1 Important instructions for safety and environment
This section contains safety instructions that
will help protect from risk of personal injury
or property damage. Failure to follow these
instructions shall void any warranty.
1.1 General safety
• This product can be used by children at
and above 8 years old and by persons
whose physical, sensory or mental
capabilities were not fully developed or
who lack experience and knowledge
provided that they are supervised or
trained on the safe usage of the product
and the risks it brings out. Children must
not play with the product. Cleaning
and maintenance works should not be
performed by children unless they are
supervised by someone.
• Unplug the product if a failure occurs while
it is in use.
• If the product has a failure, it should not
be operated unless it is repaired by the
Authorised Service Agent. There is the risk
of electric shock!
• Connect the product to a grounded
outlet protected by a fuse complying with
the values in the rating plate. Have the
grounding installation made by a qualified
electrician. Our company shall not be
liable for any damages that will arise when
the product is used without grounding in
accordance with the local regulations.
• Unplug the product when not in use.
• Never wash the product by spreading or
pouring water onto it! There is the risk of
electric shock!
• Never touch the plug with wet hands!
Never unplug by pulling on the cable,
always pull out by grabbing the plug.
• It is recommended to clean the tip of the
plug regularly with a dry cloth.
• Do not plug the refrigerator if the wall
outlet is loose.
• Never connect your refrigerator to
electricity-saving systems. Such systems are
harmful for the product.
• Unplug the product during installation,
maintenance, cleaning and repairing
procedures.
• Always have the installation and repairing
procedures carried out by the AuthorisedServiceAgent. Manufacturer shall not
be held liable for damages that may
arise from procedures carried out by
unauthorised persons.
• Do not eat cone ice cream and ice cubes
immediately after you take them out of
the freezer compartment! This may cause
frostbite in your mouth!
• Do not touch frozen food by hand! They
may stick to your hand!
• Do not put bottled and canned liquid
beverages in the freezer compartment.
They may burst!
• Never use steam and steam assisted
cleaning materials to clean or defrost the
refrigerator. Steam will cause short circuit
or electric shock since it would get into
contact with the electrical parts in the
refrigerator!
• Do not use mechanical devices or other
methods to accelerate the defrosting
process, other than those recommended by
the manufacturer.
• Never use the parts on your refrigerator
such as the door and drawer as a means
of support or step. This will cause the
product to tip over or parts of it get
damaged.
• Do not damage the cooling circuit, where
the refrigerant is circulating, with drilling
or cutting tools. The refrigerant that might
blow out when the gas channels of the
4 / 20 EN
Refrigerator/User Manual
Important instructions for safety and environment
evaporator, pipe extensions or surface
coatings are punctured may cause skin
irritations and eye injuries.
• Do not cover or block the ventilation holes
on the refrigerator with any material.
• Place the beverage with higher proofs
tightly closed and vertically.
• Do not use gaseous sprays near the
product since there is the risk of fire or
explosion!
• Flammable items or products that contain
flammable gases (e.g. spray) as well as the
explosive materials should never be kept in
the appliance.
• Do not place containers filled with liquid
on top of the product. Spilling water on an
electrical component may cause electric
shocks or risk of fire.
• Do not store products (vaccines, heatsensitive medicines, scientific materials and
etc.) that require a precise temperature
control in the refrigerator.
• If you will not operate the product for a
long period of time, unplug and unload the
food in it.
• If the product is equipped with blue light,
do not look at the blue light with optical
tools.
• Exposing the product to rain, snow, sun
and wind is dangerous with respect to
electrical safety.
• In products with mechanical control
(thermostat), wait for minimum 5 minutes to
plug in the product again after unplugging
it.
• Do not overload the product. It may fall
when the door is opened, and cause injury
or damage. Similar problems may occur in
case of putting things on top of the product.
• If the product's door is equipped with a
handle, do not pull by the handle when
changing the place of the product. Handle
may get loose.
• Pay attention not to have your hand or
any part of your body get caught by the
moving parts inside the product.
1.1.1 HCA warning
• If the product is equipped with a cooling
system containing R600a gas, pay
attention not to damage the cooling
system and piping during usage and
transportation. This gas is flammable.
