W at cool humidication)
Maximum Humidity Capacity: 250 ml/hr
Tank Capacity: 1.21 gallons/ 4.57 L
Successive Humidity Hours: 18 hours (highest setting on warm humidication) or over
55-hours (low setting on cool humidication)
Dimensions: Width 13 inches - Height 7 inches - Depth 11 inches
Weight: 8 pounds (not including packaging)
FUNCTIONS AND FEATURES
Select humidifying temperature based on need. Warm mist selection will use more power but
will humidify your room quicker.
PRODUCT SPECIFICATIONS AND PARTS
CONTROL PANEL BUTTON FUNCTIONS
Tank Lid
Cleaning
Brush
Power Plug
Body
Humidity Spout
Handle
Water Tank
Spout Guide
Warm or Cool Humidication Selection
When the unit is low on water the Rell LED on the front panel will light up and the unit will shut off.
Simply add more water to continue use.
Water Shortage Indicator
Provides a soft ring of blue light
with ON/OFF switch.
Night Light/Lamp
Adjusts spray between low,
medium and high.
Spray Control
Turns humidier ON/OFF.
Power
Select humidifying temperature
based on need. Warm humidity
will use more power, but will
humidify room quicker.
Warm/Cool
Night Light/Lamp
Spray Control
Power
Warm/
Cool
*Cleaning brush
is located in base
of unit.
The spray volume or amount of mist that is produced by the unit can be adjusted based on need.
It can be changed from low to high by pressing the SPRAY CONTROL button on front panel.
Spray Volume Adjustment
Small silver particles have been embedded into the water tank to help ght the growth of
bacteria and mold.
Silver Clean Technology
H1600_0509_Manual.indd 2 5/18/2009 11:57:43 AM
E-4 E-5
WARNINGS
This product should be used only in accordance with the specications outlined in this manual.
Usage other than what has been specied here may result in serious injury.
Disassembly, repair or remodeling by an unauthorized person may result in serious harm.•
Do not use if plug is damaged or loose.•
Keep this product out of the reach of children and away from pets.•
Be careful not to put water in the humidity spout.•
Before lling or cleaning the unit, make sure it is unplugged.•
Once the humidier has been turned on, do not move it.•
Do not move when in operation.•
Do not remove the water tank from the unit while it is on.•
Do not handle the adapter plug with wet hands.•
Do not excessively bend, twist or pull the power cord.•
Avoid placing this product where the humidity is pointed directly at an electrical object.•
Do not directly inhale the humidity.•
Do not place this product on a sloped or unstable surface.•
When not in use, unplug the unit.•
Do not ll the water tank with hot or boiling water.•
Do not use this product in direct sunlight, or near a gas stove or heater.•
Do not use if the water tank becomes cracked or damaged.•
Do not keep this product running for an extended period of time.•
Do not clean the unit or water tank with detergents or chemicals of any kind.•
Do not use this product near any other electronic device.•
Do not cover the humidity opening at any time during use.•
Do not use this product near a sink.•
Do not drink water from the water tank.•
Do not place this product on an absorbent surface.•
Do not pour anything but water into the water tank.•
Failure to comply with the warnings listed above may result in electric shock or serious injury.
Make sure the unit is unplugged.
1. Separate the tank from the
body of the unit.
2. Turn water tank over. Open the
tank lid, twisting the cap to the left.
3. Pour cool, clean water directly
into the tank. Do not pour anything
but water into the water tank.
4. Close the tank lid, twisting the
cap to the right.
5. Attach the tank to the body
of the unit.
6. Power Button
Before turning on make sure
there is water in the unit. Press
the POWER button.
7. Cool or Warm
Humidication Button
Press to select cool or warm mist.
Water temperature is maintained
at room temperature for cool
setting and 80 degrees for warm.
8. Spray Control Button
When you press the Spray Control
button there are three options:
Press once for LOW
Press twice for MEDIUM
Press three times for HIGH
*Lights get higher as spray increases.
9. Night Light Feature
Press the Night Lamp button at
the top of the unit to illuminate
the night light feature.
10. Water Rell Button
When the Water Rell button lights
up it is time to rell the water tank.
11. Humidity Spout Direction
To change the direction of
the mist turn humidity spout
as desired.
WARNING: THE CORDS, WIRES AND/OR CABLES SUPPLIED WITH THIS PRODUCT CONTAIN CHEMICALS,
INCLUDING LEAD OR LEAD COMPOUNDS, KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER
AND BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. WASH HANDS AFTER USING.
