GTEK M23 User Manual

Mini Bt speaker user manul

1) the bluetooth speaker power support (3.7 4.2 V battery or USB
power supply 5 V).

2) long press PWR key 3 seconds boot, blue LED and red LED flash
alternately, that has entered the BT speaker can be paried
State, can be connected to the bluetooth device paring.

3) if the last pairing set online, BT speaker will connect the bt

device automaticly, after boot .

4) will be the last paired device close bluetooth, BT speaker after

boot can enter the can paring mode ,paring connection with
other BT equipment.

5) the bluetooth speaker if you already have and bluetooth

connection is established, can transmit music of bluetooth
devices(such as mobile phone).Through short press NEXT/VOL
+ select a song on music, short press the PREV/VOL - choose
the NEXT song music, long press NEXT/VOL + control the
volume growth, a long press on the PREV/VOL - controls the
volume reduction, short press PWRS control pause or play.

6) insert AUX line can enter the LINE IN die try play an external

audio source.Pull out LINEIN line back to bluetooth mode or
standby mode.

7) i f with mobile phone bluetooth connection is established, a call,

by short press the bluetooth phone to pick And end calls.When
we have to long press the bluetooth telephone refused.
Double-click the bluetooth phone keys automatically back to
dial the phone number of the mobile phone calls recently.

8) if the bluetooth connection is established, long press the tell key,

enter the remote take picture mode, short press tell key,
photograph.

FCC STATEMENT :

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.

RF warning statement:

The device has been evaluated to meet general RF exposure requirement. The device can
be used in portable exposure condition without restriction.