GT-Lite GT-SL1 Assembly And Installation Instructions Manual

GT-SL1

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

GT-SL1

180° MOTION ACTIVATED LED FLOODLIGHT

Questions, problems, missing parts? Please contact

1-800-865-6799

THANK YOU!

WARNING

：

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER

WHILE INSTALLING OR SERVICING THIS FIXTURE.

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO
SHUT OFF POWER BEFORE INSTALLING OR SERVICING

THIS FIXTURE

GT-SL1

Safety Information

WARNING:

□ Risk of fire/electric shock. If not qualified, consult an electrician

□ Disconnect power at fuse or circuit breaker before installing or servicing

CAUTION:

□ Connect fixture to a 120-volt, 60Hz power source. (Any other connection voids warranty.)

□ Fixture should be installed by persons with experience in household wiring or by a qualified electrician. The

electrical system and the method of electrically connecting this fixture to it must be in accordance with the

National Electrical Code and local building codes.

□ Suitable for wall mount or eave mounting onto recessed or mounted electrical boxes rated for wet locations.

Not suitable for ground mount installation.

□ DO NOT remove the protective LED lens.

□ DO NOT look directly at lighted LEDs for any length of time.

□ DO NOT leave bare wires exposed outside the wall canopy enclosure.

□ For proper operation and protection against damage, the motion sensor head adjustment knobs must be

facing the ground.

□ DO NOT mount below 5 feet.

IMPORTANT SAFETY INFORMATION:

When using product, basis precautions should always be followed, including the following:

□ Read and follow these instructions.

□ Heed all warnings, including below warnings AND those included on product.

□ Save these instructions and warnings.

□ For outdoor use only.

□ Disassembling your fixture will void the warranty.

□ Your fixture is prewired and preassembled for easy installation.

Pre-Installation

Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and
hardware contents. If any part is missing or damaged, do not attempt to assemble the product.

Estimated Assembly Time: 30~45 minutes.

Select the installation location carefully. Do not install in areas having pedestrian or motorized traffic, pools or bodies
of water, or trees/bushes that move in the wind. All of these may trigger the motion sensor security light and may be

GT-SL1

disruptive to the intended operation of the light. Do not install near sources of light. The other light sources can fool
the dusk to dawn sensor into thinking it is daylight.

TOOLS REQUIRED:

HARDWARE INCLUDED

Part

Description

Quantity

AA

Gasket(not to Scale)

1

BB

#6-32×3/4 in. junction box screw

2

CC

#8-32×3/4 in. junction box screw

2

DD

Mounting Strap 1 EE

Wire Nut

3

FF

Fixture Mounting Screw

1

GG

O Ring

1

Philips Screwdriver

AA

BB

CC

DD

EE

FF

GG