H1600_0509_Manual.indd 3 5/18/2009 11:57:43 AM
E-6 E-7
Always unplug the unit before servicing it in any way.•
The temperature of the water remaining in the unit after use may be HIGH.•
Do not submerse the unit in water, or allow water to enter the inside of the unit or humidity •
spout. Only put water into the water tank.
INSIDE THE BODY OF THE UNIT
Pour excess water out of the unit, but do not allow it to enter the humidity spout. Wash
out the unit with fresh water, using the cleaning brush and a soft cloth as needed.
OUTER SURFACE OF THE UNIT
Wipe the surface of the unit with a soft, damp cloth if needed.
WATER TANK
If water spots remain in the water tank, wipe the inside with a soft cloth.
DO NOT use soap or detergents.
ULTRASONIC DISK
Remove water tank (Fig. 1) and use the enclosed cleaning brush to regularly remove build up
and deposits from this area (Fig. 2). Diluted white vinegar will help to prevent this build up.
Fig. 1
Fig. 2
Fully dry the inside and outside of the unit before storing it.•
DO NOT leave water in the unit.•
Store in a cool, dry place.•
PROBLEM SOLUTION
Water mist and humidity
are not produced.
Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try again.
Water Tank Installation: Make sure the water tank is
correctly attached. Make sure spring on tank
cap moves freely when pushed.
Air blows but water mist
is not produced.
Excessive Water: Remove water tank. Empty a
small amount of water from the base of the unit.
The desired humidity is lower than the current
temperature: Increase the desired humidity.
Detergent residue in the tank: Wash the tank out
and try again.
Humidity level is low.
The surface of the ultrasonic disk is dirty. Clean
with white vinegar.
The water in the unit is too cold: Replace with cool,
but not cold water.
If ultrasonic disk is damaged contact
Customer Service at 1.866.603.5900.
Warm humidity is not produced. It may take 10-15 minutes before warm
humidity is created. The mist may not feel
warm to the touch.
Check to see if base of unit feels warm to the touch.
If so then warm mist is being produced.
The humidity has a bad smell. Poor maintenance or dirty water: Clean the product
thoroughly, and ll it with fresh water.
White dust is forming on
nearby furniture.
Hard water will deposit a certain amount of
dust. Dust in the air settles because of the
added humidity in the room.
*Use distilled water if this becomes a nuisance.
H1600_0509_Manual.indd 4 5/18/2009 11:57:43 AM
E-8
E-9
To the consumer, Guardian Technologies LLC warrants this product to be free of defects in
materials or workmanship commencing upon the date of the original purchase. Save your
original sales receipt to validate start of the warranty period.
If this product should become defective within the warranty period, we will repair or replace
any defective parts free of charge. The complete machine must be delivered pre-paid to any
authorized Guardian Technologies LLC warranty service center. Please include complete
information on the problem, date of purchase, copy of original sales receipt and your name,
address and telephone number. If you are not near a warranty center, call the factory for
assistance in the US and Canada at 1.866.603.5900. Use only genuine Guardian Technologies
replacement parts.
The warranty does not include unusual wear, damage resulting from accident or
unreasonable use of the product. This warranty does not cover unauthorized repairs.
This warranty gives you specic legal rights and you may also have other rights (other rights
may vary from state to state in the U.S.A.).
We consider the registration process important to ensuring superior service to our
customers, however submitting the warranty card to Guardian Technologies LLC is optional
and does not affect your rights to utilize this warranty according to the conditions stated
above. If you have any questions or comments about our product call toll free at 1.866.603.5900
or send comments to:
This warranty can also be registered online at www.germguardian.com.
ATTN Customer Service
Guardian Technologies LLC
7700 St Clair Avenue
Mentor, Ohio 44060
Guardian Technologies LLC
7700 St Clair Avenue | Mentor, Ohio 44060
1.866.603.5900 | www.germguardian.com
©2007 Guardian Technologies LLC
®
®
Additional Products Available
from Germ Guardian
®
HEAT SANITIZERS
UV-C Room Air Sanitizer
Model No. EV9102
AIR CLEANSING SYSTEMS
UV-C SANITIZERS
Pluggable UV-C Air Sanitizer
Model No. GG1000
UV-C Mini Sanitizer Wand
Model No. LW9
UV-C Sanitizer Wand
Model No. LW18
Toothbrush Sanitizer
Model No. TS3000
Dry Heat
Nursery Sanitizer
Model No. NS2000
Complete Air Cleansing System
Model No. AC6000
Table Top Complete
Air Cleansing System
Model No. AC4000
H1600_0509_Manual.indd 5 5/18/2009 11:57:44 AM
Loading...