Guardian GGU350 User Manual

USE & CARE INSTRUCTIONS

pureguardian

2-in-1 Upright and Canister

with Silver Clean Technology

English E - 1 French F - 1 Spanish S - 1

Replacement Parts:

HEPA Dirt Cup Filter FLTB Exhaust Filter FLTA Belt BLT1

Model No. GGU350TT

1-Year Limited Warranty www.guardiantechnologies.com

1.866.603.5900

REV0411

Date Purchased

month ________ year _________

WARNING:

Cleaner assembly may include small parts. Small parts can present a choking hazard.

E-1

THIS VACUUM IS INTENDED FOR HOUSEHOLD USE ONLY

IMPORTANT SAFETY INSTRUCTIONS

When you use an appliance, basic precautions should always be followed. Please read the entire manual before using this appliance.

•READ ALL INSTRUCTIONS BEFORE USE.

•ALWAYS FOLLOW SAFETY INSTRUCTIONS.

•BRING VACUUM TO AN UPRIGHT POSITION IF NOT USING IN CANISTER MODE TO

USE THE HOSE AND ATTACHMENTS.

•DO NOT LEAVE VACUUM CLEANER UNATTENDED WHEN PLUGGED IN.

•REGULARLY CHECK FILTERS TO CLEAN OR REPLACE.

•DO NOT OPERATE VACUUM WITHOUT FILTERS.

•WARNING: DO NOT USE SHARP OBJECTS TO CLEAN OUT THE HOSE SINCE THEY

COULD CAUSE DAMAGE.

•OCCASIONALLY REMOVE BRUSHROLL AND REMOVE DEBRIS FROM END CAPS TO ENSURE BRUSHROLL ROTATES SMOOTHLY.

•WARNING: THE CORDS, WIRES AND/OR CABLES SUPPLIED WITH THIS VACUUM CONTAIN CHEMICALS, INCLUDING LEAD OR LEAD COMPOUNDS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. WASH HANDS AFTER USING.

WARNING:

To reduce the risk of electric shock, this vacuum has a polarized plug (one blade is wider than the other). This plug will t in a polarized outlet only one way. If the plug does not t fully in the outlet, reverse the plug. If it still does not t, contact a qualied electrician to install the proper outlet. Do not change the plug in any way.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:

•Do not leave appliance when plugged in. Unplug vacuum from wall outlet when not in use and before servicing or performing any maintenance on the unit.

•Do not use outdoors or on wet surfaces. Electrical shock could occur.

•Do not use as a toy. Close attention and supervision is necessary when used by or near

children.

•Use only as described in this manual. Use only manufacturer's recommended attachments and replacement parts such as lters, belts and headlights.

•Do not use with damaged cord or plug. If vacuum is not working as it should, has been dropped, damaged, left outdoors or dropped in water, return it to the manufacturer for service or call 1.866.603.5900 for more information.

•Do not pull or carry by cord, use cord as a handle, close a door on the cord, vacuum over the cord, pull around sharp corners or edges. Keep cord away from heated surfaces.

•Do no unplug by pulling on cord. To unplug, grasp the plug and not the cord.

•Do not handle plug or vacuum with wet hands.

•Do not put any objects into openings. Do not use vacuum with any openings that are blocked.

Keep all openings free of dust, lint, hair and anything that may reduce air ow.

•Keep loose hair, clothing, ngers and all parts of the body away from openings and moving parts.

•Keep animals away from openings and moving parts.

•Do not pick up anything that is burning or smoking, such as cigarettes, matches or hot ashes.

•Do not use without dirt cup container and lters in place. If the vacuum is not working as it

should please call customer service at 1.866.603.5900 or

•Turn off all controls before unplugging.

•Use extra care when cleaning on stairs or under furniture.

•Do not use to pick up ammable or combustible liquids such as gasoline or use in areas where

they may be present.

•Keep the vacuum cleaner on the oor. Only handheld vacuum cleaners may be set on furniture.

•Do not use an extension cord with this vacuum.

•Store the vacuum indoors. Put the vacuum away after use to prevent tripping accidents.

•Using improper voltage may result in damage to the motor and possible injury to the user.

Proper voltage is listed on the data label located on the vacuum cleaner.

SAVE THESE INSTRUCTIONS

www.guardiantechnologies.com.

E-2

E-3

PLEASE READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE

WARNING! Do not use the Dirt Cup Handle to move the cleaner.

THERMAL RESET BUTTON:

Operates due to overheating, caused by a full dirt cup, clogged lter or blocked pipes.

Unplug the cleaner and remove the blocked materials. To operate again, after

cooling down the cleaner about 30 minutes, press the Thermal Reset Button.

HOSE CRADLE ASSEMBLY

• Set hose cradle on the top of the cleaner. (Fig. 1)

• Using a Phillips screwdriver, secure the 3/4-inch screw.

Model .................................................. GGU350TT

Rating .................................................. 120V/60Hz

Amperage ............................................... 12 amps

Weight (Net) .......................................... 20.50 lbs

Dimensions ............................. 15" x 14" x 45.25"

Main Power

Brush Power

Switch

Hose Connector

Height Setting

Height Adjustment

Control

Knob

Switch

Filter

Dirt Cup Handle

Dirt Cup

Cord Length .............................................. 32 feet

Inner Filter .......................................... HEPA Filter

Exhaust Filter .................................. Micron Filter

Headlight ......................................................... Yes

Belt .................................................................... Yes

Handle

Extension

Button

Handle Inlet

Body

Cord

Storage

Hooks

Canister

Handle

Cord Clip

Handle Hose Connector

(TOOLS/CANISTER MODE)

Hose Cradle

Hose

Hose Clip

Handle Removal

Button

Base Hose Connector

(UPRIGHT MODE)

Fig. 1

VACUUM ASSEMBLY: UPRIGHT USE

HOSE ASSEMBLY

• Insert the body end of the hose into the hose inlet on the top of the cleaner. (Fig. 2)

• Line up circular tab on hose cuff with inner groove. (Fig. 2)

• Connect and twist clockwise to secure proper hose connection. (Fig.3)

• Place hose in hose cradle. (Fig. 4)

• Insert the base end of the hose into the hose inlet on the base of the cleaner. (Fig. 5)

IMPORTANT: Hose must be connected to inlet on base of vacuum to work in the UPRIGHT mode.

E-4

Canister

Release Pedal

Headlight

Base

Thermal Reset

Button

Handle Release

Pedal

Cord

Plug

Fig. 2

Fig. 4

Fig. 3

Hose

Base Hose Connector

Fig. 5

E-5

+ 5 hidden pages