GTPro VC 320, VC 321 Instruction Manual

10011433_001
CSR Tools & Consumables Triniti 3, Level 5 39 Delhi Road North Ryde NSW 2113 Australia http://www.csr.com.au
Vacuum cleaner Instruction manual
IMPORTANT: Read and understand all instructions before using.
VC 320/321
1-7
1-6
1-8
1-9
1-5
1-4
1-3
1-2
1-1
1
2
3
1
1
2
4
5
FB-VC 320/321 10011591
1
2
3
4
3
2
1
6
7
4
NEW
1
2
3
4
6
5
7
HF-VC 320/321 10011592
NF-VC 320/321 10011593
6
VC 320/321
Original operating manual
1Safety instructions
Warning! Read and observe all information and safety instructions.
Ignoring warn-
ing notes and instructions may lead to electric shocks, fires and/or cause serious injury.
Keep all safety information and other instructions in a safe place for future reference.
– This machine can be operated by
children
over 8 years of age and persons with re­duced physical, sensory or mental capabilities or a lack of practical experience and knowledge, provided they are supervised or have been instructed to use the ma­chine safely and understand the dangers of machine operation.
Children
must not
play with the machine.
Cleaning and user maintenance
may not be performed by
children
without supervision.
Risk of explosion and fire hazard: do not extract
sparks or hot dust, flammable or explosive dust (e.g. magnesium, aluminium, petrol, thinner, with the exception of wood), aggressive fluids/solids (e.g. acid, leach, solvent).
– Observe all national safety regulations as well as the material manufacturer's spec-
ifications!
– Not suitable for extracting hazardous dust. – Always use suitable protective equipment! – If intact following a visual inspection, work in a dry environment according to in-
structions!
– If foam or fluid starts to escape, switch off the machine immediately. – Clean the fill level sensors
[7]
and inspect for damage at regular intervals. – Not suitable for extracting fluids that foam excessively. – Always operate with the filter system installed. – Always use the socket on the machine for the purpose specified! –
Check the plug and the cable regularly and should either become damaged, in order
to avoid a hazard, have them replaced by an authorised after-sales service workshop. – Do not lift or transport using a crane hook or lifting gear! –
Only for AS/NZS:
The tool shall always be supplied via residual current device with
a rated residual current of 30 mA or less.
VC 320/321
7
2Symbols
3Technical data
4 Machine features
The specified illustrations appear at the beginning of the Operating Instructions.
5 Intended use
Mobile dust extractor suitable for
– Extracting non-hazardous dust, dirt, sand and
chips, –Extracting water, – Increased loads during commercial use,
according to IEC/EN 60335-2-69.
The user is liable for improper or non-in­tended use.
6Operation
Warning of general danger
Risk of electric shock
Read the Operating Instructions/Notes!
Disconnect from the power supply!
Wear a dust mask.
Do not throw in the household waste.
Extracting fluids.
Mobile dust extractors
Power consumption 400 - 1200 W Maximum appliance socket connected load EU (230 V, 50 Hz)
CH, DK (230 V, 50 Hz)
GB (240 V, 50 Hz)
AUS (240 V, 50 Hz)
2400 W 1100 W 1800 W
1200 W Max. suction capacity (air), extractor/turbine 3000 l/min / 3700 l/min Max. vacuum, turbine 24000 Pa Filter surface area 4600 cm² Suction hose D 36 mm x 3 m Length of the net cable 5,5 m Sound pressure level as per EN 60704-2-1 / Uncertainty K 74 dB(A) / 3 dB Protection category IP X4 Safety class I Container capacity 32 l Dimensions L x W x H 550 x 380 x 485 mm Weight 9,9 kg
[1-1]
Intake opening
[1-2]
Switch
[1-3]
Suction power adjuster (only VC 321)
[1-4]
Appliance socket
[1-5]
Folding handle
[1-6]
Locking clip
[1-7]
Dust container
[1-8]
Cable/hose holder
[1-9]
Exhaust opening
WARNING
Unauthorised voltage or frequency! Risk of accidents
Observe the specifications on the machine’s name plate.
Observe country-specific regulations.
8
VC 320/321
6.1 Initial operation
Open the locking clips and remove the top sec­tion of the machine
[2]
.
Remove accessory parts and accompanying documents
[3]
.
Insert a filter bag
[4]
.
6.2 Connecting the suction hose
For extracting material at the intake opening
[1-1]
For blowing out material from the exhaust opening
[1-9]
6.3 Connecting the mobile dust extractor
The switch
[1-2]
serves as an on/off switch.
Switch position "0"
Appliance socket
[1-4]
is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket
[1-4]
is connected to the power,
the mobile dust extractor starts.
"Auto" switch position
Appliance socket
[1-4]
is connected to the power, the mobile dust extractor starts when the connect­ed tool is switched on.
Insert the plug into an earthed socket.
Pull the plug from the socket when the ma­chine is not in use and prior to maintenance and cleaning work.
6.4 Connecting electric power tools
Connect the electric power tool to the appliance socket
[1-4]
.
6.5 Adjusting the suction power (only VC 321)
Use the rotary knob
[1-3]
.
7Working
7.1 Dust extraction
Do not operate the machine without a main filter. This may damage the motor.
Extracting dry materials
Always use a filter bag.
Extracting wet materials/liquids
Remove the filter bag! Insert a special wet filter.
The dust extractor stops automatically when the maximum level is reached.
After wet extraction, allow the main filter to dry!
7.2 After finishing work
Switch off the mobile dust extractor and pull out the mains plug.
Wind up the mains power cable.
Empty the dirt trap.
Place the mobile dust extractor in a dry room in­accessible to unauthorised users.
8 Service and maintenance
8.1 Filter bag / main filter
Remove the filter bag
[5]
.
Insert the filter bag
[4]
.
Change the main filter
[6]
.
Dispose of the used filter in accordance with statutory regulations.
WARNING
Risk of injury from tools starting up unexpectedly
Before setting the switch to the "AUTO" or "MAN" position, make sure that the connected tool is switched off.
WARNING
Risk of injury
Observe the maximum appliance socket con­nected load (see chapter "Technical data")
Switch off the electric power tool.
CAUTION
Escaping foam and fluids
Switch off and empty the machine immediately.
WARNING
Risk of injury, electric shock
Always disconnect the mains plug from the socket before performing maintenance work on the machine!
All maintenance and repair work which requires the motor housing to be opened must only be carried out by an authorised service workshop.
VC 320/321
9
9Environment
Do not dispose of the device in house­hold waste!
Recycle devices, accesso­ries and packaging. Observe applica­ble country-specific regulations.
10 EU Declaration of Conformity
We declare under sole responsibility that this product complies with all the relevant requirements in the fol­lowing Directives, standards and normative documents:
2006/42/EC, 2004/108/EC, 2011/65/EU, EN 60335-1, EN 60335-2-69, EN 55014-1, EN 55014-2, EN 61000­3-2, EN 61000-3-3.
CSR Tools & Consumables
Triniti 3, Level 5, 39 Delhi Road, North Ryde, NSW 2113, Australia
John Rae Product Manager 2013-06-06
Mobile dust extractor Serial no.
VC 320
10011533
Year of CE mark: 2013
Loading...