GUANGZHOU SEANY STAGE LIGHTING EQUIPMENT CO.,LTD SC-1200 User Manual

User Manual

SC-1200

Read and save these instructions

GUANGZHOU SEANY STAGE LIGHTING EQUIPMENT CO.,LTD

Introduction

Thank you for having chosen our company's snow machine. Please read this user manual
carefully before installing the device. By following the suggestions found in this manual,
you can look forward to the reliable and satisfactory performance of your snow machine
for years to come.

Specifications

Voltage : AC220-240V, 50-60Hz
Power : 300W
Fuse : 5A
Fluid Tub Volume : 5L
Fluid Consumption : 8L/H
N. W. : 8.5Kgs, G. W. : 9.8.Kgs
Packaging volume(mm) : 580*330*350

UNPACKING & INSPECTION

Open the shipping carton and verify that call equipment necessary to operate the system
has arrived intact. Included with your SC-1200 Snow Machine should be the following
items:

1. This user manual.

2. Power cord.

3. Wired adjustable output control attach 5M cord.

*Snowflake fluid sold separately.

If any equipment is missing, contact your dealer immediately. Before beginning initial
setup of your snow machine, make sure that there is no evident damage
caused by transpiration. In the event that the unit's housing or cable is damaged, do not
plug it in and do not attempt to use it until after contacting tour dealer for assistance.

SETUP

1.Remove all packing materials from shipping box, check that all foam and plastic is
removed, especially in the nozzle area.

2.Place snow machine on a flat surface and remove snow liquid tank cap. Fill with snow
liquid or other high-quality water-based snow liquid. Any other types of liquid can
damage the unit. When filled, place cap back on liquid tank.

3.Firmly attach control cable to the proper input on the rear of the machine.

OPERATION

1. Open the cover of the liquid jug and pour the special snow liquid into the judge.

2.Use the standard 3-core shielded signal cable to connect the control box, the
mainframe and the by-frame.

3. Insert the plug of the power supply socket of the back panel of the machine, turn the
power supply switch of the machine, ON/OFF to ON and then the red indication light
on the control box will be on (POWER).