If the cooling system is damaged, keep
the product away from potential sources
that can cause the system catch a fire
and ventilate the room in which the unit is
placed immediately.
If the product is equipped with a
cooling system containing R134a gas,
C
C
A
ignore this warning.
You can learn the gas used in
production of your product on the
rating plate located on the left inner
part of it.
WARNING:Never dispose the product
in fire.
1.1.2 For products with
a water dispenser
• Pressure of water mains should be minimum
1 bar and maximum 8 bars.
• Use only potable water.
1.2 Intended use
• This product has been designed for
domestic use. It is not suitable for
commercial use and it must not be used out
of its intended use.
• Product must be used only for storing food.
• The manufacturer waives any responsibility
arisen from incorrect usage or
transportation.
• The service life of your product is 10 years.
During this period, original spare parts
will be available to operate the appliance
properly.
Refrigerator/User Manual
5 / 20 EN
Important instructions for safety and environment
1.3 Children's safety
• Packaging materials are dangerous for
the children. Keep packaging materials
in a safe place away from reach of the
children.
• Electrical products are dangerous for the
children. Keep children away from the
product when it is in use.
• If the product's door is equipped with a
lock, keep the keys away from reach of
children.
1.4 Compliance with WEEE
Directive and Disposing
of the Waste Product:
This product complies with EU WEEE
Directive (2012/19/EU). This
product bears a classification
symbol for waste electrical and
electronic equipment (WEEE).This
product has been manufactured
with high quality parts and
materials which can be reused
and are suitable for recycling. Do
not dispose of the waste product with normal
domestic and other wastes at the end of its
service life. Take it to the collection center for
the recycling of electrical and electronic
equipment. Please consult your local
authorities to learn about these collection
centers.
1.6 Package information
Packaging materials of the product are
manufactured from recyclable materials in
accordance with our National Environment
Regulations. Do not dispose of the packaging
materials together with the domestic or other
wastes. Take them to the packaging material
collection points designated by the local
authorities.
1.5 Compliance with
RoHS Directive:
The product you have purchased complies
with EU RoHS Directive (2011/65/EU). It
does not contain harmful and prohibited
materials specified in the Directive.
Figures in this user manual are schematic and may not match the product exactly. If the subject
parts are not included in the product you have purchased, then those parts are valid for other
C
models.
Refrigerator/User Manual
7 / 20 EN
3 Installation
Refer to the nearest Authorised Service Agent
for installation of the product. To make the
product ready for use, make sure that the
electricity installation is appropriate before
calling the Authorised Service Agent. If
not, call a qualified electrician to have any
necessary arrangements carried out.
Preparation of the location and
electrical installation at the place
C
B
B
A
C
3.1 Appropriate
A
• Choose a place at where you would use
• Install the product at least 30 cm away
of installation is under customer's
responsibility.
Product must not be plugged in during
installation. Otherwise, there is the risk
of death or serious injury!
WARNING:Installation and electrical
connections of the product must be
carried out by the Authorised Service
Agent. Manufacturer shall not be held
liable for damages that may arise from
procedures carried out by unauthorised
persons.
WARNING:Prior to installation, visually
check if the product has any defects
on it. If so, do not have it installed.
Damaged products cause risks for your
safety.
Make sure that the power cable is not
pinched or crushed while pushing the
product into its place after installation
or cleaning procedures.
installation location
WARNING:If the door of the room
where the product will be placed is too
small for the product to pass, then the
product's doors must be removed and
the product must be turned aside to
pass it through.
the product comfortably.
from heat sources such as hobs, ovens,
heater cores and stoves and at least 5 cm
away from electrical ovens. Product must
not be subjected to direct sun light and
kept in humid places after installation.
• Appropriate air ventilation must be
provided around your product in order
to achieve an efficient operation. If the
product is to be placed in a recess in the
wall, pay attention to leave at least 5 cm
distance with the ceiling and side walls.
• Do not place the product on the materials
such as rugs or carpets.
• Place the product on an even floor surface
to prevent jolts.
