GS Racing Vision RTR Instruction Manual

1 / 10 SCALE RADIO CONTROLLED GAS POWERED RACING TOURING CAR

Width/198 mm (7.8")

Height/104 mm (4.1")

Track: 172 mm (6.8")

Length/380 mm (15.0")

Wheelbase/260 mm (10.2") Gear Ratio/Low 7.55:1/High 5.82:1 Ground Clearance Front~Rear/4.5~5.5 mm (0.18-0.22")

VISION RTR/Required for Operation Assembly General Information

Parts Name List

Optional Parts List

Foam Tire Part List Exploded View (1) Exploded View (2) Engine Parts List

Set-up Sheet

.30-31

This radio controlled racing car is not a toy! This high-performance R/C model is recommended for ages 14 and older.

2-3

4-13 14-18 19-22 23-24

26-27

28 29

Thank you for purchasing the GS Racing VISION RTR nitro powered radio controlled touring car.

Please read through all the instructions carefully before you attempt to operate your VISION RTR. This manual contains building steps and instructions to help you for the assemble/disassemble on your VISION RTR. Follow the directions in this manual closely so you don't encounter any problems on start up. We hope that you will enjoy your new GS Racing nitro VISION RTR. If you ever have any questions or need the further setup help, please feel free to contact our official dealers. See you at the track!

Required Equipment for Operation

1. Tools required for building and maintenance:

• Hobby knife

• Needle nose pliers

• Precision ruler or caliper

• Phillips screwdriver (#0, #1, #2)

• Hobby scissors

• Wire cutters

• Thread locking compound

• CA glue

• Rubber cement

• Snap ring pliers

WARNING!

Do not use a power screwdriver to install screws into nylon or plastic materials. The fast rotation speed can heat up the screws being installed. They can then break the molded parts or strip the threads during installation.

2. Additional items needed for operation Vision RTR #GS 410412 (Gsc 412):

• 4-AA batteries for receiver /8-AA batteries transmitter

• Shock, diff., and air filter oils, and grease

• Glow igniter, glow fuel, and fuel bottle