Groove GV-PS733 Instruction Manual

GV-PS733

CD/Radio
Portable Player

INSTRUCTION MANUAL

o

WARNING

TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

WARNING: SHOCK HAZARD-DO NOT OPEN

LIGHTNING FLASH WITH ARROWHEAD SYMBOL -

within an equilateral triangle, is intended to alert the

user to the presence of uninsulated dangerous

voltage within the products enclosure that may be of

sufficient magnitude to constitute a risk of electric

shock to persons.

EXCLAMATION POINT - within an equilateral triangle,

is used to indicate that a specific component shall be

replaced only by the component specified in that

documentation for safety reason.

Th

e foll

owing label has been affixed to the unit, listing the proper procedure for working with the laser beam:

CLASS 1 LASER PRODUCT LABEL -

This label is attached to the appliance as illustrated to inform you that

the apparatus contains a laser component.

WARNING LABEL INFORMING OF RADIATION -

This label is placed inside the unit. As shown in the illustration. To

warn against further measures on the unit. The equipment contains

a laser radiating laser rays according to the limit of laser product of

class 1.

This equipment is a Class II or double insulated electrical appliance,

it does not require a safety connection to electrical earth.

CLASS 1 LASER PRODUCT
KLASS 1 LASER APPARAT
LUOKEN 1 LAISERLAITE
KLASSE 1 LASER PRODUKT

E-1

SAFETY INSTRUCTIONS

1. READ INSTRUCTIONS - All the safety and operating instructions should be read before the appliance is operated.

2. WATER AND MOISTURE - The appliance should not be used near water.

3. VENTILATION - The appliance should be situated in a position that does not allow interference with its required

ventilation as this may impede the air flow through the ventilation openings.

4. HEAT - The appliance should be situated away from heat sources such as radiators, stoves, or other appliances
(including amplifiers) that produce heat.

5. POWER SOURCE - The appliance should only be connected to a power supply of the type described in the manual
or as marked on the appliance.

6. POWER CORD PROTECTION – Power supply cords should be routed so that they are not likely to be walked on or
pinched by items placed upon or against them.

7. POWER LINES – An outdoor antenna should be located away from power lines.

8. ESD WARNING - If the display does not function properly or there is no response from the controls this may be due

to electrostatic discharge, please try switching off and unplugging the appliance and then reconnecting it to your
power source after 30 seconds.

9. DAMAGE REQUIRING SERVICE – The appliance should be serviced by qualified service personnel when:

a. The power supply cord or plug has been damaged.
b. Objects have fallen into, or liquid has been spilled into the appliance enclosure.
c. The appliance has been exposed to rain.
d. The appliance has been dropped, or the enclosure damaged.
e. The appliance does not appear to operate normally.

10. SERVICING

If an error display or malfunction occurs switch the appliance off and disconnect the power cord or remove the
batteries and then reconnect to your power source and switch the appliance back on.

BEFORE OPERATION

Please take care as dirty, damaged or warped CD’s may damage the appliance, care should be taken and only use
CD’s with the marks shown below

E-2