• Your product can operate in ambinet
temperatures between -15°C to +43°C.
If two coolers are to be installed side
by side, there should be at least 4 cm
C
3.2 Installing the
Plastic wedges are used to create the distance
for the air circulation between the product
and the rear wall. Insert the 2 plastic wedges
onto the rear ventilation cover as illustrated
in the figure. To install the wedges, remove
the screws on the product and use the screws
given in the same pouch with the wedges.
distance between them.
plastic wedges
8 / 20 EN
Refrigerator/User Manual
Installation
3.3 Electrical connection
Connect the product to a grounded outlet
protected by a fuse complying with the values
in the rating plate. Our company shall not be
liable for any damages that will arise when
the product is used without grounding in
accordance with the local regulations.
• Electrical connection must comply with
national regulations.
• Power cable plug must be within easy
reach after installation.
• The voltage and allowed fuse or breaker
protection are specified in the Rating Plate
which is affixed to interior of the product.
If the current value of the fuse or breaker
in the house does not comply with the
value in the rating plate, have a qualified
electrician install a suitable fuse.
• The specified voltage must be equal to
your mains voltage.
• Do not make connections via extension
cables or multi-plugs.
WARNING:Damaged power cable
must be replaced by the Authorised
B
B
Service Agents.
WARNING:If the product has a failure,
it should not be operated unless it is
repaired by the Authorised Service
Agent! There is the risk of electric
shock!
Adjusting the legs
If your refrigerator is unbalanced;
You can balance your refrigerator by turning
its front legs as illustrated in the figure. The corner where the leg exists is lowered when you
turn in the direction of black arrow and raised
when you turn in the opposite direction. Taking
help from someone to slightly lift the refrigerator will facilitate this process.
Refrigerator/User Manual
9 / 20 EN
Installation
Replacing the interior lamp
Should the light fail to work, proceed as
follows.
1. Switch off at the socket outlet and
pull out the mains plug.You may find it
useful to remove shelves for easy access.
2. Use a flat tipped screwdriver to
remove the light diffuser cover.
3. First check that the lamp hasn’t
worked loose by ensuring it is screwed
securely in the holder. Replace the plug
and switch on.
4. If the lamp works, replace the light
cover by inserting the rear lug and pushing
up to locate the front two lugs.
5. If the light still fails to work, switch off
at the socket outlet and pull out the mains
plug. Replace the lamp with a new 15 watt
(max) screw cap (SES) lamp.
6. Carefully dispose of the burnt-out
lamp immediately.
7. Replacement light lamp can easily be
obtained from a good local electrical or
DIY store.
10 / 20 EN
Refrigerator/User Manual
Installation
Installation (Under the counter)
• Internal height of the counter should be
820mm.
• (!) Cookers or other heat sources must not
be placed above the counter where the
appliance is installed under the counter.
• The mains wall socket plug must be close to the right or left hand side of the appliance.
• Remove the top cover of the appliance.
There are 4 screws(2 pieces at the back,
2 pieces below the front edge) that should
be removed. Fig. 1
• Cut the part shown in the picture and then
remove it by the help of pliers.
• Place you appliance under the counter
and adjust the front feets until its top touches to the counter.
• In order to use the product under the counter, the distance between the wall and the
reference indicated in the top connection
plastic must be minimum 595 mm.
Fig. 2-3
• Fix the appliance under the counter by
using 2 of the screws that was removed
from the top cover.(Material of the counter
must be plastics or wood based!)
Fig. 4
Refrigerator/User Manual
11 / 20 EN
Installation
Reversing the doors
a
a
c
b
b
e
d
1
595 mm
55 mm
820 mm
2
3
bb
12 / 20 EN
4
Refrigerator/User Manual
Installation
a
Reversing the doors
C
H
E
B
D
F
A
G
I
Refrigerator/User Manual
13 / 20 EN
Installation
60°
9
14
60°
5
17
18
16
10
2
3
4
8
7
7
12
12
11
11
6
6
15
13
Reversing the doors
1
14 / 20 EN
Refrigerator/User Manual
Loading...
+ 31 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.