Grundig GCD8302E User Manual
COLOR TELEVISION
P 37-070
P 37-731/12 text
ķ
44
Connection Possibilities
Ń
!
Additional Information for Units sold in Great Britain
Units sold in GB are suitable for operation from a 240 V AC, 50 Hz mains
supply.
In case this appliance is supplied with a Safet
y Standard Approved mains
lead fitted with a non-rewireable 13 Amp mains plug which, if unsuitable for
your socket, should be cut off and an appropriate plug fitted by a
qualified electrician. The fuse and fuse holder must be removed from the
plug as accidental insertion of the redundant plug into a 13 Amp socket is
likely to cause an electrical hazard.
Note: The severed plug must be destroyed to avoid a possible shock
hazard should it be inserted into a 13 Amp socket elsewhere.
If it is necessary to change the fuse in the non-rewireable plug, the correct
type and rating (5 Amp ASTA or BSI approved BS 1362) must be used and
the fuse cover must be refitted. If the fuse cover is lost or damaged the lead
and plug must not be used until a replacement is obtained. Replacement
fuse covers should be obtained from your dealer.
If a non-rewireable plug or a rewireable 13 Amp (BS 1363) plug is used, it
must be fitted with a 5 Amp ASTA or BSI approved BS 1362 fuse. If any
othe type of plug is used it must be protected by a 5 Amp fuse either in the
plug or at the distribution board.
Important:
The wires in the mains lead are coloured in accordance with the following code:
BLUE – NEUTRAL
BROWN – LIVE
As the colours of the wires in the mains lead of your appliance may not correspond with
the coloured marking identifying the terminals in your plug, proceed as follows:
Connect the BLUE coloured wire to plug terminal marked with the letter "N" or coloured
black.
Connect the BROWN coloured wire to the plug terminal marked with a letter "L" or colou-
red red.
In no circumstance must any of the wires be connected to the terminal marked with a let-
ter "E", earth symbol , coloured green or green and yellow.
Replacement mains lead can be obtained from your dealer.
Safety and Installation
ķ
45
r
Notes on safety
Ń
!
If the television is to be built into a compartment or similarly enclosed, minimum distances must be maintained (10 cm at the sides, 20 cm on the top).
Ń
!
Do not obstruct the ventilation openings at the back.
Heat build-up can reduce the service life of your television, and can also be
dangerous. Never place the television near heat sources.
Ń
!
When setting up and using this unit, please make sure that the mains
connection wire is free and not jammed in order to avoid damage.
Ń
!
Even if your television is switched off, it can still be damaged by lightning
striking the mains and/or aerial cables. For this reason, you should always
disconnect your television from the mains and the aerial system during
thunderstorms.
Ń
!
Do not expose the set to moisture (eg: dripping or splashing).
Ń
!
Do not insert foreign objects into the ventilation openings at the back.
Caution! High voltage!
r
Inserting the batteries into the remote control handset
Insert the batteries supplied. Make sure they are inserted correctly
(markings in the battery compartment).
Ń
!
When the batteries are dead, the message ”Batter.” appears on the
picture screen. Remove the dead batteries immediately.
Dead batteries must be disposed of respecting the laws on environmental
protection.
r
Connecting the unit and switching on/off
Insert the plug of the aerial lead into the aerial socket É of the TV set.
Connect the plug for the mains cable or battery cable to the appropriate
socket at the back of the TV set.
Left-hand socket = battery cable (slide to right).
Right-hand socket = mains cable (slide to left)
Connect plug of the mains or battery cable to the mains socket or to the
battery (e.g. car cigarette lighter).
Ń
!
When extending the battery cable, insure sufficient cable diameter and
flawless, low-ohm contact to the battery.
Press the
¢
IO
button on the unit.
Ń
!
Only with mains operation: If the LED is now illuminated, then the unit is in
stand-by mode. Switch the unit on using the remote control by pressing
one of the 0/AV…9, buttons.
4
3
2
1
1
Loading...