Page 1
HOT AIR
HAIR STYLER
HS 4020
Page 2
__________________________________________________________________
2
ENGLISH
2
A
1 2
B
C
D
E
F
Page 3
ENGLISH
3
Please note the following instructions when
using the appliance:
7
This appliance is intended for domestic use
only.
7
Never use the appliance in the bath, shower
or over a wash basin filled with water; nor
should it be operated with wet hands.
7
Do not immerse the appliance in water or let
it come into contact with water, even during
cleaning.
7
Do not use the appliance near water in bathtubs, wash basins or other vessels.
7
If the appliance is used in the bathroom, it is
essential that the power plug is pulled out
after use, as water close to the appliance can
still pose a hazard, even if the appliance is
switched off.
7
If not already in use, for additional protection
it is recommend to install a residual-currentoperated protective device (RCD) with a
rated residual operating current not exceeding 30 mA in the electrical circuit of your
bathroom.
Ask your plumber for advice.
7
Never place the appliance on soft cushions
or blankets during operation.
7
Ensure the air intake and outlet openings are
not covered during operation.
7
The appliance is equipped with an overheating protection system.
7
Pull out the power plug after use. Do not disconnect the plug by pulling on the cable.
7
Never use the appliance if it or the power
cord is visibly damaged.
7
If the power cord is damaged, it must be
replaced by the manufacturer, its service centre or a similarly qualified person to prevent
danger arising.
7
Keep the appliance out of the reach of
children.
7
The appliance may not be used by the
following people, including children: persons
with limited physical, sensory or mental
capabilities and also those with a lack of
experience and knowledge. This does not
apply to the latter if they were instructed in the
use of the appliance or if they use it under the
super-vision of a person responsible for their
safety. Children should always be supervised
to ensure that they do not play with the
appliance.
7
Do not open the appliance under any circumstances. No warranty claims are accepted for
damage caused by improper handling.
7
A very warm flow of air is required to achieve
a perfect result.
Please note that a metallised brush can
become extremely hot during prolonged or
intensive use.
To avoid injury, adjust the usage time of the
appliance to the accessory being used.
SAFETY
____________________________________________________________________
Page 4
4
ENGLISH
Dear customer,
Congratulations on the purchase of your
HS 4020 professional Hair Styler.
Please read the following instructions carefully
to allow you to enjoy your quality product from
Grundig for many years to come.
Special features
The hot air brushes of your Hair Styler have
ceramic coatings so that they are especially
gentle on your hair.
7
The size of curls depends on the diameter of
the styling attachment in use.
7
The ø 25 mm styling attachment is suitable for
smaller curls and waves.
7
The ø 38 mm styling attachment is suitable for
softly cascading hair styles such as larger
curls and waves.
A responsible approach!
GRUNDIG focuses on contractually
agreed social working conditions
with fair wages for both internal
employees and suppliers, as well as
on the efficient use of raw materials with continual waste reduction of several tonnes of plastic
each year – and availability of at least 5 years
for all accessories.
For a future worth living.
For a good reason. Grundig.
Control elements
Detachable hot air brush (styling attachment)
Catch for detaching the styling attachment
Switches the device on and off.
Controller for two temperature and blower
levels and cold air setting
Swivelling power cord
Air inlet grille
Handle
Accessories
Ceramic-coated heated brush, medium,
ø 38 mm
Ceramic-coated heated brush, small,
ø 25 mm
2
1
F
E
D
C
B
A
OVERVIEW
__________________________________________________
Page 5
ENGLISH
5
Settings
Your appliance has the following setting
options:
Temperature level/blower level
– 0 : off
–
1 : gentle air flow and moderate temperature
for gentle drying and styling
–
2 : stronger airflow and high temperature for
fast drying and styling
Cold air setting
– : interrupts the hot air supply and provides
cold air for fixing a hairstyles
Changing the styling attachments
1 Remove the styling attachment currently in
place by pressing the catch and pulling off
the heated brush.
2 Place on a different styling attachment and
allow to latch in place. The two markings (
.
)
must be opposite each other.
Notes:
7
The size of curls depends on the diameter of
the styling attachment in use.
7
The styling attachment with a diameter of
25 mm creates small and medium curls and is
especially suitable for short hair.
7
The styling attachment with a diameter of
38 mm can be used to attain greater volume
with longer hair.
B
C
C
Operation
Check if the mains voltage on the type plate (on
the handle of the appliance) corresponds to
your local mains supply.
1 Towel dry your hair thoroughly after washing.
2 Plug the power cord into the wall socket.
3 Turn on the appliance with the switch and
set the temperature/blower level.
4 If required you can interrupt the hot air sup-
ply when drying by turning the switch to
»« (cold air setting).
Note
7
The cold air setting interrupts the hot air operation and provides a cool air flow. This
allows you to fix your hairstyle better and
more lastingly.
5 After use, switch off the appliance with the
button and pull out power cord from
the wall socket.
Caution
7
Never wind the power cord around the appliance, as this can result in damage.
Check the power cord and the appliance
regularly for visible damage.
Cleaning and care
Pull the plug out before cleaning.
Never submerge the appliance in water.
Use a soft dry cloth for cleaning the housing.
Remember to clean the air inlet grille occasionally with a soft brush to remove any hairs
and dust.
E
D
C
C
C
D
OPERATION
___________________________________________________________
Page 6
Environmental note
This product has been made from high-quality
parts and materials which can be re-used and
recycled.
Therefore, do not throw the product away with
normal household waste at the end of its service
life. It should be taken to a collection point for
recycling electrical and electronic devices. This
is indicated by this symbol on the product, in the
operating manual and on the packaging.
Please find out about collection points operated
by your local authority.
Help protect the environment by recycling used
products.
Technical data
This product conforms to the
European directives
2004/108/EC, 2006/95/EC and
2009/125/EC.
Power supply
230 – 240 V~, 50 – 60 Hz
Power
750 – 800 W
Technical and design modifications are
reserved.
ENGLISH
6
INFORMATION
______________________________________________________
Loading...